PROVN OF AERODROME BEACON LIGHT AT ATC OF AOP AREA UNDER GE NRC

Amount

Supply, Install, Test and Commissioning of FAA Approved Rotating Aerodrome Beacon Light with visibility 30 miles & meeting latest ICAO and CAR requirements. Beacon light shall be made of light weight aluminium enclosure fitted with heavy duty gear motor and two sealed beam 1000W lamps and standard tell-tale-circuit suitable for operation on 220V/240V, 50 Hz single phase AC power supply similar to model AB-1000F-220V-50Hz RPM : 12 , dimensions : 33' high 25" dia. Actual weight 70 lbs, Lamps : four sealed beam 1000W PAR 64, Beam width : 5 wide x 32 high, rated lamp life 4000 hours , power requirement : 117V AC,60 Hz 2250W , 19.2 Amps all as specified and directed.

Supply, fix, connect and test insulated armoured , PVC sheathed heavy duty electric cable with copper conductor 1100 volt grade laid in trenches passing through pipes/ducts including testing complete of cross section area 2.5 sqmm 6 core with suitable size of cable gland and cable lugs complete all as specified and directed.

Supply and fixing MS enclosure made out of CRCA sheet 3.00mm thick of size 450mm x 450mm x 250mm depth with three phase aluminium bus bar mounted on epoxy insulators, fixing arrangement with suitable MS Clamps for fixing of MCCB/control button of Beacon light.

Material and labour for Double Walled Corrugated DWC HDPE Pipe of outer dia 20mm and innter dia 16mm including 90 degree bends with coupler and rubber ring laid in trenches of size 20 mm suitable for cable protection complete all as specified and direct

Material and labour for earthing complete with copper earth plate electrode size 600x600x3.15 mm thick buried directly in ground vertically in a pit of depth not less than 2.25 mtr below ground levels with top edge of the earth plate not less than 1.5 mtr below normal ground level surrounded from all sides by mixture of charcoal and common salt and electrode connected to and including copper strip 20 x 3 mm dia by means of bolts, nuts, check nuts and washers of galvanized including GI protection pipe light grade 15mm dia connected to main earth wire on pole or control board and GI pipe light grade 20mm dia bore for watering funnel with wire mesh. CI cover with frame, PCC chamber pit with PCC 1:3:6 type C-2 excavation and earth work all as shown in electrical plate No 5 connected to earthing test point all as specified or indicated including testing on completion

S & F angle iron ,bracings,supports,clamps and back plate fabricated from structural steel sections including nuts ,bolts, in any shape or size as indicated or directed and inclusive of two coat of aluminium paint over a coat of red oxide for fixing of beacon light at top of ATC.

DURGAI ELECTRICALS

sapana enterprises

MAYUR ELECTRIC SERVICES

Bidder Name

MAYUR ELECTRIC SERVICES

sapana enterprises

Mukesh Enterprises

DURGAI ELECTRICALS