Alingement with Repairing and Replacement of Musical Rubber Seal of Regulators i/c Fabrication work, P/fixing of shed and Complete Greasing, Oiling, Painting of Regulators etc. at Escape Drain No.1 Near RD 400M.

Cleaning, Greasing & Oiling of wheel bearing, retainer plate i/c checking and tightening of Pin, Nut & Bolts etc. complete in respect and as per directions of engineer-in-charge.

Cleaning, Greasing, Oiling & checking of Pulley, Hoist Gearing, Manual lever & Rope drum system etc. i/c checking of electromagnetic brake system complete & testing at site.

Supplying & Fixing of J-Type Musical Rubber Seal dia.44 x100 mm of 12 mm thick with M.S.Clamp Plate 50mm x10mm with galvanized Nut/Bolt/Washer and Flat Rubber seal (75 x 14 mm) in bottom with clamp plates & Galvanized Nut/Bolt/washer etc .complete in all respect as required at site. (Regulator Size- 8020mm X 4300mm).

Fabrication, Erection and Commissioning of chequered sheet of Hoist, stairs and ISA 75x75x10mm in column including cutting, grinding, welding complete as per specification and to the entire satisfaction of engineer-in-charge.

Dismantling roofing including ridges, hips, valleys and gutters etc., and stacking the material within 50 metres lead of: G.S. Sheet

Providing corrugated G.S. sheet roofing including vertical / curved surface fixed with polymer coated J or L hooks, bolts and nuts 8 mm diameter with bitumen and G.I. limpet washers or with G.I. limpet washers filled with white lead, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (up to any pitch in horizontal/vertical or curved surfaces), excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. 0.80 mm thick with zinc coating not less than 275 gm/m².

Scrapping, Cleaning and Painting of Complete Gates with ISI approved paint, after removing of dust, rust & moisture etc. complete in all respect as required at site and as per direction of Engineer-in-Charge.

Taking out rusted Jaal and Fabrication, Erection & Welding of New M.S Jaal by Providing M.S angle (40x40x5mm), M.S square bar 12mm etc. to cover the open portion inside pump house near submersible pipe laying etc. complete as req. at site.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources).