Improvement road surface at various LCs with rubberized road surface under jurisdiction of Sr.DEN/W/BKN.

Financial Eligibility Criteria: The tenderer must have minimum average annual contractual turnover of V/N or V whichever is less; where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet. Note :- (i) For Joint Venture (JV): The tenderer shall submit credentials as mentioned in Clause 17 of GCC April 2022 (Ammended upto date). (ii) In case, date of tender inviting is on or after date of statutory deadline for audit of balance sheet of previous Financial Year (i.e. 30th Sept. or as further extended for this FY), audited balance sheet of 4th previous year shall not be considered unless concerned CA certifies that balance sheet is not audited yet as on date of invitation of this tender.

The tenderer must have successfully completed or substantially completed any of the following during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (a) Three similar works costing not less than the amount equal to 30% of advertised value of the tender, or (b) Two similar works costing not less than the amount equal to 40% of advertised value of the tender, or (c) One similar work costing not less than the amount equal to 60% of advertised value of the tender. Note :- For Joint Venture (JV): The tenderer shall submit credentials as mentioned in Clause 17 of GCC April 2022 (Ammended upto date).

Defination of Similar Work :- Any Civil Engineering work

Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.

Note:-1)All materials to be supplied by the contractor should be get approved by the Engineer-in-charge before use. 2)All works are to be done as per programme fixed by the Engineer-in- charge or his authorised representative and as per their direction only. 3)The Railway will not be responsible for compensation towards contractor's idle labour in case traffic block cannot be arranged to the contractor as per programme due to unforeseen reasons. 4)All safety measure will be taken by the contractors for movement of traffic during the operation. 5)If required some of the essential works are to be executed in night time and stipulated period with proper safety precautions for which no extra payment will be made. 6)Before offering the rates in the tender, the tenderers are required to inspect the site thoroughly and satisfy themselves as to the nature of work involved and all possible difficulties for executing the work. 7)The cost of the work & quantities shown above are rough and are for guidance only. The quantities given above are subject to change according to needs of the Railway and variation thereof to any extent will not be the basis of any claims against Railway. 8)The work shall be carried out as per NS Item's Specification (Amended up to date) & Special conditions. 9)The rates should be inclusive of all labour and materials, taxes, lead, lift, loading, unloading, sales tax etc. Nothing extra payment other than the accepted rates will be made in any circumstances. 10) The contract shall be governed by General Condition of Contract and Instructions to the Tenderers 2022 (Amended up to date). 11)SD shall be released after successful completion of warranty period of 60 Months.12) All Tools and plants and mechanical equipments as required to execute the work shall be arranged by the contractor. 13) Contractor/ suppliers/ service providers/ parties shall register their firms under GSTIN (GST Identification Number).