Construction of Command and Control Center

Amount

CONSTRUCTION OF COMMAND AND CONTROL CENTRE BUILDING AT GENEPOOL GARDEN NADUGANI RANGE NADUGANI

Earth work excavation and depositing on bank with lead of 10 metre and lift 2metre in hard stiff clay, stiff black cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders SS.20B

Earth work excavation and depositing on bank with lead of 10 metre and lift 2metre in hard stiff clay, stiff black cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders SS.20B

Filling in fountation and basement with M Sand in layers of maximum 100mm thick including watering and consolodation with standard specificatin etc., complete as per standard specification

Plain Cement Concrete 1:4:8, mix using M Sand and machine broken IRC, HBG 40mm metal and including the cost of materials, conveyance and labour charges etc., complete complying with the standard specifications.

Supplying, fabricating and placing in position of Steel Reinforcement using mild steel / ribbed tor steel rodes for all RCC works as per the design given including cost of steel and binding wire in all floors complying with standard specification and drawings. Using M.S Rods of Required size.

Reinforced Cement Concrete 1:1 1/2:3, (One Cement one and a half M-Sand and three 20mm metal) mix using 20mmmachine broken IRC, HBG metal including the cost of all material with conveyance and labour charges etc., complete complying with standard specifications.

Supplying and erecting Centering and Shuttering for sides and soiffts including supports and strutting using mild steel sheets stiffened with welded mild steel angles boarding laid over Silver Oak joists centre to centre and supported by Casuarina props centre to centre etc., complete complying with standard specfication.

Brick work masonry in CM 1:5 mix (M Sand), using 2nd class bricks and the rate including cost and conveyance of all materials, curing etc, complete.

Special ceiling Plastering with CM 1:3, 10mm thick using P-Sand and the rate including cost and conveyance of all materials, labour etc, complete with standard specification

Plastering with CM 1:5, 12mm thick using P Sand and the rate including cost and conveyance of all materials, labour etc, complete with standard specification

Supply, fabrication and fixing in position of Mild steel structural works for given design including the cost og materials, welding charges and labour charges FOR MAKING AND FIXING etc., complete.

Floor finishing with joint free double charged vetrified Tiles of best approved quality and colour of size 600 x 600 x 8mm in all floors laid over a base layer of cement mortar 1:3 (One cement and three sand) 20mm thick and pointing neatly with same colour cement at 0.30 Kg/Sqm to suit the colour of the tiles and specifications. including finishing the joints and pointing flush with even surface etc., as directed by the departmental officers.

Dadooing wall with glazed tiles of size 300cmx600cmx6mm, over cement mortar 1:2, 10mm thick including all cost and conveyance etc, complete as per standard specification.

Providing and filling the joint with epoxy grout including the surface preparation cleaning the joint, sealing the tile gape with epoxy joint grout and finishing neatly including the cost of all material and labour charges etc.,

Supply and fixing UPVC Doors as per PWD SSR Specifications

Supply and fixing UPVC Windows as per PWD SSR Specifications

Supply and fixing UPVC Ventilators as per PWD SSR Specifications

Supply and fixing Prepainted Factory Made Steel door of 2 layer of 16g thickness of size 100x200mm including all necessary fittings and locking arrangements etc., complete

Supply and fixing of safty grills for windows/ventilator using mild steel sq. rods of 12mm size with spacing @ of 20cm for horizontal rods and 8cm for vertical rods including the cost of material welding, fixing to position by drilling wall/wooden sill portions of window/ventilator, finishing with 2 coats of iron painting with a primer coat etc., complete

Supply and fixing of european water closet (Suit Type) with "P" or "S" trap with double flapped seat and seat cover with brass hinges and 12.5 lt capacity PVC low level flush tank with all internal fittings.

Supply and fixing hand wash basin with pedes (Premium Model Hindware/Jaquare) with all fittings including the cost of materials and labour charges.

Painting one coat with approved cement paintover cement plastered wall and Ceilingincluding cleaning, preparing the surface and curing etc

Painting two coats of ready mixed plastic emulsion paint over a primer coat on wall surface after thorough scrapping and the rate including cost and conveyance of all materials, labour etc, complete with standard specification

Painting two coats over iron works and the rate including cost and conveyance of all materials, labour etc, complete with standard specification.

Providing and fixing the following diameter rain water Down Fall pipe including fixing fratting at the junction of parapet and RCC floor or roof slap including finishing etc the rate is to included of teak wood plugs the pipe is to be fixed by means of U clamps at the centre of the pipe of is to sorewed to the plugs. The special type of U clamps at the centre of the pipe is to be fixed in addition to this for more than 3mm pipe length etc., complete complying with standard specification.

Supplying and laying and jointing PVC pipes of approved best quality conforming to I.S.S and with I.S.I mark (6 Kg / 1 cm2) with rigid joints, spigot and socket joints ends in dry condition with paste including necessary earthwork excavation to the required depth for trenches including shoring and strutting wherever found necessary and refilling same, well rammed, consolidated, leveling the ground, laying the pipe to true alignment land gradient and giving required water supply tests with necessary tools and plants etc., as directed, complete complying with standard specification.

110mm diameter PVC pipe (6 Kg / cm2)

75mm diameter PVC Pipe

50mm diameter PVC Pipe

25mm diameter UPVC Pipe

20mm diameter CPVC Pipe

Supply of SFRC manhole cover 60x60xm

Bathroom and Sanitary fittings

SSElbow action/pillar tape tape item

1 HP Monoblock pump

Bib cock with health faucet item

SS heavy Duty Long body tape item

CP angle cock tape

SS towel racks

porcelain soap tray Tray

Mirror 600x450mm

Mirror 1000x780mm

Screw down tap

Cost of 32mm GM ValveP

CEILING FAN : Supply and fixing of 1400mm 56" sweep ceiling fan complete with stepped electronic 300W regulator with 1down rod including fan clamp with side plates and cross arm of size 450mm. Including the cost of materials and labour charges.

GEYSER 25 LTRS: Supply and fixing of Automatic electrical water heater with copper container, with glass wool/puf insulation with MS powder coated shell suitable for 25 lts capacity 230V/1000W including material and labour charges.

EXHAUST FAN : Supply and fixing of 300mm (12") sweep - light duty) AC exhaust fan complete with necessary wall opening and making good of the wall

AC PLUG POINT : Supply and fixing of 20A DP and socket in sheet enclosure with 32A DP mCB in flush with wall with earth connection (FOR AC PLUG POINT) [LEGRANT (MDS)/HAGER (L&T) make.

CFL BULK HEAD: Supply and fixing WT bulk head fitting (Philips/Bajaj/K.lite/Crompton Grieaves) suitable for 11watts CFL lamp with bulb

8 WAY DP SWITCH : Supply and fixing of 8 way single pole and neutral MCB sheet steel enclosure distribution board with double door (metal) 1 No.32ADP MCB as incoming and 6Nos. 6A to 32ASP MCB out going in flush with wall and making good of the concealed portion with earth connection only. The MCB DB and MCB's should be with ISI mark (like standard make)

3 PHASE DISTRIBUTION BOARD: Supply and fixing VERTICAL THREE PHASE DISTRIBUTION BOARD WITH MCBS 4 way / 8 way / 12 way vertical TPMCB sheet steel distribution boards flush type / surface type fitted with bus bars and neutral links with single / three phase MCB outgoings and separate 4 way provision for accommodating One No. 4 pole incoming MCB / Isolator and another separate 4 way provision for accommodating One No. 4 pole ELCB / RCD with label holder and provisions for taking up cable.

3 PHASE TNEB METER BOARD: Supply and fixing of TNEB meter board for 32 Amps THREE PHASE service connection with 32A fuse unit (500V) 32A neutral link and earth link (1"x1/8" copper flat) on TW plank of size 600x450mmx19mm with aupporting TW reepers of 1" thick on either side with painting suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit.

SERVICE CONNECTION 3 PHASE: Supply and run of 4 of 6 Sq.mm (84/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100 n 7/20GI bearer wire for service connection mains

LIGHT/FAN POINT - CONCEALED: Wiring with 2x1.5 sq.mm (22/0.3) PVC insulated SC. Unsheathed Cu. Conductor of 1100 V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories and with TW switch box and 5 Amphere F.T switch in flush with wall with 3mm hylem sheet cover for making good of the concealed portion with suitable colour for PVC concealed light/fan point

5AMPS PLUG POINT - CONCEALED: Wiring with 2x 1.5sq.mm (22/0.3) PVC insulated SC. Unsheathed Cu. Conductor of 1100 V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with 150mmX100mmx113mm TW switch box for 5 Amphere 3 pin non-interlocking CS plug with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire and making good for the concealed portion with suitable colour FOR CONCEALED PVC PLUG POINT

POWER PLUG POINT - CONCEALED: Wiring with 2x4 sq.mm (56/0.3) PVC insulated SC. Unsheathed Cu. Conductor of 1100 V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories WITH 150mmX100mmx63mm TW switch box for 15 Amphere 3 pin non-interlocking CS plug with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire, and making good of the concealed portion, with suitable colour FOR CONCEALED POWER PLUG POINT,

RUNNING WIRE 2X1.5 SQ.MM - CONCEALED: Supply and run of 2X1.5 sq.mm (22/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100V Grade in suitable PVC rigid pipe on wall and ceiling with continuous earth wire connection 14SWG TC wire with painting of suitable colour

EARTH: Earthing as per ISI specification with an earth electrode of 201mt class B GI pipe of dia 40mm with copper earth plate of size 125mmx50mmx6mm with necessary funelling arrangements with necessary masonry work with 38mm RCC cover slab for the brick masonry

LED TUBE LIGHT : Supply and fixing single box type 4', 20 watt ( LED TUBELIGHT) fitting complete with electroic ballast with TW round blocks on wall or ceiling with PVC unsheathed copper leads from terminals to the fitting.

Supply and fixing curtains to windowncluding cost and conveyance of all materials and labour charges ect., complete

PROVIDING APPROACH ROAD USING PAVER BLOCK CONTROL COMMAND CENTRE

Earth work excavation and depositing on bank with lead of 10 metre and lift 2metre in hard stiff clay, stiff black cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders SS.20B

Plain Cement Concrete 1:5:10, mix using M Sand and machine broken IRC, HBG 40mm metal and including the cost of materials, conveyance and labour charges etc., complete complying with the standard specifications.

Supplying and erecting Centering and Shuttering for sides and soiffts including supports and strutting using mild steel sheets stiffened with welded mild steel angles supported by Casuarina props etc., complete complying with standard specfications.

Plain Cement Concrete 1:2:4, mix using M Sand and machine broken IRC, HBG 20mm metal and including the cost of materials, conveyance and labour charges etc., complete complying with the standard specifications.

Providing and laying, spreading and compacting graded stone aggregates to Wet Mix Macadam 250mm thick specification including premixing the materials with water at OMC in mechnanical mix plant carriage of mixed material by tipper to site laying in uniform layers with pavers in Sub Base/ Base course on well prepared surface and compacting with vibratory roller to acheive the desired density including cost of material, labour charges, rentals for machinery, fuel and all other incidental charges etc., complete as per clause 406 of MORTH

Supplying and laying precast designer paver block (TAMIN) of M50 grade 60mm thick suitable for footpaths on expensive soils etc., including the cost of paver block and conveyance of materials to work site mentioned in the tender schedule cost of loading and unloading handling during execution over sand bed of 80mm thick with conveyance of paver block cutter to site and hire charges of vibrators and block cutter operator and labour for leveling the sand to paver block etc., complete

PROVIDING WATER SUPPLY FACILITY TO COMMAND & CONTROL CENTRE AT GENEPOOL

Supplying and laying and jointing PVC pipes of approved best quality conforming to I.S.S and with I.S.I mark (6 Kg / 1 cm2) with rigid joints, spigot and socket joints ends in dry condition with paste including necessary earthwork excavation to the required depth for trenches including shoring and strutting wherever found necessary and refilling same, well rammed, consolidated, leveling the ground, laying the pipe to true alignment land gradient and giving required water supply tests with necessary tools and plants etc., as directed, complete complying with standard specification.

110mm dia PVC pipe

75mm diameter PVC Pipe

40mm diameter PVC Pipe

25mm diameter UPVC Pipe

20mm diameter CPVC Pipe

Supply of SFRC manhole cover 60x60xm

Supplying and laying and jointing 50mm Dia HDPE pipes of approved best quality conforming to TWAD Board Specification PE 100 AS PER IS 4984/2016 (10 PN) with rigid joints, spigot and socket joints ends in dry condition with paste including necessary earthwork excavation to the required depth for trenches including shoring and strutting wherever found necessary and refilling same, well rammed, consolidated, leveling the ground, laying the pipe to true alignment land gradient and giving required water supply tests with necessary tools and plants etc., as directed, complete complying with standard specification.

Supply and fixing PVC Water tank with all fittings including the cost of tank and labour charges for fixing in position etc., complete

Supplying and fixing GI Specials of approved quality and good variety but including necessary cutting and threading of G.I.Pipes for jointing the valve.

25mm diameter G.M. Wheel valve

32mm diameter G.M. Wheel valve

40mm diameter G.M. Wheel valve