Work of installing high mast lights and flag mast in Raja Mahendra Pratap University

S/F Of 20 mtr High Mast Shaft Of pproved Make(utkarsh/Mayfair/mactac) With rising system hot dip glavanized inside &out side dip, having pole sheet thickness 4mm.Top dia minimum 150mm,Bottom dia 410mm base plate 32mm thick suitable for wind velicity as per as par is 875 part 3 & having no circumferential weld, with accessories for high mast such as head frame suitable for 6 to 12 luminaries & its control gear boxes 1.5hp power tool motor ,3 point suspesion system with steel wire rope 8mm dia ,double drum winch ,including making sutable foundation as per manufacture drawing /site reument along with foundation bolts ,nuts ,washers,anchor plates ets complete in all respect [ Item No 653] SOR 2018

S/F Of national Flag size 12*8 perachute polyester (M.R.)

S/F Of fidder panel for flag mast (M.R.)

Supply and fixing of factory wired integral LED(phillips, bajaj, crompton, havills) flood light luminaires with die cast aluminium housing built with dirver set suitable for 170 to 200 Watt. Confirming to IP 66 protection complete in all respect. CAT- AAA[ Item No 1455] SOR 2018

Supply and laying of aluminium conductor PVC insulated armoured served sheathed cables 1100 Volts grade at a depth of 750 mm below ground level over a cushion of 75 mm. thick sand all around and protected with burnt bricks on sides and on top. On surface the cable run shall be fixed on M.S. clamps etc. of suitable size or as directed by the Engineer-Incharge, complete in all respect. The armouring of the cable shall be properly connected with the earth conductor by clamps etc. (SOR - 2018 Item no.501 (i) 16 sqmm 4 core

Supply and fixing following capacity of automatic street light cubicle control panel painted with anti corrosive alkali and acid proof paint consisting of time switch TSO 100 series with contactors, HRC fuses, isolating switch metering instrument & instrument box with CTs etc. in case of (15 A ) TPN, complete in all respect. (SOR - 2018 Item no.807. D (ii)

Supply and burring of Safe Earthing Electrode T-19, (Hot Dip Galvanized), Length up to 3000mm, outer Dia 50 mm inner Dia 25 mm, terminal Dia 12mm, outer GI pipe of 16 swg and inner GI pipe of 12 swg with Hot Dip Galvanization up to 100 micron filled with crystalline conductive mixture (CCM) having anti corrosive & conductive property with 50 kgs activated soil (BFC) capable of reducing the soil resistivity with good mixture of retaining capacity and one earthing lead of 25mm x 3mm G.I. strip, upto switch board (from apron to switch board, the cost of G.I. strip will be extra) along with 30 cm square C.I. frame with hinged cover & masonry housing. Make: As approved in U.P. P.W.D., & C.P.R.I. Certified. (SOR - 2018 Item no.725. (b)

S/F of following size DWC HDPE pipe ISI marked along with all accessories like socket bend, coppers etc. confirming to is 1493 part-11 complete with fitting and cutting, jointing etc. direct in ground (75 cm below ground level), including excavation refilling the trenches but excluding sand cushioning and protective covering at complete as required 63 mm dia (OD)-63mm & 51 mm (ID)

Please Enable Macros to View BoQ information