REPAIR/ REPLACEMENT FENCING, BOUNDARY WALL, GATE PILLAR AND DRAINAGE AND FOOTPATH / HARD STANDING AT DRONACHAL BASE BHOPAL

Amount

Demolition of cement concrete (un-reinforced) in ground floors and pavings n. exc. 15 cm thickness (below or above ground level)

M&L for 100 mm thick PCC 1:3:6 type C2 (using 40 mm graded stone aggregate) as sub base floor complete all as specified.

M & L for sand filling under floors or in foundation including watering and consolidation as in bedding layers for laying tiles.

M&L for factory made Machine pressed precast concrete interlocking paver blocks any shape and size confriming to IS 15658-2006 of 60mm thickness coloured chemically treated PCC (ISI Marked ) M-35 grade of desgin & pattern approved by GE as in footpath and filling of joints with Narmada fine sand complete all speciified and directed.

M & L for Machanic pressed precast concrete interlocking paver block any shape and size confriming to IS 15658-2006, M-40 Grade 80mm thickness, jointed and pointed with grey cement and pigment in floor/ footpath.

Dismantling of Stone slabs and tiles of any description or thickness in floor, aprons etc laid dry or laid and pointed in floor/ footpath complete all speciified and directed.

Fixing Only for Machine pressed precast concrete interlocking paver blocks any shape and size of 60mm thickness coloured of desgin & pattern refixing in floor/footpath and filling of joints with Narmada fine sand complete all speciified and directed Note: retrived material obtained from item No.6 shall be reused in this item

Dismantling of existing RCC/ Steel /Wooden posts or struts (wood, steel or R.C.C.) any section, embedded in concrete ,brick work ,massonery etc . including taking out embedded portion and making good disturbed ground complete all speciified and directed

Dismantling wrought iron or mild steel work of any description not otherwise provided for all as per specified.

Dismantling fencing wire mesh, any type.

M & L for excavating in post holes (or similar holes) each exc 0.5 cum, getting out in hard/dense soil, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering, and removing surplus soil to a distance exc 50m and maging good surfaces.

M&L PCC 1:3:6 (type C2) (using 40 mm graded stone aggregate) as in foundation filling and mass concrete

S&F mild steel post and strut in fencing including cutting tops to shape as directed drilling holes notching for wire flat iron fillet ( for securing wire mesh) in including all necessary drilling bolting and rivetting screwing etc conforming to Fe-290 Grade E-165.

Supply only Mild steel screw bolt ( machine made) with hexagonal or square head at one end and screwed the other, each srewed end to be fitted with washer n.exc 5 cm long and dia of neck 5 to 10mm.

M&L for MS round bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips complete all speciified and directed

Supply only Chain link MS galvanisd fencing, any size or type complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified and directed.

S&F, galvanised 2 strand steel barbed wire 2.24mm dia barbed with 2 mm dia barbs at 75 mm spacing and straining and fixing to any type of standard rails straining bolts including securing or tying at crossing with and provision of galvanised mild steel wire complete all speciified and directed (each line wire to be measured)

M&L for preparation of new steel surface of any description over 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

Taking down cement plaster of any description including raking out joints, hackisng for key, scrubbing down with water etc.

Material and labour for rendering 10 mm thick in cement and sand mortar 1:3 on fair faces of brick work or cement concrete surfaces to recieve tiles complete all as specified and directed.

S&F for Dholpur stone 16 to 18mm thick veneering to walls, fire places, pillars, steps etc, in cladding gang saw cut with machine cut edges, uniform colour of each stone size exc 0.25 Sqm area and not exceeding 0.5 Sqm area fixed and driling hole for hold fastner, polsihing, rubbing & including silicon treatment complete all as specified and directed.

Dismantling structural steel work including doors, gates and framed truss etc.

M&L for rolled mild steel Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering, Doors etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive or steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete confirming to Fe-410-W (Gde-E-250) quality A.

S&F structural steel work as in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to I. S.1161- 1979 grade St.-240 complete all as specified and directed.

Dismantling of asbestos cement and Plain or corrugated steel sheeting any gauge, thickness, including nainitial or similar pattern roof covering complete all as specified and directed.

S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet with approved profile and 0.50 mm thick of any colour having tensile strength of 550 Mpa as in roof covering/ cladding to wall, fixed with self tapping screws all as specified and directed

Demolition of brick work or stone /boulder masonry built in cement mortar including all quoins, arches, pillers etc. but excluding ashlar facings, dressed stone work and precast conc rete articles.

Demolition of PCC of any description and in any position not otherwise specifically provided for complete all as specified and directed

Demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically provided for complete all as specified and directed (reinforement cut as required to facilidate demolation)

M&L for PCC 1:3:6 (type C2) (using 40 mm graded stone aggregate) as in foundation filling and mass concrete

M&L for brick work with Fly ash' bricks , (modular bricks) straight or curved on plan exc 6 m mean radius built in cement mortar 1:6 complete all as specified and directed.

M&L for walling of random rubble uncoursed well bounded, bedded, and solidly hearted, builted in Cement Mortar 1:6 complete all as specified and directed

Description all as per Item No 33 above but except stones complete all as specified and as directed. Note:- Old stone obtained from demolition shall be used under this item.

M&L, for reinforced cement concrete (Nominal mix) in type A1 1:1/2:3 (20 mm Graded aggregate) for Walls, retaining walls, ballast walls, like any thickness; above top of fooitngs; including attached pilaster and buttreses complete all as specified and directed..

M&L for providing precast cement concrete Type B1 1:2:4 (20mm graded aggregate)as in cover slabs (for manholes, drains etc.) of any size and thickness as required Set in cement mortar 1:4 Note :- Reinforcement will be measured and paid saperately

M&L mild steel TMT bars 10 mm dia and over cut to length bent to sharp required including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) but less than 0.9 mm dia Securing with clips .

Supply & fixing 6 to 8mm dia TMT bars, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming to complete all as specified and directed

M&L, for formwork to sides of concrete Foundations, footings, bases of columns, raft and raft beams, plinth beam, vertical or batter etc. for flat rough finished surfaces of concrete surfaces all as specified and directed.

M&L PCC 1:2:4 type B-0 (using 12.5mm graded crushed stone aggregate) as in coping including weathering, slightly rounded or chamfered angles and throating, as directed and necessary form work complete all as specified and directed.

M&L Flush pointing to random rubble, uncoursed or brought upto courses in cement mortar 1:4 complete all as specified and directed.

M&L for rendering 15mm thick cement plaster in CM 1:4 and even on fair faces of brick or concrete surfaces finished even & smooth without using extra cement complete all as specified and directed

M & L for two coats of synthetic enamel paint over a coat of priming with Red oxide zinc on new or previously untreated surface of any description not exc 10cm in width or girth when unconnected with other painting or painted in different tint

M&L for three coats of white wash including preparation of new surfaces complete all as specified and directed

Jyoti enterprises

R K Sales

PADAMSHRI CONSTRUCTION CO

Samaksh Enterprises

M/s VIKAS TRADERS

Vee kay construction

MODI CORPORATION