Repair and maint of compound wall fencing gate hardstanding drain culvert etc and other connected B and R works in the area of Army Avn Sqn at Sharifabad under AGE (I) CIF (K)

Amount

Demolition of brick work or stone masonry, built in cement mortar including all quoins, arches, pillars, etc but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified and directed.

M&L brick work with sub class 'B' bricks, straight or curved on plan exceeding 6 Mtr mean radius, built in cement mortar 1:6, complete all as specified and directed.

Descriptions all as per srl item No 2 herein above but except bricks

Taking down cement plaster on stone wall / brick wall etc including racking out of joints, hacking for key, scrubbing down with water etc, complete all as specified and directed.

M&L rendering 15mm thick in CM 1:4 on brick work or concrete surfaces, finished the surface even and smooth without using extra cement, complete all as specified and directed.

Demolition of reinforced cement concrete and paving exc 15cm thick above ground level (reinforcement cut as required to facilitate demolition), complete all as specified and directed.

M&L precast cement concrete louvers and jallies, 45mm thick (measured solid) type B-0, 1:2:4 (using 12.5mm graded crushed stone aggregate), set in cement mortar 1:4 including all mouldings and frame, complete all as specified and directed. NOTE :- Cost of precast frame shall be deemed to be included in the rate quoted.

M&L RCC (Nominal mix) 1:2:4, type B-1 (using 20mm graded crushed stone aggregates) as in tie beams, gable beams, cantilevers, bressummers, lintels over 1.5m clear span etc, complete all as specified and directed.

S&F TMT steel bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and directed.

Description all as per ser item No 9.00 here-in-above but 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders, complete all as specified and directed.

Formwork to rough finished surfaces of concrete of sides and soffits of floor or roof beams, beam haunching, girders, bressummers, lintels, cantilevers, shelves, including supports, overhanging etc, complete all as specified and directed.

M&L cement concrete 1:2:4, type B-1 (using 20mm graded crushed stone aggregate) as in copings, roof kerbs or mud stops, benching, haunching including necessary formwork, weathering/ slightly rounded or camfered angles, complete all as specified and directed.

Demolition of cement concrete in ground floor and paving not exc 15cm thick below or above ground level, complete all as specified and directed.

M&L PCC 1:4:8, type D-2 (using 40mm graded crushed stone aggregate) as in sub base of floors, hardstanding, manholes, drains etc, finished the surface even and fair, complete all as specified and directed.

M&L machine pressed precast coloured concrete interlocking paver blocks of any shape and size, confirming to IS-15658 : 2006 of 60mm thickness M-35 Grade, laid and jointed with grey cement and pigment, complete all as specified and directed. NOTE :- Sand bedding shall be measured and paid under srl item No 16.

M&L 20mm thick sand filling under floors or in foundations including watering and consolidation, complete all as specified and directed.

M&L 150mm thick PCC 1:2:4, type B-2 (using 40mm graded crushed stone aggregates) as in flooring, finished the surface even and smooth without using extra cement, complete all as specified and directed.

M&L forming 12mm thick expansion joints 150mm deep filled with preformed bituminious filler and top 30mm primed and sealed with sealing compound Grade 'A', complete all as specified and directed.

M&L forming contraction joints (Dummy joints) 65mm deep x 10mm wide and filled with sealing compound Grade 'B', complete all as specified and directed.

M&L forming construction joints 30mm deep x 10mm wide and filled with sealing compound Grade 'B', complete all as specified and directed.

Dismantiling of floor hearth or wall tiling including cement mortar bedding (but not backing), removing serviceable tiles to store and rubbish of the premises, complete all as specified and directed.

M&L chequered cement concrete tiles of size 20cm x 20cm x 25mm thick each, as in path, floors etc, set and jointed with grey cement and pigment, laid over and including 15mm thick screed bed or bedding layer in CM 1:6, complete all as specified and directed.

Dismantling posts or struts (wood, steel or RCC) of any section including taking out embedded portion in natural ground and making good disturbed surface, complete all as specified and directed.

Excavation in post holes (or similar holes) each not exc 0.50 Cum in hard / dense soil, getting out and removing the excavated material (soil) to a distance not exceeding 50 mtr above the starting point and deposited, complete all as specified and directed.

M&L PCC 1:3:6 type C-2 (using 40mm graded crushed stone aggregate) as in foundation, filling in and mass concrete etc., complete all as specified and directed.

M&L mild steel angle iron, flat iron work as in post or struts, drilling holes, notching for wire etc, cutting and twisting necessary drilling, bolting and riveting or welding, confirming to Fe-290- Gde E-165, complete all as specified and directed.

Supply only chain link fencing, weight not exc 4 Kg / Sqm, complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts etc including provision of binding wire, complete all as specified and directed.

S&F galvanized 2 strand steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails, straining bolts including securing or tying at cross with and provision of galvanized mild steel wire, staples or steel pins etc, complete all as specified and directed.

S&F mild steel screw bolts purpose made with hexagonal or square heads at one end and screwed the other, each screwed end to be fitted with washer and one hexagonal or square nut length of bolt exc 5cm but not exc 10cm, dia of neck 5-10mm, complete all as specified and directed.

M&L for mild steel round bars 8mm dia and over, cut to length, bent to shape required including cranking, bending for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and directed.

Demolition and breaking up drain pipes 300mm bore (SGSW, AC or reinforced), set in cement mortar, complete all as specified and directed.

M&L 300mm bore reinforced concrete pipes, Class NP3, laid in trenches and jointed in CM 1:1 and tested, complete all as specified and directed.

M&L concrete bed for 300mm bore drain pipe in PCC 1:3:6 type C-2 (using 40mm graded crushed stone aggregate) including packing under and haunching against the sides of pipes after they are laid and tested, complete all as specified and directed.

M&L preparation of new steel or iron surfaces of any description not otherwise described over 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer, complete all as specified and directed.

M&L preparation of new plastered surfaces of walls and applying two coats of cement base paint over a coat of alkali resistance primer, complete all as specified and directed.

Notes :- An amount of Rs. 34,185.00 on account of Credit Schedule for Schedule 'A' Part-II shall be deducted from total quoted amount of BOQ to arrive at the contract sum.

M/S M.S TANVEER ENTERPRISES (BID ID -3390569)

M/S SHIMAR STAR GLACIER (BID ID -3390457)

CLASSIC JK SUPPLIERS (BID ID -3398634)

M/S TAHAA BUILDERS (BID ID -3399312)

M/S Muzakir & Co. (BID ID -3398198)

M/S MAHIR MUNEER (BID ID -3398810)