Renovation of Divisional Office building of Irrigation division Tral

Earth work in bulk excavation by manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 m2 on plan) including disposal of excavated earth lead upto 50 meters and lift upto 1.5 m, as directed by Engineer-in-Charge. All kinds of soil :

Dumping stone excluding cost of stones. in Horizontal on level

Supply of stones(Nallah)

Providing and laying in position cement concrete of specified grade including curing but excluding the cost of centring and shuttering. All work upto plinth level with: 1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 mm nominal size)

Providing and laying in specified grade of reinforced cement concrete including curing but excluding the cost of centring, shuttering,furnishing and reinforcement. All work upto plinth level with: 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size)

Providing and laying in position cement concrete of specified grade including curing but excluding the cost of centring and shuttering. All work upto plinth level with: 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size)

Centering and shuttering including strutting, propping etc. and removal of form work for: Foundations, footings, bases for columns

Providing and fixing aluminum work for doors, windows, ventilators and partitions with extruded built up standard tubular sections/appropriate Z sections and other sections of approved make conforming to IS: 733 and IS: 1285, fixed with dash fastener of required dia. and size including necessary filling up of gaps at junctions i.e, at top, bottom and sides with required EPDM rubber / neoprene gasket felt etc. Aluminum sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminum snap beading for glazing / panelling, C.P. brass / stainless steel screws, all complete as per architectural drawings and the directions of Engineer-in-Charge (glazing, panelling and dash fasteners to be paid for separately. Anodised aluminium ( Anodized transparent or dyed to required shade according to IS:1868,minimum anodic coating of grade AC 15)

Providing and fixing machine moulded aluminum covering of approved pattern & design, made out of machine-cut aluminum sheet and machine holed for receiving dash fastener, over expansion joints on vertical surfaces/ ceilings floors, the fixing on plate in one row on one side of joint only shall be done with stainless steel dash fastner of 8 mm dia. and 75 mm long bolt including providing aluminum washers 2mm thick, 15mm dia. at a staggered pitch of 200 mm centre to centre including drilling holes in the receiving surface and providing expandable plastic sleeves in holes etc. complete. as per drawing and direction of Engineerin-charge Powder coated aluminum sheet 2.5 mm thick (minimum thickness of powder coating 50 micron)

Providing and fixing glazing in aluminum door, window, ventilator shutters and partitions etc. with EPDM rubber / neoprene gasket etc. complete as per the architectural drawings and the directions of engineerin-charge. (Cost of aluminum snap beading shall be paid in basic item.) With float glass panes of 8.0 mm thickness (weight not less than 20.00 kg / sqm)