CA NO GE/AFJ-06/2024-25 PROVISION OF IRON GRILLS AND FLAMEPROOF LIGHTS FANS AND AIR CONDITIONERS WITH ASSOCIATED E/M FITTINGS AND FIXTURES AT CERTAIN LOCATION AT AF STN JAMMU JOB NO 23WG/CAP-03/2023-24

Amount

Cutting holes in brick wall in cement mortar or cement lime mortar and stone wall built in lime mortar depth of embedded poertion of holdfasts or lugs measured from the face of the jamb in to wall exc.half brick but n-exc one brick for inserting holdfasts and making good dismantled portion in cement mortar 1:3 or cement concrete 1:2:4 Type B-1 as required complete all as specified.

S&F Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings and hanging; also fastening and fixing complete complete allas specified. Note :Mortice lock shall be paid separately with welded with MS Black sheet or as a ground requirement.

S&F mild steel Framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work with extra only over framed and hung as gates, including pintle hinges, stops hand-made sliding bolts and ornamental and intricate design conforming to Fe.290.Gde-E-165 complate all as specified and directed.

S&F mild steel 4 levers Mortice lock, vertical type, size 100 mm with Forming mortice holes, including provision of mortice lock with including MS black sheet duly welded or any arrange to nut bolt Forming mortice holes, n exc. 50 cu cm for balusters, newels, rag-bolts, etc. and grouting with cement mortar 1:2 after balusters, etc. are fixed dircted by Engr- in Charge.

M&L for preparing new steel surfaces of any type description over 10 cm in width or girth and applying two coat of synthetic enamel paint a coat of red oxide primer complete all as specified.

M&L for point wiring concealed with for light/fan/Bell with FRLS cable 1.5 sqmm PVC insulated (red for phase and black for neutral) unsheathed, multi stranded copper conductor 1100 volt grade in and incl 20mm dia. stove enamelled steel conduit with all accessories and 1.50 sqmm green in colour PVC copper conductor cable for earth continuity connected to common earth dolly incl Steel box surface/ flush type with sheet for mounting fittings such as switches, sockets, fan regulators etc complete all as specified and directed for one light/fan /bell point controlled by one switch & making good to disturbed surface of wall etc

Supply and fix switch flame proof rotary type with termination box in LM6, 16A, single pole 250V complete all as directed

Supply and fix Flame proof switch socket & plug combined in LM6 cable termination box in LM6, 25A, 250 V, 2p+earth complete all as directed

S & F MCB Distribution box, Double door Single pole & neutral 240 Volt, 8 way, type With 200 Amps bus bar complete all as specified and directed.

Supply and fixing amp rating 240V, 10KA 'C' curve miniature circuit breaker (MCB) of SPN 40 to 63 AMP following poles and current carrying capacity in the MCB DB complete with connection testing and commissioning all as specified and directed.

Supply and fixing amp rating 240V, 10KA 'C' curve miniature circuit breaker (MCB) of SP 5 To 20 AMP following poles and current carrying capacity in the MCB DB complete with connection testing and commissioning all as specified and directed.

M & L for sub main wiring with two single core FRLS, PVC insulated, stranded, unsheathed cable copper conductor with size 2X4 Sqmm and drawing through & incl stove enamelled steel conduit concealed in wall including earth continuity conductor of size 04 Sqmm PVC insulated unsheathed stranded copper conductor cable and connected to earth dolly to be drawn in concealed steel conduit including connecting to main board complete all as specified and directed by Engineer-in-Charge. Note:- Three runs of 4 sqmm copper wire & one run of steel conduit shall be considered one unit length.

Supply and install hi wall split units indoor/outdoor complete with cordless remote control unit and with in built air ioniser and Plasma filter for better indoor air quality with minimum 5 star rating and EER 3.2.of capacity 1.5 Ton complete with all connected acessories all as specified and directed by Engr-in-charge.

Single pole and neutral enclosure with a two pin and earth plug and socket complete with one single pole MCB 20Amp complete all as specified and directed.

Supply and fixing automatic voltage stabilizer , single phase, copper wound, with volt meter with electronic relays suitable for correction on single phase , designed for input variation between 90 V to 250 V with output voltage stabilized at 230 V with accuracy ± 2.5% of capacity 5 KVA including making electrical connections with flexiable copper wire 3 core complete, all as specified.

Supply and laying or fixing or passing through pipe, 1100 volts grade heavy duty cable with PVC insulated aluminium conductor served with an inner sheathing of PVC tape armoured with galvanised steel wire or tape and overall PVC sheathed 4 sq. mm nominal cross section in service connections complete all as specified and directed by Engr-in-charge.

Supply and fixing wiring for circuit/submain wiring alongwith earth wire with the following sizes of FRSH is PVC insulated copper conductor, single core cable in concealed including stove enamelled steel conduit as required 2x6.0 sq. mm with 1x6.0 sq. mm earth wire complete all as specified and directed by Engr-in-charge.

Supply and fixing LED 2 x16 watt flameproof type FLP-WP made of aluminium alloy LM6 with electronic ballst, bipin holders, connector block, etc complete with all accessories prewired and including cooneecting up with twin core twisted flexible copper conductor cable of 1.5 sqmm, single core all as directed.

Supply and fixing flame proof Ceiling fan SP 230V, 1200 mm sweep completes including all connected accessories all as directed and specified.

Supply and fixing flame proof Regulator for Ceiling fan SP 230V, completes including all connected accessories all as directed and specified.

Supply and fixing flame proof Heavy duty exhaust fan made of steel body complete with louvers shutter, voltage 230V, 50 Hz, RPM 1200, Copper winding of sweep 380mm complete including all connected accessories all as directed and specified.

Supply,installation,testing and commissioning of Flame Proof AC with pannel , hi wall split unit indoor/outdoor complete with cordless remote control unit and with in built air ioniser and plasma filter for better in door air quality with 5 star and EER 3.2 of capacity 1.5 ton, Operating voltage @50 Hz including necessary connection, MS Powder Coated compressor ,( Flameproof Instrumentation), Compressor Type – Reciprocating motor, Refrigerant– R134a, Flameproof approved, Cooling control–Flp Temperaturecontroller with Flp RTD on indoor unit Control Panel – Flameproof Typecomplete, Indoor unit & Outdoor Unit MOC - MS Powder coated all as specified and directed by Engr-in-charge.

Supply and fixing automatic flame proof voltage stabilizer , single phase, copper wound, with volt meter with electronic relays suitable for correction on single phase , designed for input variation between 90 V to 250 V with output voltage stabilized at 230 V with accuracy ± 2.5% of capacity 5 KVA including making electrical connections with flexiable copper wire 3 core complete all as specified and directed by Engr-in-charge..

SCHEDULE 'A' PART-II (Schedule of credit) Credit amount of Rs (Refer schedule of credit) for retrieved material mentioned in Sch 'A' Part-II of Tender documents in PDF form will be deducted offline during acceptance of tender of lowest bidder.

Harsh Electricals

L-7 Primewave Communications

G M ENGINEERING SERVICES