Loading
Loading…
Loading…
Tender ID
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
Tender Value
₹60.1 L
EMD Value
₹1.2 L
Closing Date
3 Mar 2026, 3:00 pmClosed
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
WORKS
14 conditions · 3 needing a document upload
Financial Eligibility Criteria: The tenderer must have minimum average annual contractual turnover of V/N or 'V' whichever is less; where V= Advertised value of the tender in crores of Rupees. N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet. (For details refer tender documents)
Similar work : Execution of building work, with RCC framed structure or with load bearing steel structure.
30 conditions · 2 needing a document upload
Whether History sheet of tenderers (Annexure-2 of Part-II of Tender documents) uploaded duly filled in with supportive documents.
Whether the details of facilities available vis-a-vis the requirements mentioned in STR in a tabular/narrative form if you are not on the approved list of RDSO, if required in the Annexed Document, is submitted.
Whether, EACH PAGE of the copy of documents/certificates in support of credential is self attested/digitally signed by tenderer/authorised representative with signature, stamp & date.
Whether all the documents related "Mandatory Requirement", as applicable and mentioned in the bid documents are enclosed with the tender.
Please submit bank details as per enclosed Annexure-12 of Part - II of Tender Documents or photo copy of a "Cancelled Cheque". (For details refer tender documents)
Please submit Certificate of Familiarisation as per Annexure-1 of Part-II of Tender Documents. (For details refer tender documents)
Please submit required details as required from Annexure 2 to 11 of Part-II of Tender documents duly filled in and signed. Supportive documents/separate sheet are to be submitted, if required. Annex-2: HISTORY SHEET OF THE TENDERER, Annex-3: TECHNICAL EIGIBILITY CRITERIA, Annex-4: DETAILS OF CONSTRUCTIONS MACHINERIES, TOOLS & PLANTS, VEHICLES ETC. AVAILABLE (ON HAND AND PROPOSED TO BE UTILISED, Annex-5: DETAILS OF TECHNICAL AND OTHER PERSONNELS AVAILABLE ON HAND & PROPOSED TO BE ENGAGED. Annex- 6: DETAILS OF WORKS COMPLETED DURING PREVIOUS THREE FINANCAIL YEARS & CURRENT YEAR, Annex-7: DETAILS OF WORKS ON HAND, Annex- 8: DECLARATION REGARDING ASSOCIATION OF RAILWAY OFFICER (S) WITH TENDERER(S), A n n e x - 9 : LIST OF COURT CASES, Annex-10: LIST OF ARBITRATION CASES. Annex- 11: BROAD PLAN FOR EXECUTION OF THIS WORK. (For details refer tender documents)
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
The tenderer shall clearly specify whether the tender is submitted on his own (Proprietary Firm) or on behalf of a Partnership Firm / Company / Joint Venture (JV) / Registered Society / Registered Trust / Hindu Undivided Family (HUF)/ Limited Liability Partnership (LLP) etc. If it is NOT mentioned in the submitted tender that tender is being submitted on behalf of a Sole Proprietorship firm/Partnership firm/Joint Venture/Registered Company etc., then the tender shall be treated as having been submitted by the individual who has signed the tender . The tenderer(s) shall enclose the attested copies of the constitution of their concern and copy of PAN card along with the tender. Tender Documents in such cases are to be signed by such persons as may be legally competent to sign them on behalf of the firm, company, association, trust or society, as the case may be. (for details refer tender documents) NOTE: Any document containing PAN number of the tenderer(s) shall also be considered in lieu of PAN card. However, if no document having mention of PAN number is uploaded, offer will be summarily rejected. (For details refer Tender documents)
For all tenders having advertised cost of Rs.10 lakh or above, the contractor shall have to submit the option to take payment from Railways through a letter of credit (LC) arrangement. The tenderer shall affirm having read over and agreed to the terms and conditions of the LC option. The option of taking payment through LC arrangement, once exercised by tenderer at the time of bidding, shall be final and no change shall be permitted, thereafter, during execution of contract. (The tenderer have to submit the option to take payment from Railway through a Letter of Credit arrangement) (For details refer Tender documents)
The list of personnel / organization on hand and proposed to be engaged for the tendered work. Similarly, list of Plant & Machinery available on hand and proposed to be inducted and hired for the tendered work. (For details refer tender documents)
Documents to be submitted as per Clause 14 of GCC-April 2022 in support of (a)Sole Proprietorship firm (b) HUF (c) Partnership Firm (d) Joint Venture (JV) (e) Company registered under Companies Act 2013 (f) LLP (Limited Liability Partnership) (g) Registered Society & Registered Trust. (for details refer tender documents) NOTE: Non submission of above documents will lead to summarily rejection of the offer.
Balance work for Construction of one 18 bedded Running Room at Haridaspur (HDS) station of E.Co.Railway
etenderEastkur-356-2025~ECOR
etenderEastkur-356-2025
Open
Works - General
3 Months
Khordha, Odisha
₹0
₹1.2 L
3 Mar 2026
9 Feb 2026
17 Feb 2026
57 items across 3 schedules · ₹60,82,108.02 total
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| 1 | 1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources) | cum | 41 | 7,365.15 | 3,01,971.15 |
| 2 | 1:3:6 (1 Cement : 3 coarse sand (zone-III) derived from natural sources: 6 graded stone aggregate 40 mm nominal size derived from natural sources) | cum | 31.34 | 6,670.25 | 2,09,045.64 |
| 3 | Foundations, footings, bases of columns, etc. for mass concrete | Sqm | 4.32 | 307.95 | 1,330.34 |
| 4 | Providing, hoisting and fixing above plinth level up to floor five level precast reinforced cement concrete in lintels, beams and bressumers, including setting in cement mortar 1:3 (1 cement : 3 coarse sand), cost of required centering and shuttering but , excluding the cost of reinforcement, with 1:1.5:3 (1 cement : 1.5 coarse sand(zone-III) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources) | cum | .15 | 12,321.25 | 1,848.19 |
| 5 | Cement mortar 1 : 4 (1 cement : 4 coarse sand) | Sqm | — | 9 969.65 | 8,726.85 |
| 6 | Area of slab over 0.50 sqm | Sqm | 24 | 3,301.45 | 79,234.8 |
| 7 | Providing and fixing mild steel round holding down bolts with nuts and washer plates complete. | Kg | 450 | 88.5 | 39,825 |
| 8 | Providing and laying rectified Glazed Ceramic floor tiles of size 300x300 mm or more (thickness to be specified by the manufacturer), of 1st quality conforming to IS : 15622, of approved make, in colours White, Ivory, Grey, Fume Red Brown, laid on 20 mm thick cement mortar 1:4 (1 Cement: 4 Coarse sand), jointing with grey cement slurry @ 3.3 kg/ sqm including grouting the joints with white cement and matching pigments etc., complete. | Sqm | 56.6 | 1,142.8 | 64,682.48 |
| 9 | Size of Tile 600x600 mm | Sqm | 307 | 1,416.65 | 4,34,911.55 |
| 10 | 110 mm diameter | Metre | 30 | 319.75 | 9,592.5 |
| 11 | 20 mm cement plaster | Sqm | 30 | 507.85 | 15,235.5 |
| 12 | Providing and laying 60mm thick factory made cement concrete interlocking paver block of M -30 grade made by block making machine with strong vibratory compaction, of approved size, design & shape, laid in required colour and pattern over and including 50mm thick compacted bed of coarse sand, filling the joints with line sand etc. all complete as per the direction of Engineer-in-charge. | Sqm | 70 | 951 | 66,570 |
| 13 | W.C. pan with ISI marked white solid plastic seat and lid | Each | — | 4 5540.55 | 22,162.2 |
| 14 | White Vitreous China Wash basin size 630x450 mm with a pair of 15 mm C.P. brass pillar taps | Each | — | 2 2275 | 4,550 |
| 15 | 610x460 mm bowl depth 200 mm | Each | — | 1 3337.85 | 3,337.85 |
| 16 | 32 mm dia | Each | — | 3 104.35 | 313.05 |
| 17 | Providing and fixing 600x450 mm beveled edge mirror of superior glass (of approved quality) complete with 6 mm thick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete. | Each | — | 2 1411.15 | 2,822.3 |
| 18 | Sand cast iron S&S pipe as per IS: 1729 | Metre | 50 | 1,018.05 | 50,902.5 |
| 19 | Sand cast iron S&S as per IS - 1729 | Each | — | 8 530.7 | 4,245.6 |
| 20 | 450 mm long towel rail with total length of 495 mm, 78 mm wide and effective height of 88 mm, weighing not less than 170 gms | Each | — | 4 573.6 | 2,294.4 |
| 21 | PN - 10 Pipe, 50 mm OD (SDR-11) | Metre | 25 | 568.6 | 14,215 |
| 22 | 25 mm nominal dia Pipes | Metre | 10 | 370.65 | 3,706.5 |
| 23 | 40 mm nominal dia Pipes | Metre | 10 | 559.2 | 5,592 |
| 24 | 25 mm nominal bore | Each | — | 1 532.35 | 532.35 |
| 25 | With common burnt clay F.P.S.(non modular) bricks of class designation 7.5 | Each | — | 1 10102.5 | 10,102.5 |
| 26 | Providing and placing on terrace (at all floor levels) polyethylene water storage tank, IS : 12701 marked, with cover and suitable locking arrangement and making necessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank. | Litre | 3000 | 9.7 | 29,100 |
| 27 | 15 mm nominal bore | Each | — | 2 434.2 | 868.4 |
| 28 | 15 mm nominal bore | Each | — | 4 708.4 | 2,833.6 |
| 29 | 15 mm nominal bore | Each | — | 2 594.75 | 1,189.5 |
| 30 | 15mm nominal bore | Each | — | 6 500.35 | 3,002.1 |
| 31 | 25 mm nominal bore, 152mm long, weighing not less than 440 gms | Each | — | 1 459.4 | 459.4 |
| 32 | Providing and fixing PTMT soap Dish Holder having length of 138mm, breadth 102mm, height of 75mm with concealed fitting arrangements, weighing not less than 106 gms. | Each | — | 2 96.75 | 193.5 |
| 33 | With common burnt clay F.P.S. (non modular) bricks of class designation 7.5 | Each | — | 4 11687.1 | 46,748.4 |
| 34 | Circular shape 560 mm internal diameter | Each | — | 2 1494.2 | 2,988.4 |
| Schedule total | ₹14,45,133.55 | ||||
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .