Loading…
Loading…
Tender Value
₹1.1 Cr
EMD Value
₹2.3 L
Closing Date
19 Aug 2026, 3:00 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
ESTATE II
14 conditions · 2 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N or 'V' whichever is less; where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
Technical Eligibility Criteria: (a) The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i) Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii) Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii) One similar work costing not less than the amount equal to 60% of advertised value of the tender. (b) (1) In case of tenders for composite works (e.g. works involving more than one distinct component, such as Civil Engineering works, S&T works, Electrical works, OHE works etc. and in the case of major bridges - substructure, superstructure etc.), tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i) Three similar works each costing not less than the amount equal to 30% of advertised value of each component of tender, or (ii) Two similar works each costing not less than the amount equal to 40% of advertised value of each component of tender, or (iii) One similar work each costing not less than the amount equal to 60% of advertised value of each component of tender.Note for b(1): Separate completed works of minimum required values shall also be considered for fulfillment of technical eligibility criteria for different components. (b)(2)In such cases, what constitutes a component in a composite work shall be clearly pre- defined with estimated tender cost of it, as part of the tender documents without any ambiguity.(b) (3) To evaluate the technical eligibility of tenderer, only components of work as stipulated in tender documents for evaluation of technical eligibility, shall be considered. The scope of work covered in other remaining components shall be either executed by tenderer himself if he has work experience as mentioned in clause 7 of the Standard General Conditions of Contractor through subcontractor fulfilling the requirements as per clause 7 of the Standard General Conditions of Contract or jointly i.e., partly himself and remaining through subcontractor, with prior approval of Chief Engineer in writing. However, if required in tender documents by way of Special Conditions, a formal agreement duly notarised, legally enforceable in the court of law, shall be executed by the main contractor with the subcontractor for the component(s) of work proposed to be executed by the subcontractor(s), and shall be submitted along with the offer for considering subletting of that scope of work towards fulfilment of technical eligibility. Such subcontractor must fulfill technical eligibility criteria as follows: The subcontractor shall have successfully completed at least one work similar to work proposed for subcontract, costing not less than 35% value of work to be subletted, in last 5 years, ending last day of month previous to the one in which tender is invited through a works contract.
Defination of Similar Work :- Any Civil work other than track work.
28 conditions · 2 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Tenderer may please note that offers received without requisite/mandatory documents as mentioned above, will be considered as invalid tender and for which contractor shall have no claim on Railway.
The tenderer shall visit the site of work and acquaint himself/themselves with the conditions of work viz. approach roads and accessibility, availability of materials, electric power, water for work and drinking purposes, site for labour camps, stores, godowns, extent of lead/lift in work, availability of skilled and unskilled labour etc. that may be encountered in the course of execution of work. In short, he/they should familiarize himself/themselves fully with the all the conditions of the work site & all the financial implications due to the above conditions is deemed to be understood and taken care of while bidding the offer.
Construction of Road From Block 30 to 37 Laxmi Bai Nagar Railway Colony in the S/o SSE/W/HNZM under ADEN/E-III.
NIT-07-B-26-27-WE
NIT-07-B-26-27-WE
Open
Works - General
6 Months
Delhi, Delhi
₹0
₹2.3 L
19 Aug 2026
29 Jul 2026
5 Aug 2026
34 items across 1 schedule · ₹1,21,40,775.3 total
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| 1 | Disposal of moorum/building rubbish/ malba/ similar unserviceable, dismantled or waste material by mechanical transport including loading, transporting, unloading to approved municipal dumping ground for lead upto 10 km for all lifts, complete as per directions of Engineer-in-charge. | cum | 1556 | 411.3 | 6,39,982.8 |
| 2 | All kinds of soil | Sqm | 172 | 107 | 18,404 |
| 3 | All kinds of soil. | cum | 172 | 286.85 | 49,338.2 |
| 4 | Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift upto 1.5 m. | cum | 139 | 253.95 | 35,299.05 |
| 5 | 1:2:4 (1 Cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 40 mm nominal size derived from natural sources) | cum | 44 | 7,226.95 | 3,17,985.8 |
| 6 | 1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) | cum | 87 | 6,326.05 | 5,50,366.35 |
| 7 | Concrete of M20 grade with minimum cement content of 270 kg /cum | cum | 44 | 10,009.5 | 4,40,418 |
| 8 | 1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources) | cum | 36 | 7,945.65 | 2,86,043.4 |
| 9 | cum | 17 | 10,719.3 | 1,82,228.1 | |
| 10 | Suspended floors, roofs, landings, balconies and access platform | Sqm | 131 | 766.55 | 1,00,418.05 |
| 11 | Lintels, beams, plinth beams, girders, bressumers and cantilevers | Sqm | 77 | 608.35 | 46,842.95 |
| 12 | Thermo-Mechanically Treated bars of grade Fe- 500D or more. | Kg | 1384 | 89.65 | 1,24,075.6 |
| 13 | Cement mortar 1:4 (1 cement : 4 coarse sand) | cum | 36 | 6,882 | 2,47,752 |
| 14 | With F.P.S.(non modular) bricks | cum | 131 | 8,030.6 | 10,52,008.6 |
| 15 | 125 mm | Each | 433 | 60.05 | 26,001.65 |
| 16 | Hot finished seamless type tubes | Kg | 5187 | 168.95 | 8,76,343.65 |
| 17 | In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works | Kg | 4323 | 142.3 | 6,15,162.9 |
| 18 | 40 mm thick with 20 mm nominal size stone aggregate | Sqm | 1124 | 545 | 6,12,580 |
| 19 | 25 mm thick | Sqm | 208 | 1,706.6 | 3,54,972.8 |
| 20 | 110 mm bend | Each | 87 | 132 | 11,484 |
| 21 | 110 mm | Each | 87 | 309.5 | 26,926.5 |
| 22 | 1:4 (1 cement: 4 coarse sand) | Sqm | 2075 | 307.25 | 6,37,543.75 |
| 23 | Two coats | Sqm | 12968 | 90.05 | 11,67,768.4 |
| 24 | One or more coats on old work | Sqm | 3459 | 86.55 | 2,99,376.45 |
| 25 | Nominal concrete 1:4:8 or leaner mix (i/c equivalent design mix) | cum | 87 | 1,239.6 | 1,07,845.2 |
| 26 | For thickness of tiles 10 mm to 25 mm | Sqm | 866 | 60.5 | 52,393 |
| 27 | Taking out existing CC interlocking paver blocks from footpath/ central verge, including removal of rubbish etc., disposal of unserviceable material to the dumping ground, for which payment shall be made separately and stacking of serviceable material within 50 metre lead as per direction of Engineer-in-Charge. | Sqm | 773 | 108.65 | 83,986.45 |
| 28 | Laying old cement cocrete interlocking paver blocks of any design/ shape laid in required line, level, curvature, colour and pattern over and including 50 mm thick compacted bed of coarse sand, filling the joints with fine sand etc. all complete as per the direction of Engineer-in- charge. (Old CC paver blocks shall be supplied by the department free of cost). | Sqm | 773 | 362.3 | 2,80,057.9 |
| 29 | 80 mm thick C.C. paver block of M-30 grade with approved color design and pattern. | Sqm | 1611 | 1,011.2 | 16,29,043.2 |
| 30 | 300 mm dia. R.C.C. pipe | Metre | 951 | 902.05 | 8,57,849.55 |
| 31 | With common burnt clay F.P.S. (non modular) bricks of class designation 7.5 | Each | 15 | 11,886.45 | 1,78,296.75 |
| 32 | Rectangular shape 600x450 mm internal dimensions | Each | 36 | 1,255.25 | 45,189 |
| 33 | Circular shape 560 mm internal dia | Each | 25 | 1,882.2 | 47,055 |
| 34 | With common burnt clay F.P.S. (non modular) bricks of class designation 7.5 | Each | 25 | 5,589.45 | 1,39,736.25 |
| Schedule total | ₹1,21,40,775.3 | ||||
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
StandardTenderDocument2022R5.pdf Standard Tender Document 2022
ATTACHMENT
Specialinstructionstothetenderer.pdf
ATTACHMENT
GCC-2022withCSupto11.pdf
ATTACHMENT
StandardTenderDocument2022R5.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .