Widening and Strengthening of Sadullaganj to Samrer Kaman Kundra Kharsai Beladandi road (ODR) in KM 6.400 to 18.000 at District Budaun in Year 2024-25

Amount

Excavation for roadwork in soil with hydraulic excavator including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location within all lifts and lead upto 1000m As per MORT&H Specification 2019, S.No. 3.06 (Clause-301)

Construction of embankment with approved material deposited at site from roadway cutting and excavation from drain anmd foundation of other structures graded and compacted to meet requirement of table 300-2

Construction of embankment with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300-2. As per MORT&H Specification 2019, S.No. 3.16 (Clause-305)

Construction of granular sub-base by providing close graded Material, mixing in a mechanical mix plant at OMC, carriage of mixed Material to work site, spreading in uniform layers with motor grader on prepared surface and compacting with vibratory power roller to achieve the desired density, complete as per MORTH 2019 S.No. 4.01 clause 401A (Grading -1 Material)

Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with grader in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density. As per MORT&H Specification 2019, 4.14 (Clause-406B)

Construction of un-reinforced, dowel jointed, plain cement concrete pavement (M-35) over a prepared sub base with 43 grade cement @ 400 kg per cum, coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, laid with a fixed form or slip form paver, spread, compacted and finished in a continuous operation including provision of contraction, expansion, construction and longitudinal joints, joint filler, separation membrane, sealant primer, joint sealant, debonding strip, dowel bar, tie rod, admixtures as approved, curing compound, finishing to lines and grades as per drawing. (As per MORT&H Specification S.No. 6.02 Clause 602

Providing, laying and spreading of graded stone aggregate (WMM) after mixing with water at OMC in mechanical mix plant carriage of mixed material by tipper to site , laying with 1% OPC cement and 3.5% Emulsion in uniform single layer on sub base/subgrade and compacting with the road roller to achieve the desire density. As per MORT&H Specification 2019, 4.14 (Clause-406A)

Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2 As per MORT&H Specification 2019, S.No. 3.18 (Clause- 305)

Providing and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.20 kg per sqm on the prepared bituminous surface cleaned with mechanical broom.As per MORT&H Specification 2019, S.No. 5.02 (Clause-503I)

Providing and laying bituminous concrete (Grading-II) with higher capacity batch type hot mix plant using crushed aggregates of specified grading, premixed with bituminous binder @ 5.4 per cent of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per As per MORT&H Specification 2019, S.No. 5.05 (Clause 507B)

Earth work in excavation of foundation of structures as per drawing and technical specification, including setting out, construction of shoring and bracing, removal of stumps and other deleterious matter, dressing of sides and bottom and backfilling with approved material. as per MORTH 2019 S.No. 9.01 clause 304.

PCC-M15 Plain/Reinforced Cement Concrete in Open Foundation complete as per Drawing and MORT&H sr. 12.08 Technical Specifications 1500,1700 & 2100.

Plain / Reinforced cement in sub structure complete as per drawaing & complete specification RCC Grade M-30 Using batching plant transit mixer & concrete pump (Height upto 5mtr)

Plain / Reinforced cement in sub structure complete as per drawaing & complete specification RCC Grade M-35 Using batching plant transit mixer & concrete pump (Height upto 5mtr)

Plain/Reinforced Cement Concrete in sub structuree complete as per drawing and Technical Specifications 1500,1700 & 2200 (M-25)

Supplying, fitting and placing HYSD bar reinforcement in super-structure complete as per drawing and technical specifications

Providing Weapholes in brick masonry/ stone masonry ,plain/ Reinforced abutment, wing wall , returning wall with 100 mm dia AC pipe extending through the full width of the Sturcture with slope of 1(v):2(H) towards drawing face Complete as per drawing and technical Specification Clause 2706, 2200

Providing and laying Filter material underneath pitching in slopes complete as per drawing and Technical specification MORTH 2504 Sr no. 16.05

Providing and laying Pitching on slopes laid over prepared filter media including boulder apron laid dry in front of toe of embankment complete as per drawing and Technical specifications MORTH 2503 Sr No. 16.01

Brick Masonry Work in Cement Mortar 1:3 in Foundation complete excluding Pointing and Plastering, as per Drawing and MORT&H sr. no. 12.05 Technical Specifications1300.as per MORTH 2019 S.No. 12.05 clause 1300

Supply & laying of compacted 40 mm gauge brick ballast around and below hume pipe (As per N.S. Item No. 8)

Pointing with cement mortar (1:3 ) on brick work in substructure as per Technical Specifications as per MORTH 2019 S.No. 13.02 clause 1300& 2200

Plain/Reinforced Cement Concrete in Open Foundation complete as per Drawing and MORT&H sr. 12.08 Technical Specifications 1500,1700 & 2100.

Laying Reinforce cement concrete pipe NP 4 / Prestressed concrete pipe on first Class bending in single row.

PRADEEP KUMAR CONTRACTOR (BID ID -4877604)