Replacement of old damaged doors ventilators windows with new doors ventilators windows in Blocks 1 2 3 and 4 of Girls Hostel in University Health Sciences Rohtak

Amount

Removing door and windows (wood and steel) with chowkats by making recesses in walls when the wall is not to be dismantlled :- (HSR 8.18)

(a) doors

(b) Windows

Dismantling white or coloured glazed tiles (to be carefully removed) (HSR 8.38)

First class brick work laid in cement sand mortar 1:4 in first storey upto 4 metres above plinth level(HSR.11.9)

Laying and fixing vitrified/ceramic/glazed tiles of any size of approved make in skirting/dado, pillars, wall facing, laid in any pattern as specified over base of 12 mm thick cement coarse sand mortar 1:3 and jointed with white cement slurry mixed with pigment to match the shade of tiles. (Tiles shall be supplied by the Department). (HSR 14.94) Labour Rate

12 mm thick cement plaster 1:4 on walls (HSR 15.5)

15m thick cement plaster 1:4 on the rough side of single or half brick wall ( HSR 15.10).

Applying pink primer or aluminium priming coat on wood work including preparation of surface, knotting and stopping etc. (HSR 16.2) Labour Rate

Painting two coats excluding priming coat with synthetic enamel paint in all shades on new wood work or metallic or plastered or concrete surfaces to give an even shade. (HSR 16.3) Labour Rate

Applying priming coat with metal primer on new steel or iron work including preparation of surface. (HSR 16.9) Labour Rate

Providing two coats of exterior acrylic emulsion paint. ( HSR 16.79) Labour Rate

(b) 1st quality

Providing and applying two coats white cement based putty over plastered surface and grinding the surface smooth with sand paper to get an even and smooth finish including cost and carriage of all material labour charges scaffolding sundries etc. complete (J.K/Birla make)(HSR 16.81)

Providing and fixing 0.50mm thick Aluminium sheet i/c cost of necessary screw, etc complete. (HSR 17.87)

Factory manufactured panneled door or glaged and window shutters of commercial hard wood such as hillock, champ, chikrassy and chaplash etc. (non coniferous timber other teak, conforming to IS specification No. 1003, kiln seasoned) with 100mm wide vertical styles 150mm wide lock rail 200mm wide bottom rail and 100mm wide other rails, with panels of 15 mm thick , tongued and grooved of commercial hard wood and including cost of iron hings, screws, chocks/cleats, stops, nails etc., complete fixed in position (excluding the cost of any fittings, other than specified above, but including labour for fixing the same in position) (HSR 17.90)- Note 1 under chapter 17.18)

(b) 35mm thick

Factory-manufactured wire gauze door and window shutters of commercial hard wood such as hollock, champ, chikrassy and chaplash, etc. (non coniferous timber other teak, conforming to I.S. specification No.1003 kiln seasoned) with 100 mm wide vertical styles, 150 mm wide lock rail 200 mm wide bottom rail, and wire gauze of 140 G or 120 G designation including cost of iron hinges, screws, chock/cleats, stops nails etc. , complete fixed in position (excluding the cost of any fittings, other than specified above, but including labour for fixing the same in position) (styles and rails of windows shutter shall be 75mm wide) (HSR 17.92)- Note 1 under chapter 17.18) (ii) 35 mm thick

Factory manufactured solid flush door shutters, with block board core as per I.S. No. 1659-1669 bonded with water proof type phenol formaldehyde synthetic resin, hot-pressed, conforming to I.S. 2202 part I. and II, fixed in position, including iron hinges, screws, chocks/cleats and stops etc.(excluding the cost of any fittings other than specified above, but including labour for fixing the same in position) (HSR 17.93)- Note 1 under chapter 17.18) (a) Commercial veneering with vertical grains or cross bands and face veneer on both sides commercial facing with laminated core and lipped edges:-(Jwala/Ujala make). (iii) 35 mm thick

Pressed steel sheet frames (chowkats) consisting of 2mm thick steel sheet of the specified section, including iron lugs (hold fasts) iron hinges, conforming to P.W.D. specifications, including bolts for fixing stops, locknotch, provision for receiving tower bolts, and finished with one coat of ready mixed paint red lead Non-setting primer,of approved quality, fixed in position including the cost of cement concrete 1:3:6 for filling in the frame, and cement concrete 1:3:6 for lugs complete :- (HSR 18.34 )

(b) Door and window frame of size 76x38 mm with 35mm wide single rebate.

(d) Door and window frame of size 114 mm x 50 mm with 35 mm wide double rebate

N.S Recovery items Civil work

Bidders have to quote rates for recovery items at least or more than reserve price. The rates quoted against recovery items will not be included in the total amount, rather it will be deducted while calculating financial statement of the agency.

Collection of old door received after dismantling of the existing work.(N.S) The reserve price of the dismantled material is as under:- @ Rs. 500/- each.

Collection of old window received after dismantling of the existing work.(N.S) The reserve price of the dismantled material is as under:- @ Rs. 250/- each.

The Laxmi Co-op L&C Society Ltd.