REPAIR/MAINT TO CHAIN LINK/BARBED WIRE FENCING ETC AT AGE(I) FATEHGARH

Amount

Dismantling of chain link fencing of any description & in any position fixed to mild steel angle /RCC post complete as directed.

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion and making good disturbed ground, posts embedded in natural ground or enclosed with Concrete, brick work, ground masonry, etc.complete all as specified and directed.

Excavating post holes in soft/Loose soils (or similar holes ) n exc 0.50 Cum each and getting out and returning filling in balance portion (after PCC filling Ref note given below) with boulder and mixed with earth in layers exceeding 25 Cm thick, rammed, watering and removing surplus soils to a distance exc 100 M but n exc 250 Mtr and deposited where directed . Note :- (i) The PCC 'for fxing post shall be measured and paid sepeartely under appropriate item of Sch À. (ii) The cost of boulder and earth shall deemed to be included in quoted unit rate by the contractor.

M&L for PCC (1:3:6) type C-2 (using 40 mm graded stone aggregates) for fixing post in post holes/embedding the post all as specified and directed.

M& L for Mild Steel work of Posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc flat iron fillets (for securing wire mesh etc) including all necessary drilling bolting or riveting etc; half round or other stock section, drilled and countersunk for balusters running bars, for doors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts and similar work conforming to Fe-290 Gde E-165 with & including preparation of surfaces & applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

Mild steel screw bolts (Machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, exceeding 5 cm long but not exceeding 16 to 20mm dia of neck complete all as specified and directed.

S&F mild steel TMT bars 10 mm dia and over cut to length ,bent to shape required ,including cranking bending ,spirally for hooping for column ,hooking ends and binding with and including mild steel wire (annealed) not less than .9 mm dia or securing bolts etc complete all as specified and directed.

Supply & fixing chain link fencing made out of mild steel galvanised wire of 4 mm dia GI wire having mesh size 75 mmx75 mm of pattern & design as approved by AGE (i) complete all as specified and directed.

S&F for GI barbed wire 2 strand steel barbed wire 2.24 mm dia barbed with 2 mm barbs at 75 mm spacing and shall confirming to IS-278-2001 & IS-280-2006 and straining and fixing to any type of standrad rails with & including necessary straining bolts including securing or tying at crosssing with and provision of Galvanized mild steel wire ,staples or steel pins etc with & including dismantling complete all as specified and directed. Note :- (i) The entire quantity brought by the contractor shall be got approved from AGE(I) before fixing. (ii) The weight of barbed wire shall be between 97 to 106 Kg per KM. (iii) Rates quoted by the contractor includes the cost of necessary straining/adjustment nut bolts

M&L for preparation of new or previously untreated surfaces of steel of any description, over 10 cm in width or girth and apply Two coat of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

Demolition of cement concrete in ground floors and pavings n exc 15 cm thikness (below or above ground level) complete all as specified and directed.

M&L for 15mm thick screed bed or bedding layer of cement mortar 1:6 for laying floor finishes complete all as specified and directed.

M&L for 50 mm thick PCC (1:4:8) type D-1 using (20mm graded stone agg) as in flooring complete all as specified and directed.

M&L for chequered cement concrete tiles 25 cm x 25 cm x 20 to 25 mm thick set, jointed and pointed in neat cement slurry as in floors with grey cement and pigments complete all as specified and directed.

M/S WASEEM KHAN CONTRACTOR

M/S S P CONSTRUCTION