Repairs to path hardstanding chain link fencing barbed wire fencing boundary walls compound walls area drainage culverts kerbstones and plinth protection under AGE B/R I area at GE (N) Ahmednagar

Amount

Demolition of brick work stone/boulder masonry built in cement mortar including all quoins, arches, pillars etc, but excluding ashlar facings, dressed stonework and precast concrete articles etc complete all as specified and directed by Engineer-in-Charge

M&L for Pre-cast cement concrete block masonry of (1:3:6) type C-1 (20 mm graded stone aggregate) with solid blocks, exc. 10 cm in width complete set in and including cement and sand mortar (1:6) etc complete all as specified and directed by Engineer-in-Charge.

M&L for Pre-cast cement concrete block masonry (except concrete blocks) of (1:3:6) type C-1 (20 mm graded stone aggregate) with solid blocks, exc. 10 cm in width complete set in and including cement and sand mortar (1:6) etc complete all as specified and directed by Engineer-in-Charge.

Taking down cement mortar plastering on brick or stone walls, etc. including raking out joints,hacking for key,scrubbing down with water, etc complete all as specified and directed by Engineer-in-Charge

Rendering 15mm thick on brick masonry wall in cement and sand mortar (1:4) finishing the surfaces even and smooth( without using extra cement) etc complete all as specified and directed by Engineer-in-Charge

M&L for two coats of cement base paint over chalk whitening on newly plastered surfaces of walls including preparation of surfaces etc complete all as specified and directed by Engineer-in-Charge

M&L for applying two coats of white wash over plastered new surface including prepration of surface etc complete all as specified and directed by Engineer-in-Charge

Dismantling of posts or struts(wood, steel or RCC) any section embadded in concrete, including taking out embedded portion and making good disturbed ground etc complete all as specified and directed by Engineer-in-Charge

Dismantling of fencing wire mesh, any type etc complete all as specified and directed by Engineer-in-Charge

Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning,filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm in hard dense soil etc complete all as specified and directed by Engineer-in-Charge

M & L for cement concrete type D2 (1:4:8) using 40 mm graded stone aggregate in foundations, filling as mass concrete etc complete all as specified and directed by Engineer-in-Charge

S & F in repais galvanized 2 strand steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing & straining & fixing to any type of standards rails straining bolts including securing or tying at crossing with & provn of galvanized mild steel wire etc complete all as specified and directed by Engineer-in-Charge (Each line wire to be measured)

M & L for RCC (1:2:4), type B-1, (using 20mm graded stone aggregates) as in precast fencing posts, stuts etc area exc 100 & not exc 250Sqcm including form work etc complete all as specified and directed by Engineer-in-Charge:- (Reinforcement shall be measured and paid seperately under relevant item of this BOQ)

S & F 10mm dia TMT bars and over cut to lengthbent to shape required including craking bending, spirally for hooping for columns, hooking ends and binding with mild steel wire (annealed) not less than 0.90mm dia of wire or secruing with clips etc complete all as specified and directed by Engineer-in-Charge

All as item No 14 (here-in-before) but 6mm dia and over up to 8mm dia in stirups, spaces etc complete all as specified and directed by Engineer-in-Charge

Supply only chain link MS galvanized fencing of any size or type etc complete all as specified and directed by Engineer-in-Charge

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc.including provission of binding wire etc complete all as specified and directed by Engineer-in-Charge

S & F mild steel bolt screwed one end with hexagonal or square nuts & washers the other end enlarged not exc 15cm long dia of neck 12mm etc complete all as specified and directed by Engineer-in-Charge

M&L Hand rails, half round or other steel section or core for wooden hand-rail straight portion,drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts posts and struts in fencing including cutting tops to shape as directed, drilling holes,notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc.,and similar work conforming to Fe-290 Gde E-165 etc complete all as specified and directed by Engineer-in-Charge

S & F mild steel flat iron, round or square bars, in available lengths, Fe-290, Gde-E-165 etc complete all as specified and directed by Engineer-in-Charge

M&L for preparation of new steel surfaces of any description over 10 cm width or girth and applying two coats of synthetic enameled paint over a coat of red oxide etc complete all as specified and directed by Engineer-in-Charge

M&L for providing, cement concrete type B1 1:2:4 (20mm graded stone aggregate), in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands,plinth courses, string courses,lacing courses,parapets and railings upto 60 cm in height,copings, kneelers, apex stones,bed plates, kerbs not provided for water troughs and the like including weathering, slightly rounded or chamfered angles and throating, etc complete all as specified and directed by Engineer-in-Charge

M&L for cement concrete type B0 (1:2:4) using 20 mm graded stone aggregate as in surface channels and drains etc complete all as specified and directed by Engineer-in-Charge

Demolition of cement concrete (unreinforced) in any description and in any position etc complete all as specified and directed by Engineer-in-Charge

Demolition of cement concrete (unreinforced) in ground floors & paving not exc 15cm thickness (below or above ground level) etc complete all as specified and directed by Engineer-in-Charge

Demolition of reinforced cement concrete of any description and in any position not otherwise specifically provided for .Note- Rate includes for reinforcement cutting as required to facilitate demolition etc complete all as specified and directed by Engineer-in-Charge

M&L for providing RCC (1:2:4) using 20mm graded stone aggregate as in coping, slab supported on wall, beam, lintels including form work etc complete all as specified and directed by Engineer-in-Charge

Formwork to edges of concrete flats, breaks in floors, openings in concrete walls, floors and roofs and sides of RCC/PCC bands in walls, horizontal or sloping, and similar work all exceeding 20cm wide etc complete all as specified and directed by Engineer-in-Charge

M& L Providing precast cement concrete louvres and jallies Type BO 1:2:4 (12.5mm graded aggregate) Set in cement and sand mortar (1:4) , 30 mm thick (measured solid ), including all mouldings but excluding frame etc complete all as specified and directed by Engineer-in-Charge

M & L for 75 mm thick Cement concrete (1:3:6) type C-2, (40 mm graded stone aggregate) as a Plinth protection etc complete all as specified and directed by Engineer-in-Charge

S&F for framed work as in doors or gates of angle or other section with gusset Plate, rails,braces etc complete drilled for fixing of steel sheeting or other covering doors etc to be prepared for hanging or sliding with and including either hooks and hinges and door fittings necessary rivetting/welding cutting up complete steel conf. to Fe-410-0 or Fe-310-0 all as specified and directed. Note : Distrubed surfaces of wall shall be made good to true surface etc complete all as specified and directed by Engineer-in-Charge

Dismantling structural steel work including doors, gates but excluding framed trusses etc complete all as specified and directed by Engineer-in-Charge

Dismantling of stone slab and tiles laid bedded and pointed in any mortar description or thickness in floors, apron etc complete all as specified and directed by Engineer-in-Charge

M&L for Granite (of any type) 20mm thick machine cut, bedded and jointed with grey cement slurry and pointed with white cement with admixture of pigment to match the shade of granite stone including cutting and polishing laid types over and including 10mm thick screed bed in cement and sand mortar (1:4) and jointed in neat cement slurry and pointed in white or coloured cement to match the shade of granite etc complete all as specified and directed by Engineer-in-Charge

M & L for chequered cement concrete tiles 30cm x 30cm x 20mm thick Rouber moulded with grey cement and pigment, including 15mm thick screed in cement and sand mortar (1:6), set jointed & pointed in neat cement slurry in floors etc complete all as specified and directed by Engineer-in-Charge

M&L for precast cement concrete interlocking tiles 60 mm thick ruber moulded with strength 35 N/sqmm as in floor/pavement laid over and including 30 mm thick stone dust cushioning laid dry to the profile etc complete all as specified and directed by Engineer-in-Charge

M & L for precast cement concrete (1:2:4) type B-1 using (20mm aggreates) set in cement and sand mortar (1:4) as in cover slabs (for manhole etc) & simillar articles with plain faces complete (Reinforcement will be measured and paid separatly) etc complete all as specified and directed by Engineer-in-Charge

S&F 10mm dia MS Round bars as in support of Chain Link Fencing etc complete all as specified and directed by Engineer-in-Charge

Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, mounds, mitred/stopped end etc complete all as specified and directed by Engineer-in-Charge

Extra for forming fair finished drain or channel 45 cm inner girth in cement concrete, using extra cement, including forms, mounds, mitred/stopped end etc complete all as specified and directed by Engineer-in-Charge

M & L for Cement concrete type B2 (1:2:4) (40 mm graded stone aggregate) in foundations, filling and mass-concrete etc complete all as specified and directed by Engineer-in-Charge

M & L for one coat of synthetic enamel paint of old stone or concrete surface any description, not otherwise described, over 10 cm width or girth etc complete all as specified and directed by Engineer-in-Charge

Dismantling PVC Pipes with fittings upto 75mm to 110mm dia etc complete all as specified and directed by Engineer-in-Charge

S&F for PVC (SWR) pipe 110 mm dia single socketed in any length with rubber ring jointed level fixed to walls etc complete all as specified and directed by Engineer-in-Charge

S&F for PVC (SWR) pipe 75 mm dia single socketed in any length with rubber ring jointed level fixed to walls etc complete all as specified and directed by Engineer-in-Charge

An amount of Rs 1,02,770.00 shall be deducted from BOQ on account of schedule of credit

Neha Enterprises

M/s AG PATHAN

M/s. A P INFRA

M/S-B.R.SONAWANE

Takshashila electricals

M/s. Sagar Traders

M/s IBEX Engineers and Contractors