Providing, fabricating and fixing barricading including gate work with structural steel framework covered with pre-coated GI profile sheet at MEA resi

BILL OF QUANTITIES

RE-DEVELOPMENT OF MEA HOUSING COMPLEX AT KG MARG, NEW DELHI

PROVIDING, FABRICATING AND FIXING BARRICADING INCLUDING GATE WORK

WITH STRUCTURAL STEEL FRAMEWORK COVERED WITH PRE-COATED GI

PROFILE SHEET AT MEA RESIDENTIAL COMPLEX, KG MARG, NEW DELHI

LENGTH OF 12M HEIGHT BARRICADING WORKS: 430.48 RUNNING METERS

S.No. DESCRIPTION OF ITEM AMOUNT

1 EARTH WORKS 287199.09

2 CONCRETE WORKS 564530.17

3 RCC WORKS 4411681.35

4 BRICK WORKS 1089669.13

5 STEEL WORKS 12180129.28

6 SHEETING WORKS 4057523.82

7 PILE WORKS 1833937.308

8 SIGNANGE BOARDS 1603772.486

9 ELECTRICAL WORKS 2352482.928

Digitally signed by

DEVENDRA DEVENDRA SINGH

SINGH RAJPOOT RAJPOOT

BILL OF QUANTITIES

RE-DEVELOPMENT OF MEA HOUSING COMPLEX AT KG MARG, NEW DELHI

PROVIDING, FABRICATING AND FIXING BARRICADING INCLUDING GATE WORK WITH STRUCTURAL STEEL FRAMEWORK COVERED WITH

PRE-COATED GI PROFILE SHEET AT MEA RESIDENTIAL COMPLEX, KG MARG, NEW DELHI

LENGTH OF 12M HEIGHT BARRICADING WORKS: 430.48 METRES

S.NO. DSR 2021 DESCRIPTION OF ITEM UNIT Y RATE DSR 2021 RATE NON DSR AMOUNT

SUB HEAD - I EARTH WORKS

Earth work in excavation by mechanical means

(Hydraulic excavator)/manual means over areas

(exceeding 30 cm in depth, 1.5 m in width as well as

10 sqm on plan) including getting out and disposal

of excavated earth lead upto 50 m and lift upto 1.5

m, as directed by Engineer-in-charge.

Filling available excavated earth (excluding rock) in

trenches, plinth, sides of foundations etc. in layers

2 2.25 not exceeding 20cm in depth, consolidating each CUM 400.00 270.03 108010.01

deposited layer by ramming and watering, lead up

to 50 m and lift upto 1.5 m.

Surface dressing of the ground including removing

vegetation and inequalitiesnot exceeding 15 cm

deep and disposal of rubbish, lead up to 50 m and

lift up to 1.5 m.

Clearing jungle including uprooting of rank

vegetation, grass, brush wood, trees and saplings of

4 2.31 girth up to 30 cm measured at a height of 1 m above SQM 1291.00 15.42 19904.44

ground level and removal of rubbish up to a distance

of 50 m outside the periphery of the area cleared.

TOTAL 287199.09

SUBHEAD - II CONCRETE WORKS

Providing and laying in position cement concrete of

4.1 specified grade excluding the cost of centering and

shuttering - All work up to plinth level

1:4:8 (1 Cement : 4 coarse sand (zone-III) : 8 graded

stone aggregate 40 mm nominal size)

TOTAL 564530.17

Digitally signed by

DEVENDRA DEVENDRA SINGH

SINGH RAJPOOT RAJPOOT

SUBHEAD - III RCC WORKS

Providing and laying in position specified grade of

reinforced cement concrete, excluding the cost of

centering, shuttering, finishing and reinforcement -

All work up to plinth level

1:1.5:3 (1 cement : 1.5 coarse sand (zone-III): 3

graded stone aggregate 20 mm nominal size).

Providing and laying in position ready mixed or site

batched design mix cement concrete for reinforced

cement concrete work; using coarse aggregate and

fine aggregate derived from natural sources,

Portland Pozzolana / Ordinary Portland /Portland

Slag cement, admixtures in recommended

proportions as per IS: 9103 to accelerate / retard

setting of concrete, to improve durability and

workability without impairing strength; including

pumping of concrete to site of laying, curing,

carriage for all leads; but excluding the cost of

centering, shuttering, finishing and reinforcement as

per direction of the engineer-in-charge; for the

following grades of concrete. Note: Extra cement up

to 10% of the minimum specified cement content in

design mix shall be payable separately. In case the

cement content in design mix is more than 1.10

times of the specified minimum cement content, the

contractor shall have discretion to either re-design

the mix or bear the cost of extra cement.

5.33.1 All works upto plinth level

Concrete of M25 grade with minimum cement

content of 330 kg /cum

Add for using extra cement in the items of design

8 5.35 mix over and above the specified cement content 83 732.03 60758.40

Centering and shuttering including strutting,

propping etc. and removal of form for all heights :

Foundations, footings, bases of columns, etc. for

For Lintels, beams, plinth beams, girders,

bressumers and cantilevers

Steel reinforcement for R.C.C. work including

5.22 straightening, cutting, bending, placing in position

and binding all complete upto plinth level.

Thermo-Mechanically Treated bars of grade Fe-

SUBHEAD - IV BRICK WORKS

Brick work with common burnt clay F.P.S. (non

modular) bricks of Class designation 7.5 in

superstructure above plinth level up to floor V level

in all shapes and sizes in :

12 6.4.2 Cement mortar 1:6 (1 cement : 6 coarse sand) CUM 98.02 8813.00 863853.12

Providing and Applying 18 mm cement plaster in

two coats under layer 12 mm thick cement plaster

13 13.11 1:5 (1 cement : 5 coarse sand) finished with a top SQM 393.03 470.78 185028.29

layer 6 mm thick cement plaster 1:6 (1 cement : 6

Providing and Finishing walls with water proofing

cement paint of required shade on New work (Two

14 13.44.1 or more coats applied @ 3.84 kg/10 sqm) etc. SQM 393.03 103.78 40787.72

complete and as per satisfaction of Engineer-In-

Digitally signed by

DEVENDRA DEVENDRA SINGH

SINGH RAJPOOT RAJPOOT

SUBHEAD - V STEEL WORKS

Steel Works for Trusses of Barricading, Gates,

Frames, Hinges, Supports, all works complete

Steel work in built up tubular (round, square or

rectangular hollow tubes etc.) trusses etc., including

cutting, hoisting, fixing in position and applying a

priming coat of approved steel primer, including

welding and bolted with special shaped washers etc.

15 10.16.3 Electric resistance or induction butt welded tubes KG 80169.80 149.77 12006694.90

Painting with synthetic enamel paint of approved

brand and manufacture to give an even shade

16 13.61.1 Two or more coats on new work SQM 1236.81 139.77 172869.77

Providing and fixing mild steel round holding down

bolts with nuts and washer plates complete.

SUBHEAD - VI SHEETING WORKS

Providing and fixing precoated galvanised iron

profile sheets (size, shape and pitch of corrugation

as approved by Engineer-incharge) 0.50 mm (+ 0.05

%) total coated thickness with zinc coating 120

grams per sqm as per IS: 277, in 240 mpa steel

grade, 5-7 microns epoxy primer on both side of the

sheet and polyester top coat 15-18 microns. Sheet

should have protective guard film of 25 microns

minimum to avoid scratches during transportation

18 12.50 and should be supplied in single length upto 12 SQM 5682.34 714.06 4057523.82

metre or as desired by Engineerin- charge. The sheet

shall be fixed using self drilling /self tapping screws

of size (5.5x 55 mm) with EPDM seal, complete upto

any pitch in horizontal/ vertical or curved surfaces,

excluding the cost of purlins, rafters and trusses and

including cutting to size and shape wherever

SUBHEAD - VII PILE WORKS

Boring, providing and installation bored cast-in-situ

reinforced cement concrete piles of grade M-25 of

specified diameter and length below the pile cap, to

carry a safe working load not less than specified,

excluding the cost of steel reinforcement but

including the cost of boring with bentonite solution

and temporary casing of appropriate length for

setting out and removal of same and the length of

20.2 the pile to be embedded in the pile cap etc. by

percussion drilling using Direct mud circulation

(DMC) or Bailer and chisel technique by tripod and

mechanical Winch Machine all complete, including

removal of excavated earth with all its lifts and leads

(length of pile for payment shall be measured up to

bottom of pile cap). Note: Truck Mounted

rotary/TMR/Tubewell boring machine shall not be

Digitally signed by

DEVENDRA DEVENDRA SINGH

SINGH RAJPOOT RAJPOOT

SUBHEAD - VIII SIGNAGE BOARDS

Providing, Fabricating, Installing &Commissioning of

Back Lit Signage Boards including fascia, signage

cabinet, electrical fitting, fixture & required

structural steel work including cutting, hoisting,

fixing in position and applying a priming quote of

approved steel primer all complete, with back

support of GI sheet and 3 MM sunboard neatly

pasting on GI sheet, complete filling of module in

box, complete with rain proof power supply to

support various internal components of signage

20 NDSR-1 board etc. over the structural steel framework ; all SQM 100.00 11060.50 1106049.99

complete as per detailed specifications, design &

instructions of Engineerin- charge. (The area of

Board excluding outer borders only will be

measured for payment) The works also include costs

of cladding with 25mm SHS steel members. The size

of the hoardings shall be decided by the Engineer in

Charge as per Site conditions and requirements.

Providing, Fabricating, Installing & Commissioning of

Front Lit Signage Boards including fascia, signage

cabinet, electrical fitting, fixture & required

structural steel work reveted bolted or welded in

builtup sections, and framed work, including cutting,

hoisting, fixing in position and applying a priming

quote of approved steel primer all complete, with

installation 3 MM ACP, neatly pasted Eco Solvent

with matt or gloss lamination,

frame to support various internal components of

signage board etc. over barricading work all

21 NDSR-2 complete as per detailed specifications, design &

instructions of Engineer-in-charge. Structural steel

work of barricading upto its connection & support of

complete signage board is exclusive of this item

which shall be provided by NBCC. The works also

include costs of cladding with 25mm SHS steel

members. The size of the hoardings shall be decided

by the Engineer in Charge as per Site conditions and

A With vinyl fascia SQM 75.00 6636.30 497722.50

GRAND TOTAL 26028442.63

GRAND TOTAL 26028442.63

Digitally signed by

DEVENDRA DEVENDRA SINGH

SINGH RAJPOOT RAJPOOT

S.NO. DSR 2021 DESCRIPTION OF ITEM UNIT QUANTITY RATE DSR 2022 RATE NON DSR AMOUNT

Wiring for light/ power plug with 2X4 sq. mm FRLS

PVC insulated copper conductor single core cable in

surface/ recessed medium class PVC conduit

alongwith 1 No. 4 sq. mm FRLS PVC insulated

copper conductor single core cable for loop earthing

Wiring for circuit/ submain wiring alongwith earth

wire with the following sizes of FRLS PVC insulated

copper conductor, single core cable in surface/

recessed steel conduit as required.

Supplying and fixing following way, single pole and

neutral, sheet steel, MCB distribution board, 240 V,

on surface/ recess, complete with tinned copper bus

2.3 bar, neutral bus bar, earth bar, din bar, 0.00

interconnections, powder painted including

earthing etc. as required. (But without MCB/

Supplying and fixing following rating, double pole,

(single phase and neutral), 240 volts, residual

current circuit breaker (RCCB), having a sensitivity

current upto 300 milliamperes in the existing MCB

DB complete with connections, testing and

commissioning etc. as required.

Supplying and fixing following rating, double pole,

240 V, isolator in the existing MCB DB complete

with connections, testing and commissioning etc. as

Supplying and fixing 5 amps to 32 amps rating,

240/415 volts, “C” curve, miniature circuit breaker

2.10 suitable for inductive load of following poles in the 0.00

existing MCB DB complete with connections, testing

and commissioning etc. as required.

Installation, testing and commissioning of pre-

wired, fluorescent fitting / compact fluorescent

fitting of all types, complete with all accessories and

28 1.41 tube etc. directly on ceiling/ wall, including EACH 15.00 219.04 3285.60

connection with 1.5 sq. mm FRLS PVC insulated,

copper conductor, single core cable and earthing

etc. as required.

Earthing with G.I. earth pipe 4.5 metre long, 40 mm

dia including accessories, and providing masonry

29 5.2 enclosure with cover plate having locking EACH 5.00 7288.92 36444.61

arrangement and watering pipe etc. with charcoal/

coke and salt as required.

Providing and fixing 6 SWG dia G.I. wire on surface

or in recess for loop earthing along with existing

surface/ recessed conduit/ submain wiring/ cable as

Supply and installation of 70W LED flood light

fixture suitable for Surface / Wall type mounting

with Epox y powder coated die - cast aluminium

housing with heat Sink, toughened glass, complete

with inbuilt electronics driver, mounting bracket,

min. 90 Lumen /watt efficacy, min 7000 Lumen

output, THD<10%, P.F. >0.95, IP 65 rated as

Supply, Installation Testing & Commissioning of

Flexible 12W LED Strip Light (IP-65) with double

32 NS-4 tape on backside suitable for Mounting in cove with METRE 320.00 2878.20 921023.04

all accessories including connections etc as required.

Wattage 12 Watt / Meter.

Supply, Installation Testing & Commissioning of 220

Watt (IP-20) external LED driver in suitable weather

proof enclosure for flexible LED Strip light

complete including connection etc as required.

Digitally signed by

DEVENDRA DEVENDRA SINGH

SINGH RAJPOOT RAJPOOT