SHORT PRESS NIT 25(2022-23)HP-I

Supply of sludge submersible pump set for dewatering muddy water, containing sand, silt etc. Upto passing particular 25mm solid of 50 HP capacity, having discharge not less than 9500 LPM at 12 mtrs. Head, discharge size 250 mm, ‘F’ Class Insulation with thermostat motor protection suitable for 415 volt, 3 phases, 50HZ, IP 68 Standard, MAKE- Any DJB approved make along with 30 mtrs., waterproof cable for each pump for connection from panel. (Make- Any DJB approved make)

Supply of LT Distribution panel capacity- Suitable to power supply sludge pumps (existing 02 nos. plus 01 no. mentioned in sr. no. 01). Disconnect or fuse switch unit inside the existing panel board with ISI marked HRC fuses. Make:- Any DJB approved.

Supply of 250 mm dia., HDPE, PN6 class water pipes along with necessary clamps, vibration isolators and fittings such as bends, tees, valves, strainers, gauges etc. Note:-The Pipes size 250mm & below shall be HDPE -PIN 6 class as per IS : 14333:1996.

Supply of 3.5×150 sq mm, 1.1 kV grade, XLPE insulated, stranded Aluminum conductor, galvanized steel flat strip / round wire armored, extruded PVC type ST2 sheathed, conforming to IS:7098 (Part-1) & IEC:60502 (Part-1) water and weather proof cable for double supply source. Make : Grandley, Gloster, Havells

Laying of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of 3.5x150 sq. mm direct in ground including excavation, sand cushioning, protective covering and refilling the trench etc as required. As per DSR 2018: code- 7.5.3

Providing and fabrication of shed for all Panels on both site including CC work in shed area.

Installation of sludge submersible pump set along with approx 5 to 6 Mtr M.S. pipe, fixing of Control panel with all necessary works like structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, lowering and lifting arrangement with 250x150mm I beam having chain pulley and 250x300 mm vertical MS Column, lifting capacity 03 ton, fixing in position of pump sets adequately supported on rigid supports duly painted. Laying of HDPE pipe buried in ground excavation and refilling etc. as per specification and as required complete in all respect. Making electrical connections as per requirement of site and Commissioning & testing the same on load.

ARISETEC ENTERPRISES