Loading
Loading…
Loading…
Tender ID
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
Tender Value
₹91.8 L
EMD Value
₹1.8 L
Closing Date
8 Jan 2026, 11:00 pmClosed
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
Krishna Bhagya Jala Nigam Limited
Sri. GURUNATH
AME of Head work of Malllabad Lift irrigation Scheme under Lift-3 for the year 2025-26 & 2026-27 (Maintanance Charges)
KBJNL/2025-26/IW/WORK_INDENT2689
KBJNL/2025-26/IW/WORK_INDENT2689
Open
Irrigation and Other Works
Two Tender Document System(Two Cover)
KBJNL Division JBC Division No 2 Bheemarayanagudi
10 documents required · 10 mandatory
Tenderer or his identified Sub Contractor should possess valid Electrical License for executing building electrificatio works and should have executed similar electrical works totallng Rs. xxxxxx (not less than 50% of electrical works) n any one year
Tenderer or his identified Sub Contractor should possess valid license for executing water supply / sanitary engineering works and should have executed similar works totallng Rs. xxxxxx (not less than 50% of electrical works) n any one year
Owning the following key and critical equipment for this work (xxxx, xxxx, xxxx)
Total value of civl engineering works executed and payments received in the last five years (year-wise)
List of works for which tenders already submitted
Banker Details for reference
Construction equipment owned by the tenderer and equipment proposed to be deployed on this contract, if awarded
Reports on the financial standing of the tenderer, such as profit and loss statements and auditor’s reports for the last five years
Qualification and experience of the key technical and management personnel in permanent employment with the tenderer and those that are proposed to be deployed on this contract, if awarded
List of Financial Resources with Certificates
Bidder should have satisfactorily completed at least one similar nature of work such as Operation and maintenance of Lift Head work or Pump house (Consisting of VT pump sets with allied equipments at not less than 42.29 m head at 980 rpm coupled with 280 KW 415 volts motors 4 nos. 11 or 33 KV / 440 KV substations with at least 5 MVA transformers along with allied equipments.) of value not less than Rs. 45.89 Lakhs (50% of the amount put to tender during the last 5 years i.e. 2020-21 to 2024-25)( The certificate should be issued by an officer not below the rank of Executive Engineer of the concerned Division / Equivalent officer and countersigned by the Superintending Engineer of the concerned Circle / next higher officer) (The work done of previous years shall be updated to 2024-25 at 10% per annum).
executed in any one year, (for a continuous period of 12 months) the minimum quantities of work: (usually 80% of the annual requirement), Item Of work-Providing man power for Maintenance of Major LIS headwork with 11 or 33 KV / 440 KV & above substation, Quantities-7 no.s of labour per day for 1 year.
Liquid assets and /or availability of credit facilities of not less than Rs.27.53 lakhs. (Credit lines/ letter of credit/ Certificates from Banks) for meeting the fund requirement etc.
Tenderers who meet the above specified minimum qualifying criteria, will only be qualified, if their available tender capacity is more than the total tender value. The available tender capacity will be calculated as under: Assessed available tender capacity (Ax N x 2.5- B)
To qualify for award of this contract, each tenderer in his name should have in the last five years Period (2020-21, 2021-22, 2022-23 ,2023-24 & 2024-25)Achieved in at least two financial years an average annual financial turnover (in all classes of civil engineering construction works only) of Rs. 91.79 Lakhs (usually not less than the estimated cost under this contract) (upload scan copy of audit report and originals should be produced while opening the tender.)
₹2,300
₹1.8 L
1 Jan 2026
1 Jan 2026
10 Jan 2026
5 Jan 2026
AME of Head work of Malllabad Lift irrigation Scheme under Lift-3 for the year 2025-26 & 2026-27 (Maintanance Charges)
Engineer- Grade-II DIPLOMA Mechanical for over all supervision Operation and Maintanance of Pump Houses and 33/11 KV Sub-Stations as per directions of Engineer-in-Charge.
Engineer- Grade-II DIPLOMA Electrical for for over all supervision Operation and Maintanance of Pump Houses and 33/11 KV Sub-Stations as per directions of Engineer-in-Charge.
Pump Operators- ITI/ITC/JOC/WIREMAN for over all supervision, Operation and Maintanance of Pump Houses and 33/11 KV Sub-Stationas as per directions of Engineer-in-Charge.
HEAVY Mazdoors for cleaning of Pump Houses and 33/11 KV Sub-Station at Mallabad Lift Irrigation Scheme under Lift-3 as per directions of Engineer-in-Charge.
Watchmen for security of Mallabad Lift Irrigation Scheme under Lift-3 for security and surveilance of Pump Houses and 33/11 KV Sub-Stations as per directions of Engineer-in-Charge.
Erection, testing, commissioning and trial running of Vertical turbine pump and motor with all accessories necessary for satisfactoryrunning of pump including cost of all materials, machinery, labour...
Rewinding of Jyoti make HT Induction Motor-311HP, 280KW,990 RPM, including replacement of DE and NDE bearing, rotor bar brazing at start points, transportation, re-erection,testing and commissioning, ...
Service Motors upto 1250KW, 6.6KV as per direction of Engineer in Charge.
Gear oil HP-90. ( For Vertical turbine pumps )as per direction of Engineer in Charge.
Grease GEM-RR3(For motor Bearings)as per direction of Engineer in Charge.
Lubricant oil for Motors(for shafts)as per direction of Engineer in Charge.
Supply and installation of Axillary DC supply system of approved make with battery charger cum DCDB with batteries for 110 A hour complete with all accessories.as per direction of Engineer in Charge.
Supplying and fixing Moulded Case Circuit Breaker (MCCB) over the existing wood/panel board using necessary screws, bolts, nuts, necessary phase separators, handle and wiring complete. Protection of O...
Supply, installation and commissioning of soft starter for specified kW load operating at 6.6 KV with load break switch, metering, protection by-pass vaccum contactor with all accessories complete hou...
EHV Grade Transformer Oil - New .as per direction of Engineer in Charge.
Filling of oil to the main tank and OLTC tank, filtering the oil including filtering till attainment of prescribed BDV valves including labour, filtering equipment along with accessories.as per direct...
Work of repairing and overhauling of upto 400 amps LT breaker bus coupler as specified below: Complete dismantling of breaker units of 400 amps, breaker of compressor room taking out the fixed and mov...
Lightning Arrester 30 kV 10kA Lightning Arrester Normal Duty polymeric Discharge Class -2as per direction of Engineer in Charge.
Providing and fixing kinetic AIR VALVE of PN 16.0 for automatic discharge of accumulate air during working condition, conforming to IS 14845 / EN 1074-4. Body and bonnet of DI conforming to IS-1865 of...
Providing and fixing kinetic AIR VALVE of PN 16.0 for automatic discharge of accumulate air during working condition, conforming to IS 14845 / EN 1074-4. Body and bonnet of DI conforming to IS-1865 of...
Work of supply and fixing of isolator panel and capacitor panel fuses to motor. as specified below: A) Removing the damaged burnt out fuses upto 63Amps 7.2 /11 K.V isolator fuses form isolator panel f...
Work of replacement of faulty control components and modification and rewiring of soft starter panel upto 1250KW/6.6KV motor as specified below: a. Disconnecting the power cables and control cables. b...
Testing :1. Ratio Test 2. SC Test 3. Excitation Current Test/ Highpot Test 4. Magnetic Balance Test 5. Vector Group Test 6. Induced High Voltage Test 7. OLTC Operation - Local and Remote 8. Protectiv...
Testing of C&R panels:Testing for insulation level, testing of relays, control operations for closing tripping etc., interlock. Alarm annunciation & indicationchecks (without SAS)as per direction of E...
Supplying of recess mounting non integral type ........ LEDw luminaire comprising of pressure decast/ extruded aluminium housing, with spring loaded falseceiling clamps ,Power LEDs with CCT6500 degree...
Supplying of .....feet -PVC Batten with integrated LED tube .... W with high quality diffuser with Life of 25000 burning hours & 70% lumen maintenance with CRI greater than 80. Power Input: 220-240V...
Fixing all types and all capacities of fluorescent /false ceiling / spot light / CFL / LED fittings indoor on the wall/ ceiling / rafters / girders using 23/0.0076" twin twisted PVC insulated wires, r...
PG Clamp. as per direction of Engineer in Charge.
Supplying and installation of RUBBER MAT 1mtr x 1mtr -1Omm thick. complete including cost of materials, labour, usage charges of machinery complete as per specifications. as per direction of Engineer...
Rubber Hand gloves 15 kV, SEAMLESS Confirming to ISS (Sample to be verified for seamless before approval) for electrical purpose as per direction of Engineer in Charge.
Cotton Waste as per direction of Engineer in Charge.
Work of repair, overhauling & servicing of HT southern switch gear breakers of capacitor bank as specified below: Lowering the breaker from the panel after isolating the supply, draw out the breaker ...
curved surface fixed with polymer coated J or L hooks, bolts and nuts 8 mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead, including a coat of approve...
Providing and fixing Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting,fixing in position and applying a priming coat of approve...
Supply and installation of 6.5Kg C02 Gas val ve type Fire Extinugisher,TrolleyMounted, EasyWeight Management usedUnused Mechanism, GrossWeight 30.5Kg. emptyWeight 24.0Kg. CanHeight 1015MMDiameter 140M...
Engaging Hydraulic Excavator 0.9 cum Bucket capacity for removal of hurdals and juliflora bhushes. (for 2 years) as per direction of Engineer in Charge.
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
MLIS Head work DTP KW-3.docx
Tender Document • 1.21 MB
AME of MLI head work 25-26 Notification.doc
Instructions to Tenderers • 0.11 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .