Refurbishment of Room No.F007-F011 and adjacent room of Commissioner and Secretary , Finance Department, F-Block, Janata Bhawan Dispur, Ghy-6

Dismantling cement asbestos or other hard board ceiling or partition walls including stacking of serviceable materials and disposal of unserviceable materials within 50 metres lead.

Providing and laying integral cement based water proofing treatment including preparation of surface as required for treatment of roofs, balconies, terraces etc consisting of following operations:22.7.1 With average thickness of 120 mm and minimum thickness at khurra as 65 mm

Diluting and injecting chemical emulsion for POST-CONSTRUCTIONAL anti-termite treatment (excluding the cost of chemical emulsion) : 2.35.3 Treatment of soil under existing floors using chemical emulsion @ one litre per hole, 300 mm apart including drilling 12 mm diameter holes and plugging with cement mortar 1 :2 (1 cement : 2 Coarse sand) to match the existing floor: 2.35.3.1 With Chlorpyriphos/Lindane E.C. 20% with 1% concentration

Providing and fixing false ceiling at all height including providing and fixing of frame work made of special sections, power pressed from M.S. sheets and galvanized with zinc coating of 120 gms/sqm (both side inclusive) as per IS : 277 and consisting of angle cleats of size 25 mm wide x 1.6 mm thick with flanges of 27 mm and 37mm, at 1200 mm centre to centre, one flange fixed to the ceiling with dash fastener 12.5 mm dia x 50mm long with 6mm dia bolts, other flange of cleat fixed to the angle hangers of 25x10x0.50 mm of required length with nuts & bolts of required size and other end of angle hanger fixed with intermediate G.I. channels 45x15x0.9 mm running at the spacing of 1200 mm centre to centre, to which the ceiling section 0.5 mm thick bottom wedge of 80 mm with tapered flanges of 26 mm each having lips of 10.5 mm, at 450 mm centre to centre, shall be fixed in a direction perpendicular to G.I. intermediate channel with connecting clips made out of 2.64 mm dia x 230 mm long G.I. wire at every junction, including fixing perimeter channels 0.5 mm thick 27 mm high having flanges of 20 mm and 30 mm long, the perimeter of ceiling fixed to wall/partition with the help of rawl plugs12.45.1 12.5 mm thick tapered edge gypsum plain board conforming to IS: 2095- (Part I) :2011 (Board with BIS certification marks) at 450 mm centre, with 25mm long dry wall screws @ 230 mm interval, including fixing of gypsum board to ceiling section and perimeter channel with the help of dry wall screws of size 3.5 x 25 mm at 230 mm c/c, including jointing and finishing to a flush finish of tapered and square edges of the board with recommended jointing compound , jointing tapes , finishing with jointing compound in 3 layers covering upto 150 mm on both sides of joint and two coats of primer suitable for board, all as per manufacturer's specification and also including the cost of making openings for light fittings, grills, diffusers, cutouts made with frame of perimeter channels suitably fixed, all complete as per drawings, specification and direction of the Engineer in Charge but excluding the cost of painting with :

Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface :13.43.1Water thinnable cement primer

Wall painting with acrylic emulsion paint of approved brand and manufacture to give an even shade :13.60.1 Two or more coats on new work

Providing and fixing double action hydraulic floor spring of approved brand and manufacture conforming to IS : 6315, having brand logo embossed on the body / plate with double spring mechanism and door weight upto 125 kg, for doors, including cost of cutting floors, embedding in floors as required and making good the same matching to the existing floor finishing and cover plates with brass pivot and single piece M.S. sheet outer box with slide plate etc. complete as per the direction of Engineer-in-charge.21.4.2 With brass cover plate minimum 1.25 mm thickness.

Providing and fixing in position collapsible steel shutters with vertical channels 20x10x2 mm and braced with flat iron diagonals 20x5 mm size, with top and bottom rail of T-iron 40x40x6 mm, with 40 mm dia steel pulleys, complete with bolts, nuts, locking arrangement, stoppers, handles, including applying a priming coat of approved steel primer.

Supplying fitting and fixing of 2mm thick toughened glass for door and fiaxed glass with overhead panel (size 2.40mx1.20m) aong with GEZE floor spring GEZE handle 300mm partch floor locks, connecting patch etc. complete in all levels as specified and directed by the Department.

Providing ,fitting and fixing Decorative Partition wall of size 2.14 x 2.00 x0.16 made of green ply board, vinear Etching Glass fitted with all fittings,. Complete in all respect as specified and directed by the Deptt.

Providing erecting cutting and fixing of 420 mm depth free standing file cabinate/rack with laminated finished,erected/making to be made with 19mm thick Greenply plywood on all frame structure and required partition with self member as per required height with providing fixing of edge binding in all plywood edges cuitting and pasting with fixing for 1.5mm thick decorative laminated sheet in both side of ply surface including all hardware fittings like,nails,fevicol,pesting tap,handle,lock,hinges,tower bolt,magnate catcher etc. as a complete with all necessary required materials and labour as directed by the concern department.

Providing fitting and fixing of Wooden Flooring (Nobile Laminate flooring, BVG) with under layer of 6mm materials & installation including labour, carriage etc as directed and specified

Supplying, fitting and fixing Johnson Zebra Roller Blinds (Combi Blackout) make and shade, design as per choice complete as specified and directed by the department at all levels.

Supplying of single backless couch reputed make and shade design as directed by the department

Supplying of two seater sofa reputed make and shade design as directed by the department.

Providing fitting, fixing PVC panels for wall and ceiling (Plain) with mterials installation including labour , carriage etc. as directed and specified.

Providing and fixing Conference Table made of 19mm GREEN ply and outside finished with 1mm thick mica and all inside surface finished with viner complete with necessary hardware fittings as per design as directed and specified by the Deptt.

Providing fitting fixing Carpet for floor with material & installation including labour carriage etc. as directed and specified.

Providing and Fixing of Linear Grooved Slats Sound Absorption Panels HDF based Melamine Finish Sound Absorption Panels on walls over GI frame work of 48mm GI Studs and 50mm floor using 0.50mm thick stud channels at 610mm c/c, fixed with MS angle/GI channel cleats @ 1220x610mm centers to wall by using fasteners, backed with 50mm thick 1000GSM FR grade polyester wool, as per detailed drawing. The panels are made of High Density Fibreboard of density about 760 to 800 kg/m3 with low formaldehyde content. The top surface is laminated with melamine finish. Each panel is having tongue and groove structure on the long side with an additional groove to hold the clip of size 2440mmX128mmX16mm. The back of each panels is pasted with acoustic fleece of density 80kg/m3. The front of the panel is grooved in width of 4mm and depth of 4mm while the back is perforated with holes of dia 10mm. All complete as per the design & drawings.

Supplying,fitting and fixing of Delux Chair reputed make and shade design as per directed by the department.

Supplying,fitting and fixing of corian top make and shade design as directed by the Department.

Wiring for light point/ fan point/ exhaust fan point/ call bell point with 1.5 sq.mm FRLS PVC insulated copper conductor single core cable in surface / recessed medium class PVC conduit, with modular switch, modular plate, suitable GI box and earthing the point with 1.5 sq.mm FRLS PVC insulated copper conductor single core cable etc. as required. GROUP-C

Wiring for circuit/ submain wiring alongwith earth wire with the following sizes of FRLS PVC insulated copper conductor, single core cable in surface/ recessed medium class PVC conduit as required. 2 X 1.5 sq. mm + 1 X 1.5 sq. mm earth wire

2 X 2.5 sq. mm + 1 X 2.5 sq. mm earth wire

2 X 4 sq. mm + 1 X 4 sq. mm earth wire

Supplying and fixing following modular switch/ socket on the existing modular plate & switch box including connections but excluding modular plate etc. as required. 5/6 A switch

15/16 A switch

3 pin 5/6 A socket outlet

6 pin 15/16 A socket outlet

Supplying and fixing two module stepped type electronic fan regulator on the existing modular plate switch box including connections but excluding modular plate etc. as required.

Supplying and fixing following size/ modules, GI box alongwith modular base & cover plate for modular switches in recess etc. as required. 1 or 2 Module (75mmX75mm)

4 Module (125mmX75mm)

6 Module (200mmX75mm)

8 Module (125mmX125mm)

Supplying and fixing following Modular base & cover plate on existing modular metal boxes etc. as required. 1 or 2 Module

4 Module

6 Module

8 Module

Supplying and insstallation of 1200mm service value including parts and accessories Electric ceilling type fan as per IS374 as specified and directed by the Deptt. (ORIENT/CROMPTON/BAJAJ/ or equivalent make(GEM PRODUCT ID 5116877-83928411529)

Supplying and installation of 16W lighting Fixtures and accessories general lignting and fixture LED round Luminaire (Recessed Luminaire) Rev. 1 as specified and directed by the Deptt. (GEM PRODUCT ID 5116877-57957607394 ) (ORIENT/ CROMPTON /LEDURE) or equivalent make

Supplying including installation of LED Strip grow light as specified and directed by the Deptt. (GEM PRODUCT ID 5116877-2247928608) (BAJAJ/CROMPTON/JAQUAR or equivalent make)

Supplying including installatiion of 16A,250V PP single Multi Pin Electrical Top for industrial as specified and directed by the Department (GEM-PRODUCT ID 5116877-143845831) (GREATWHITE/HEAVELL's/C&S or equivalent make.

Supplying with fitting and fixing of Single Phase Modular Motor Starter switch MODEL RANGE LEGRAND (MYRIUS)ANCHOR ( VIOLA),MK (WARAPAROUND/ PLUS),ABB (CHEIRON), KOLARS (KREST), SCHNEIDER (VIVAGE), CRABTREE inclding making necessary connection as per direction of deptt.

Supplying including installation of Home Distribution and conditioning systems and Equipments and Heating and ventilation and Air Circulation Maelic Mount Suitable for Air Conditioneer (Asccessories) as specified and directed by the Deptt. (GEM PRODUCT ID-516877-74236143769) (VOLTUS/CARRIER/ BLUESTAR or equivalent make)

Supplying including installation of 2 Ton with 3BEE stsar rating Split Type Air Conditioners including Green AC and AIR circulation cooling Equipments and Parts and Accessories as specified and directed by the Deptt. (GEM PRODUCT ID 5116877-32630235651) (VOLTAZ/CARRIER/BLUESTAR or equivalent make)

Supplying including installation of Home Distribution and conditioning systems and Equipments and component Heating and ventilation and Air Circulation Extra refrigent pipe for Air Conditioneer (Asccessories) as specified and directed by the Deptt. (GEM PRODUCT ID-516877-93181769304) (PANASONIC/CARRIER/GODREJ or equivalent make)

Supplyinh omv;ifomh ;syinh of 3.0 Core 2.5sq.mm PVC Copper Circular Sheathed Cable with flexible conductor to be used as interconnecting communitation cable between Indoor & Outdoor units as per IS:694 as specified and directed by the Deptt. (GEM PRODUCT ID 5116877-16964573993) (MICROTECH/ V-GUARD or equivalent make)

Supplying including installation of Home domestic Appliances and supplies and consumer Electronic Product Consumer Electronics Audio & Visual equipments Televation TV 65 Inch 4K Ultra HD as specified and directed by the Deptt. (GEM PRODUCCT ID 5116877-79234166962) (SAMGSUG/LG/SONY or equivalent make

Supply, installation Testing and commissioningof Pop up Box havingHDMI.^A socket (Accepted Rste as per Tender No. 346 EL of 2024-25 of Executive Engineer, PWD, Electrical Division.

Please Enable Macros to View BoQ information