CWEK-03/2022-23

Amount

Excavation in trenches not exc.1.5 mtr wide and not exc.1.5 m in depth for laying of pipes as in hard/dense soil and getting out, complete all as specified and directed.

Returning filling, including spreading, leveling , watering and well ramming in layers not exceeding 25 cm in hard/dense soil, complete all as specified and directed.

Removal of excavated material i.e soil to a distance not exc. 50m and depositing where directed at a level not exceeding 1.5 mtr above starting point complete all as specified and directed.

M & L for Sub class ‘B brick, old size, brick covering laid dry, flat, transversally along the length of cable on sand cushioning, with width equal to the length of the brick, complete all as specified and directed.

Sand cushioning to underground cables 8 cm below the cable before laying and 15 cm above the cable after laying, complete all as specified in clause 19.75 of SSR Part-I. Note :- 1. Dry fine sand of best available quality shall be used. 2. Punned thickness shall be measured and paid.

Supply and installation of copper wound transformer step down outdoor type complete with standard fitting HT 11KV 3 phase, LT 433 volts 3 phase 4 wire with off load tapping on HT side to vary secondary voltage within limit all as per IS 2006 of capacity 100 KVA complete all as specified and directed.

Supply, laying and testing cable XLPE insulated ,screened, PVC bedded, galvanised steel strip or wire armoured, electric power cables (heavy duty) with stranded aluminium conductor,1100 volts grade,of size 3.5 core cross sectional area 120 sq.mm ISI Marked complete all as specified and as directed.

Supply, laying and testing cable XLPE insulated ,screened, PVC bedded, galvanised steel strip or wire armoured, electric power cables (heavy duty) with stranded aluminium conductor,11000 volts grade,of size 3.5 core cross sectional area 120 sq.mm ISI Marked complete all as specified and as directed.

Supplying and laying reinforced precast concrete cable cover, class HV, type 1, flat , size 300mmx 180mmx 40mm complete all as specified and directed.

Supply and fixing Voltage stabilizer for automatic operation, three phase naturally oil cooled,indoor type & designed for input variation between 340 V to 460 V with output voltage stabilizer at 415 with accuracy + 2.5 % and speed of correction 8 volts per second and of capacity upto 100 KVA complete all as per specified and directed.

M & L for Cable Jointing Kit for 11 KV (Earthed) Grade cable for Outdoor termination, Heat shrink type, joint complete with jointing material and accessories suitable for 3 Core XLPE Armoured aluminium conductor cable of size 50 Sqmm to 95 Sqmm complete all as specified and directed.

Supply and fixing PVC four layer water storage tank (cylindrical vertical with closed top) hoisted and fixed in position of capacity 5000 Ltrs including required PCC work complete ISI Marked all as specified and directed by Engr-in-Charge.

Supplying and fixing 'medium grade' ISI Marked GI tubing of size 50 mm dia with all fittings like socket union, elbow ,bend, tees etc jointed and fixed complete to walls and ceiling or laid in floors for over flow, complete, all as specified and as directed.

Supplying and fixing 'medium grade' ISI Marked GI tubing of size 40 mm dia with all fittings like socket union, elbow ,bend, tees etc jointed and fixed complete to walls and ceiling or laid in floors for over flow, complete, all as specified and as directed.

Supplying and fixing 'medium grade' ISI Marked GI tubing of size 25 mm dia with all fittings like socket union, elbow ,bend, tees etc jointed and fixed complete to walls and ceiling or laid in floors for over flow, complete, all as specified and as directed.

Supplying and fixing 'medium grade' ISI Marked GI tubing of size 20 mm dia with all fittings like socket union, elbow ,bend, tees etc jointed and fixed complete to walls and ceiling or laid in floors for over flow, complete, all as specified and as directed.

Supplying and fixing 'medium grade' ISI Marked GI tubing of size 15 mm dia with all fittings like socket union, elbow ,bend, tees etc jointed and fixed complete to walls and ceiling or laid in floors for over flow, complete, all as specified and as directed.

S & F of Brass/gun metal, globe or gate valve, with flanged brass spindle and iron wheel head, screwed both ends for iron pipe of size 40mm bore complete all as specified and directed.

S & F of Brass/gun metal, globe or gate valve, with flanged brass spindle and iron wheel head, screwed both ends for iron pipe of size 25mm bore complete all as specified and directed.

S & F of Brass/gun metal, globe or gate valve, with flanged brass spindle and iron wheel head, screwed both ends for iron pipe of size 20mm bore complete all as specified and directed.

S & F of Brass/gun metal, globe or gate valve, with flanged brass spindle and iron wheel head, screwed both ends for iron pipe of size 15mm bore complete all as specified and directed.

S & F for Sluice valve of size 50 mm bore dia PN 1.6, iron wheel head,screwed both ends for iron pipe including required GI fittings complete all as specified and directed.

M & L for Earthing complete with galvanised steel earth plate electrode 60x60cmx 6 mm thick, buried directly in ground (earth pit not less than 2.25 metres deep below ground level) with top edge of the plate not less than 1.5 metres below normal ground level, connected to galvanised earth lead wire 4.0 mm by means of bolts, nuts, check nuts and washers of galvanised iron or steel including PCC (concrete chamber) shall be PCC 1:3:6 type C-1 using 20mm graded stone aggregate,with fair finish internal surface of concrete chamber shall be given 15mm thick plaster in CM 1:4,funnel with wire gauge of (0.68) 8 mesh per liner inch,80mm thick RCC pit cover 320 mmx320 mm of RCC 1:2:4 type B-1 using 20 mm graded stone aggregate reinforced with XPM,JALLI and charcoal dust and common salt all as shown in electrical plate No.3 of MES SSR Part-1 and specified including provision of earth wire protected by 40 mm dia medium grade GI pipe and watering pipe shall be 20 mm bore medium graded GI pipe,and including all excavation and earth work & connecting the earthing to an earthing test point /transformer neutral/body/LT panel etc.and testing on completeion complete all as spec ified and directed. NOTE: The quoted rate of earthing shall be deemed to included cost of 7.5m long galvanised earth lead wire 4.0mm and protection pipe of 40 mm bore medium graded ,GI light graded 20mm bore watering pipe ISI Marked.

M & L for Earthing complete with galvanised steel earth plate electrode 60x60cmx 6.3mm thick, buried directly in ground (earth pit not less than 2.25 metres deep below ground level) with top edge of the plate not less than 1.5 metres below normal ground level, connected to galvanised iron strip 32x6mm by means of bolts, nuts, check nuts and washers of galvanised iron or steel including PCC (concrete chamber) shall be PCC 1:3:6 type C-1 using 20mm graded stone aggregate,with fair finish internal surface of concrete chamber shall be given 15mm thick plaster in CM 1:4,funnel with wire gauge of (0.68) 8 mesh per liner inch,80mm thick RCC pit cover 320 mmx320 mm of RCC 1:2:4 type B-1 using 20 mm graded stone aggregate reinforced with XPM,JALLI and charcoal dust and common salt all as shown in electrical plate No.3 of MES SSR Part-1 and specified including provision of earth wire protected by 40 mm dia medium grade GI pipe and watering pipe shall be 20 mm bore medium graded GI pipe,and including all excavation and earth work & connecting the earthing to an earthing test point /transformer neutral/body/LT panel etc.and testing on completeion complete all as spec ified and directed. NOTE: The quoted rate of earthing shall be deemed to included cost of 7.5m long galvanised earth strip 32x6 mm and protection pipe of 40 mm bore medium graded ,GI light graded 20mm bore watering pipe ISI Marked.

Supply and Fixing horizontal multistage centrifugal pumpset of capacity 30 HP, 3 phase, head -150 mtr, 20cum/hr including base frame and foundation as per manufacturer's design and electric connection with suitable size PVC insulated copper conductor cable drawing through and including flexible conduit from main control panel to starter and starter to motor including thimble of suitable size, and all necessary connection for suction and delivery pipes and all holding arrangments foundation complete all as specified and directed by Engr-in-Charge.

Supply and Fixing horizontal multistage centrifugal pumpset of capacity 20 HP, 3 phase, head -194 mtr, 10cum/hr including base frame and foundation as per manufacturer's design and electric connection with suitable size PVC insulated copper conductor cable drawing through and including flexible conduit from main control panel to starter and starter to motor including thimble of suitable size, and all necessary connection for suction and delivery pipes and all holding arrangments foundation complete all as specified and directed by Engr-in-Charge.

Supply and Fixing horizontal multistage centrifugal pumpset of capacity 20 HP, 3 phase, head -194 mtr, 10cum/hr including base frame and foundation as per manufacturer's design and electric connection with suitable size PVC insulated copper conductor cable drawing through and including flexible conduit from main control panel to starter and starter to motor including thimble of suitable size, and all necessary connection for suction and delivery pipes and all holding arrangments foundation complete all as specified and directed by Engr-in-Charge.

Supply and fixing Star Delta starter, oil immersed,initial oil filled,3 phase ,50 c/s, 440 V suitable for 40 HP pumping set for heavy duty type SSD complete all as specified and directed by Engr-in-Charge.

Supply and fixing Star Delta starter, oil imersed,initial oil filled,3 phase ,50 c/s, 440 V suitable for 30 HP pumping set for heavy duty type SSD complete all as specified and directed by Engr-in-Charge.

Supply and fixing of 50 Sqmm, single core HRFR PVC insulated industrial grade copper conductor (unsheathed) flexible cable,1100 volts conforming to IS :694 complete all as specified and directed.

Supply and fixing single phase preventor complete all as specified and directed. Make:- Minilec/Siemens/L&T

M&L for Construction of shed of size 3.5m x 3.5m x 2.5m for motor starter and panel including steps,plinth protection,cable duct complete all as specified and directed refer details as per drawing NO CESZ/TD-1110/2011 sheet 1/2 and 2/2 Dated 01/12/2011

Supply and fixing control unit for motor including all fixing accessories complete all as directed by Engr-in-Charge. Note :- Each control unit consist of MCCB 4 pole,63 Amps, 25 KA -01 No, MCCB 4 pole , 100 Amps, 36 KA -02 single preventor -01 No, RYB indication light -01 set, Ammeter 0-100 A - 01 No Voltmeter 0-500V -01 No and the cost shall be deemed to be included in quoted rate.

M/S Charan Singh and Sons