Providing MS grill for openings and windows in 2nd and 3rd floor and Teak wood door for entrance of Water Resources and Ocean Engineering Department in NITK.

Amount

M S grill : Providing and fixing M.S. grills of required pattern in frames of windows etc. with M.S. flats, square or round bars etc. including priming coat with approved steel primer all complete. Fixed to steel windows by welding

Synthetic enamel paint in two coats: Painting with synthetic enamel paint of approved brand and manufacture to give an even shade :Two coats on new work after thoroughly brooming the surface to remove all dirt, dust, mortar drops and foreign matter including preparing the surface even and sand paper smooth, cost of materials, labour complete as per specifications and as per directions of Engineer-in-charge.

Dismantling Collapsible gate: Dismantling Collapsible gate, removing and transporting the debris with all lead and lift; and stacking the dismantled serviceable materials available for re-use in the departmental store with all fittings and fixtures as directed including transportation charges etc complete

Teak wood door frames: Providing Teak wood frames of doors, windows, clerestory windows, ventilators and other frames, wrought, framed or assembled including making plaster groves but including cost of materials, labour, usage charges complete as per specifications.

Teak wood for Fully panelled door shutters: Providing and fixing in position fully panelled Teak wood shutters for doors with , stiles and rails of 35mm. thick with bottom and lock rails 180mm wide top rail and stiles 100mm wide as per drawing and panels of 25mm thick including cost of materials, labour, usage charges complete as per Specifications. (excluding cost of fixtures)

Melamine Polish for Teak wood surfaces:Polishing in high gloss/matt finish melamine clear polish on wood work in required color /wooden shade texture with following process in the sequence as detailed below: (1). The surface to be polished is rubbed with sand paper 80/120 no. and then with sand paper of 160/180 nos. (2). Applying two coats of sealer with spray gun and allowing sufficient drying time for 1st coat and 2nd coat is allowed to dry for 8 to 12 hrs.( 3) On drying of sealer coat, wet rubbing with emery cloth of finer grading with ample water to remove excess sealer layer and make the surface further smooth after this wet rubbing, then surface is applied with special grade melamine fillers to fill all the small and big holes/grooves etc. Filler coat to be allowed to dry for 4 to 6 hrs on which again a light wet rubbing is done this surface is further allowed to dry for 12 hrs. 4. On this, 1st coat of melamine polish is applied with spray gun using melamine clear polish and melamine thinner in required proportion. This 1st coat is allowed to dry for 24 hrs then this dry surface is again fine wet rubbed smooth, which is further allowed to dry for 12 hrs. The final melamine polish is applied with compressor pressure spray gun using melamine clear polish and melamine thinner mixed in required proportion complete as per direction of Engineer-in-Charge. (Final coat to be done in 2 layers without gap of time.)

Butt Hinges of size 125x85x5.5mm : Providing and fixing bright finished brass butt hinges with necessary screws etc. complete :125x85x5.5 mm (heavy type)

Brass Handle: Providing and fixing bright finished brass handles with screws etc. complete: Brass handles 125 mm with plate 175x32 mm

Brass Tower bolts: Providing and fixing bright finished brass tower bolts (barrel type) with necessary screws etc. complete : 250x10mm

Brass Mortice latch wooden door: Providing and fixing chromium plated brass 100 mm mortice latch and lock with 6 levers and a pair of lever handles of approved quality with necessary screws etc. complete.

Brass door stopper: Providing and fixing 150 mm bright finished floor brass door stopper with rubber cushion, necessary brass screws etc. to suit shutter thickness complete

DSOUZA ELECTRICALS