Estimate for New Connection of 01 No 64 KW Non domastic Connection applied from SDE Building BSNL Morena on 11 KV Industrial Feeder at place Dholpur Road Morena under Ganeshpura Zone of (OandM) Dn. Morena-I

Task Name : 100 KVA DTR

11 KV AB Switch Polymer type 400 Amp with Complete fitting

Erection costo of 11 KV AB Switch Polymer type 400 Amp with Complete fitting

11 KV AL 59 ACS Covered Conductor 78.82 sq.mm along with MVCC accessories as per EN:50397 Calculated for 1 KM Single Phase Feeder, tension/dead/anchoring clamps with piercing connector suitable for MVCC, IPC for CC to CC connection,EN-50397 -P-2

Erection cost o f 11 KV AL 59 ACS Covered Conductor 78.82 sq.mm along with MVCC accessories as per EN:50397 Calculated for 1 KM Single Phase Feeder, tension/dead/anchoring clamps with piercing connector suitable for MVCC, IPC for CC to CC connection,EN-50397 -P-2

11 KV D.O. Fuse Unit Polymer type

Fixing of 11 KV D.O. fuse unit ( Set of 3 No. )

11 KV Strain hardware (T&C type) fittings

11 KV(45KN) Composite Polymer Disc Insulators

Erection cost of 11 KV Disc Insulators with hardware

9 KV Gapless type ( 5KA) Polymer for DTR

Erection cost of 9 KV Gapless type ( 5KA) Polymer for DTR

AAAC Rabbit conductor 0.05 sq. inch. (55 sq.mm. Al.Eq.)

DTR 11/0.4 KV BIS EE-Level-2 100 KVA

Handling & Installation of Distribution Transformer (DTR) on DP, tightening with turn buckles on both sides, poles clamping and boting of base jumpering on HT side (Including hydra charges in urban area and chain pully charges in rural area)

H-Beams 152 X 152 mm., 37.1 Kg./Mtr.-11 mtr. Long = 408.1 kg

Erection cost of material with transportation for H-Beams 152 X 152 mm., 37.1 Kg./Mtr.-11 mtr. Long = 408.1 kg

Three phase Static Energy meters 20-80 Amps.with L.S. & TOD Facility with box

XLPE Cable 1 core unarmoured 150 sqmm Aluminium conductor 1100 Volts

XLPE Cable 1 core unarmoured 70 sqmm Aluminium conductor 1100 Volts

11 KV Single pole cut point fitting 100x50x6 mm channel

Erection cost of 11 KV Single pole cut point fitting 100x50x6 mm channel

Aluminium paint

Erection cost of Aluminium paint

Anti climbing devices ( Barbed wire 2.24 mm dia, 14 SWG)

Back Clamps for H-Beam of MS Flat 65x8mm (Each weight 1.92 Kg)

Bentonite compound powder

Bi-metallic clamps Distribution Transformers Bushing

Bi-metallic clamps suitable for 12mm dia stud and 80sqmm AAAC

Clamp 65X8 mm Flat of MS Flat for H-Beam ( Each weight 3.2 kg)

Concreting of Rail / Hbeam supports @0.65 Cmt.per pole including muffing of pole

Erectio cost of Concreting of Rail / Hbeam supports @0.65 Cmt.per pole including muffing of pole

D.C. Cross-arms 8 ft centre to center (100x50x6mm) Channel

Erection cost of D.C. Cross-arms 8 ft centre to center (100x50x6mm) Channel

D.O.Mounting Channel 75x40x6mm

Eretion cost of D.O.Mounting Channel 75x40x6mm

Danger Boards Enamelled 11 KV

Erection cost of Danger Boards Enamelled 11 KV

Double Gate (2No-2.5'x5x) set of MS angle (25x25x4mm) with mesh & locking

Erection cost of Double Gate (2No-2.5'x5x) set of MS angle (25x25x4mm) with mesh & locking

DTR S/s fencing (37 feet) of 6' with on MS Angle(50x50x6mm) 7No, 7'Height

Erection cost of DTR S/s fencing (37 feet) of 6' with on MS Angle(50x50x6mm) 7No, 7'Height

G.I. STRIP 25X3 MM1

G.I.Pipe 40 mm Dia C grade type

Erection cost of G.I.Pipe 40 mm Dia C grade type

Galvanized nut & bolt with washer

LT distribution box with 1.2 mm thick MS powder coated sheet, 315 A MCB on incoming & 6 no. 250 A HRC fuse base including 200 A HRC fuse , For 200 KVA Transformer

Erection cost of LT distribution box with 1.2 mm thick MS powder coated sheet, 315 A MCB on incoming & 6 no. 250 A HRC fuse base including 200 A HRC fuse , For 200 KVA Transformer

M.S.Nuts with Bolts

Red oxide paint

Erection cost of Red oxide paint

Stone Block/Pre cast block for base pedding(450X450X75MM)

Trans. Belting with 50 X 50 X 6 mm.angle with two cross fixing channels

Transformer mounting Channel (100X50x6 mm.)

Erection cost of Transformer mounting Channel (100X50x6 mm.)