SPL REPAIR REPLACEMENT OF STREET LIGHT POLE INCLUDING NECESSARY ITEMS UG CABLES FP PANEL AT MH DANAPUR AND PROVN OF ELECTRIC CONNECTION FOR UPS ROOM ALONG WITH CONNECTED WORK AT CDA PATNA UNDER GE DANAPUR

Amount

Dismantling of OH ACSR conductor of any size and removing unserviceable conductor from site complete all as specified & directed.

Dismantling of LT insulators any type or size complete all as specified & directed.

Dismantling of cross arms of MS channels or angle, section etc complete and setting aside for reuse complete all as specified & directed.

Excavation in trenches, in any type of soil not exceeding 1.5m wide and not exceeding 1.5m in depth for foundation, etc or not exceeding 10 Sqm on plan and not exceeding 1.5m in depth for shafts, cesspits, manholes, pier holes, etc and getting out in any type of soil complete all as specified and directed.

Removing excavated soil to a distance not exceeding 50m and depositing where directed at a level not exceeding 1.5m above the starting point complete all as specified and directed.

Returning, filling in excavated approved soil, including spreading, leveling, watering and well ramming in layers not exceeding 25cm each complete all as specified and directed.

M & L in repair for dry sand cushioning to underground cables with 8cm thick before laying of cables and 15cm thick after laying and stretching of cable complete all as specified and directed. Note: Thickness of sand shall be measured after punned as 18 mm only.

M & L for Old size sub class ‘B’ bricks, laid in trenches for cable protection complete all as specified and directed.

M & L for plain cement concrete 1:3:6 type C-2 using 40mm graded stone aggregate as in foundations, filling and mass concrete complete all as specified and directed.

M & L for plain cement concrete 1:4:8 type D-2 using 40mm graded stone aggregate as in foundations, filling and mass concrete complete all as specified & as directed.

Taking out of pressed precast concrete interlocking paver block any shape and size and refixing of same over 50mm thick sand cushioning filling under floors or in foundations including watering and consolidation complete all as specified & directed.

M & L for horizontal boring mechanically across the existing road without disturbing the road surface for inserting 80/40 mm bore GI pipe complete all as specified and directed.

Supply, laying, jointing & testing in trenches or passing through pipe, 1100 volts grade, XLPE insulated, screened, PVC bedded, galvanized steel strip or wire armoured LT electric power under ground cables, heavy duty with aluminium conductor of cross sectional area 25 sqmm 4.0 core with all fixing & connecting accessories such as Alluminium cable lugs, cable gland, nut, bolts, washer etc complete as specified and as directed. (NOTE: Earthwork & Excavation, GI pipe brick protection etc shall be measured and paid separately under relevant items of this BoQ).

All as per item No. 13 above but cross sectional area 10 Sqmm 4 core

All as per item No. 13 above but cross sectional area 10 Sqmm 2 core

Supply and fixing of GI tubing, Light grade, 40 mm bore with all fitting laid in trenches / pole / wall for protection of earth conductor complete all as specified and directed .

Supply and erecting steel tubular swaged poles complete with cast iron base plate, finial taper plug bolts, nuts and screw as specified, type 410 SP-31, 9.0 Metre long including painting all external exposed steel surfaces with two coats of aluminium paint over a coat of red oxide zinc chrome primer and all internal surfaces & external surfaces in contract with concrete with two coats of black bituminous paint and painting of bottom portion of the pole upto 0.75m from top of the copping with two coat of synthetic enamel paint over a coat of red oxide primer and writing pole no with synthetic enamel white paint on black colour circle of suitable size complete all as specified and as directed. (Note: Excavation & Earth work and PCC foundation/base shall be measured and paid separately under relevant items of this BoQ ).

M & L for cross arms, bracing clamps and back plates fabricated from structural steel section including nuts, bolts, washers etc, drilling hole for bolts in any shape or size complete with welding, binding, two coats of aluminium paint over a coat of primer for fixing flood lights complete all as specified and directed.

Material and labour for earthing complete with galvanised steel plate electrodes of size 600x600x6mm thick burried directly in ground with earth pit not less than 2.25 meter deep below normal ground level with top edge of plate not less than 1.5 meter below normal ground level connected to galvanised 32x 6 mm earth strip by means of nuts bolts check nuts GI washers earth wire protected by galvanised iron pipe 40 mm bore (Medium grade) for LT panel/FPB complete all as directed including concrete pit in PCC (1:3:6) type C1, precast RCC cover slab of size 30x30x10 cm with one handle for lifting made out of 8 mm diameter MS bar finnel wire mesh 20 mm bore galvanised iron pipe (medium grade) for watering charcoal or coke and salt in alternate layers necessary earth work in soft/loose soil complete all as shown in electrical plate No 5 of SSR Part I including testing on completion all as specified and directed.

Supply and fixing LED street light luminaires 60 Watts 230V AC outdoor type IP 65/66 type with multiple optics lens incl standard fittings pressure die cast aluminium housing with heat reistant toughened front glass housing with epoxy powder coated finsh and complete with control gear box and all accessories duly prewired and connecting to junction box and testing including GI bracket 40mm dia 0.90m long welded/bent to shape complete all as specified and directed.

Supply and fixing LED street light luminaires 70 Watts 230V AC outdoor type IP 65/66 type with multiple optics lens incl standard fittings pressure die cast aluminium housing with heat reistant toughened front glass housing with epoxy powder coated finish and complete with control gear box and all accessories duly prewired and connecting to junction box and testing including GI bracket 40mm dia 0.90m long welded/bent to shape complete all as specified and directed.

Supply and fixing pole mounted junction box/bus bar chamber for loop connection of street light cable of size 295x195x100 mm with 63 amps aluminium busbar wrapped with PVC sleeves and maintained the colour code and provision of making holes with GI nuts, bolts & washers for connections and mounted on hydrograpic insulators with nuts & bolts at both ends of busbar and suitable arrangement for fixing one/two No MCB complete all as specified and as directed. Make: Sintex ,/Hensel/Rittel.

S&F MCB, Single pole, 6 amps, 240 volts, ‘C’ curve, 10 KA complete as specified and directed.

M&L for one run of 1.5 Sqmm 3 Core (Nominal Area) PVC Sheathed multi stranded unarmered copper conductor cable LT 1100 volt grade Conforming to IS 7098 FRLS (inner sheet) from pole junction box to light fitting with suitable size copper cable lugs and connector and the wire will pass inside the pole by making hole 2 Nos on top and bottom near junction box complete all as specified and directed.

Supply, erection, testing and commissioning KIOSK outdoor type LT feeder pillar box of minimum size 900mm(height) x 600mm (breath) x 500mm (depth) platform mounted, suitable for 3 phase 4 wire, 500 volts AC supply and having 4 Nos copper bus bar for distribution system and type tested at CPRI fabricated .The feeder pillar shall be made out of 3.00mm thick CRCA mild steel sheet and 3.00mm thick gland plate duly compartmentalized for each control gear and bus-bar, double door front door (02 layer) and rear Door (01 layer) opening facility and 4 side slanting canopy type roof on top and mild steel angle iron legs of minimum size angle iron 40x40x5 mm . The feeder pillar shall be provided with ventilation facility in the form of louvers for better heat dissipation. The feeder pillar shall be provided with suitable Neoprene rubber gasket to make it completely dust and vermin proof and degree of protection not less than IP-55 and general construction conforming to IS : 13947 and including complete internal wiring with 2.5 sqmm copper wire and copper strip/wire from busbar to MCB input and MCB to cable connector of suitable length including PCC (1:3:6) type C-2 as in foundation of suitable size (30 cm below ground level & 30 cm above ground level) including necessary excavation and earth work complete all as specified and as directed alongwith comprising of the following accessories :- NOTE: Rate of earthwork and PCC are deemed to be inclusive in this item.embedded in PCC foundation of size as required and plastering the same in cement mortar 1:6 finished even and smooth without using extra cement complete all as specified and as directed comprising of the following fitment accessories : (LT Panel for Street light)

BUS BARS AND INTERNAL CONNECTIONS :The bus bars shall be made of Copper strip ,200 Amps rated of minimum length 450 mm wrapped with PVC sleeves and maintained the colour code and provision of making holes with copper nuts, bolts & washers for connections and mounted on hydrograpic insulators with nuts & bolts at both ends of busbar - 04 Nos

INCOMING : (a) MCCB 4 pole 415 volts 50 Hz adjustable thermal magnetic release of rating 63 Amps having breaking capacity 25 KA - 01 No .

(d) LED Pilot Lamp (for Incomers) suitable for 230/240 Volts AC supply complete with integral circuit & cluster LED of following colours : (i) RED - 01 No, YELLOW - 01 No, BLUE - 01 No.

(e) Multifunctional Digial type timer Switch (Astro type having longitude and latitude of Indian cities memory) 240 volts AC Single Phase - 01 No

(f) Power contractor 4 Pole, 40 Amps, 415 Volts, 50 Hz - 01 No

OUTGOINGS :

(a) MCB TPN of rating 32 Amps having breaking capacity 10 KA - 03 Nos

(b) MCB SPN of rating 25 Amps having breaking capacity 10 KA - 02 Nos

(c) Enamelled iron danger notice plate of 1.60 mm thick mild steel sheet of size 200 mm X 150mm, white with letters, figures and conventional skull and bones in signal red and fixed with nuts and bolts on door / shutter of JB for LT -01 No.

Supply,fabrication, installation and testing of LT Panel out door type factory made CPRI Approved, water and vermin proof protection of suitable size made out of 3.15 mm thick CRCA sheet dully supported with mild steel angle iron of size 40 x 40 x 5 mm vertical frame and legs with mild steel flat iron 40 x 40 x 5 mm in horizontal sides of the frame with front and back side openable,single hinged door / shutter with locking arrengement and powder coated finish both internal and external steel surfaces after necessary preparation of steel surfaces including providing PCC (1:3:6) type C2 foundation of suitable size and connections of all outgoing / incomming cable inclusive of necessary excavation and earthwork as required including the following fitment accessories and also including removing old exisisting one complete all as specified and as directed. Note: Rate of earthwork and PCC work are deemed to be inclusive in this item.

INCOMMING

4 Pole MCCB 400 Amps , adjustable thermal magnetic release type, 415 Volts, Ics = 100% Icu, 36 KA breaking capacity including all fixing accessories with both ends spreader links -01Nos

LED Neon indicator lamp (RYB) with holder and fuse holder 230/250 volts, AC -01 set (set of three)

OUTGOING

Copper strip busbar of 600 amps rated capaacity wrapped with PVC sleeves with maintained the colour code and provision of making holes with Copper nuts, bolts & washers for cable connections including hydrograpic insulators with nuts & bolts at both ends = 04 Nos

4 Pole MCCB 63 Amps , adjustable thermal magnetic release type, 4 poles, 415 Volts, Ics = 100% Icu, 16 KA breaking capacity including all fixing accessories with both ends spreader links -10 Nos (One for each UPS and one spare)

LED Neon indicator lamp (RYB) with holder and fuse holder 230/250 volts, AC -10 set (set of three)

Enamelled iron danger notice plate of 1.60 mm thick mild steel sheet of size 200 mm X 150mm, white with letters, figures and conventional skull and bones in signal red and fixed with nuts and bolts on door / shutter of JB for LT -01 No.

Supply and fixing double door SPN MCB DB four way 415 V for TPN one nos, powder coated DB's suitable for MCB's fitted with bus bar,Neutral link,Earth bar and Din rail as per existing finishing complete all as specified and directed .

Supply and fixing MCB TPN 50 to 63 amps 10 KA ,C-series including connection with suitable size aluminium / copper lugs complete all as specified and directed .

M&L for Sub main wiring PVC insulated PVC unsheathed electric FRLS cable 1100V grade single core having multi stranded copper conductor three phase of size 16.0 Sqmm nominal cross sectional area ( for R,Y,B & N) & including non metallic rigid PVC conduit ISI marked medium grade with all conduit accessories in concealed wiring system by cutting/chesing of wall and making good disturbed surface of wall with cement mortar and existing colour painting after fixing of conduit & 16.0 sqmm green PVC insulated unsheathed copper conductor as a earth wire connected to earth dolly by providing lugs complete all as specified and as directed. (Note : wiring with 4 X 16.0 sqmm run +1 X 16.0 sqmm run with proper colour code as per IE rules measured in one unit )

Supply, laying, jointing & testing cable XLPE insulated, screened, PVC bedded, galvanized steel strip or wire armoured, electric power cables (heavy duty) with stranded aluminium conductor, 3.5 core, 300 Sqmm 1100 volts grade, of following sizes complete all as specified and directed.

Supply and fixing of Earthing to panel with galvanised steel earth plate electrode 60cm x 60cm x 6mm thick, buried directly in ground (earth pit not less than 2.25m below normal ground level) with top edge of earth plate not less than 1.5m below normal ground level connected to galvanised earth lead wire 4.0mm dia by means of bolts, nut, check nuts and washers of galvanized iron or steel all as shown in electrical plate No.3 of MES Schedule pt-I 2009, GI earth lead strip protected by GI pipe 40 mm dia light grade and connected to earth test point including excavation in any type of soil,returning filling, disposal of soil, providing charcoal dust and common salt up to top edge of earth plate, construction of PCC pit with RCC cover, funnel, watering pipe of 20mm dia GI light grade and provision of earth test point including testing on completion complete all as specified and directed.

CP RAJ (BID ID -3332397)

VAISHNAVI CONSTRUCTION (BID ID -3333112)

PAPPU ROY CONSTRUCTION (BID ID -3335768)

M/S SHEO KUMAR SINGH AND SONS (BID ID -3334423)

M/S MODERN CONSTRUCTION (BID ID -3333105)

M/S NANDA CONSTRUCTION (BID ID -3335805)