Supply Installation Testing Commissioning of Borewell Pumps Parking area Lighting and CCTV system near Main Gate BARC Plant Site Tarapur.

Amount

Bore well pump sets shall be made of Stainless Steel Body of makes FALCON/TOPLAND/CRI and with ISI mark. The work includes supply of Pump Sets, Pipes, labor, tools, transportation and all the materials required for installations as per the specification given and as directed by Engg-in -Charge.

Supply, Installation,Testing, Commisioning and Gurantee of SS Body Submersible Bore well pump set 4" dia. of rating 5 HP/3.7KW, 13/15 stage, 2800 RPM and discharge at head 59 to 33 meters, 160 to 310 LPM respectively with 2" dia. outlet and suitable to work at 3 phase, 415 volts, 50 Hz. Pumps are to be supplied with 3 core x 2.5 sq. mm. flexible cable Finolex/ Polycab make in 50 meters length without joint.

Supply, Installation,Testing, Commisioning and Gurantee of SS Body Submersible Bore well pump set 4" dia. of rating 3 HP/2.2KW, 12/15 stage, 2800 RPM and discharge at head 60 to 36 meters, 126 to 192 LPM respectively with 2" dia. outlet and suitable to work at 3 phase, 415 volts, 50 Hz. Pumps are to be supplied with 3 core x 2.5 sq. mm flexible cable Finolex/ Polycab make in 50 meters length without joints.

Fabrication, Supply, Installation,Testing, Commisioning and Gurantee of Control panel incorporating of voltmeter, ammeter indicating lamp, isolator switch - 20 A T/P MCB and single phase preventor. Contactor and over load relay suitable to operate 3 to 6 HP Motor, GIC Analog time switch. Panel Box of size 450 x 500 x 250 mm fabricated out of GI sheet of 2 mm thick with openable door, hinges and locking arrangement. The Panel with door should be powder coated, water and weather proof having IP65 protection.

Supply, Installation,Testing, Commisioning and Gurantee of GI pipe 2" dia, class -C, TATA/JINDAL make, each pipe of length of 10 feet machine end threaded - total 15 Nos. with heavy duty full threaded 15 Nos couplings, Heavy duty MS. Clamp 10 mm suitable for holding the bore well pump- 1 No., Heavy Duty GI bend 2" dia - 2 Nos, GI Flange-2 Nos, Bronze/GM NRV -1 No. and heavy quality Bore Cap - 01 No.

Desing, Supply, Installation, Testing, commisioning and Gurantee of 16 Mtr highmast Lighting Pole as follows: 16 Mtr highmast shaft in two sections suitable for 44m/sec wind speed (as per IS875), 3 mm thick bottom section, Bottom A/F-410 mm, 3 mm thick, Top section Top A/F-150 mm, Hot Dip Galvanising with raising lowering system comprising headframe, luminaries carriage suitable to install 350 watt 16 nos luminaries in symmetrical arrangement, double drum winch, 6/8mm diameter SS wire rope, trailing cable, connector, integral power tool motor, manual handle, junctionbox, lightening finial. Wiring material, power cables between panel and mast. includes the following : i) Foundation bolts manufactured from special steel along with nuts, washers, anchor plate and common template. ii) Single dome LED aviation obstruction lights. iii) Lightning arrester and Head Frame iv) Outdoor stand mounted IP65 feeder pillar with 63A TPN MCB incomer, Digital Astro time switch, 45A TP contactor for the automatic switching of luminaries, power tool control with 2 no 9A contactors and raise lower push button, Incoming 35sq.mm and outgoing 16 & 2.5 sq.mm terminals. v) Construction of shallow foundation with M25 grade concrete for the highmast considering the safe soil bearing capacity at site as 10T/sqmtr at 2 metre depth with all materials and labour. vi) Provision of GI pipe earthing for High mast with 2.5 M long 40 mm dia GI Pipe including connection to High mast earth terminal with 25 x 3 mm copper strip with all materials and labour. (2 nos per mast required) Other detailed specification are given in Annexure. Lighting High Mast Pole Make : Bajaj cat no.BMRLMW16M/Phillips

Supply, installation, testing & commissioning of 350 watt LED flood light with Opticle lenses for the 16 Mtr Height High Mast 1) Rated voltage/watt - 230 V, 50 Hz, 350 Watt 2) Input operating voltage - 90 to 300 volts AC at 50 Hz 3) Protection - IP 66 4) Body - Die cast Aluminum with higher thermal conductivity 5) Luminaries system efficiency > 100 Lm/ watt 6) Single LED Wattage should be more than 4 watt 7) Heavy duty mounting bracket suitable to mount LED flood light Make - Bajaj/ Phillips

Excavation, concrete breaking and doing repairing of concrete work as per the specification and as directed by EIC.

Excavation in all types of soils at a depth of 900 mm and width 450 mm for installation of LT cables including back filling, leveling and dressing from sides. Depth of the trench shall be considered from the normal ground level. Removal or disposal of excess earth within distance of 100 M. Refilled soils should be brought to the normal level by pouring the water in the trenches where ever necessary and as directed by Engg-In-Charge

Dismantling plain cement concrete manually / by mechanical means carefully without damaging adjacent structures including disposal of debris within 200 m lead as per direction of Engineer-in-charge

Providing and laying in position cement concrete of 1:2:4 (1cement, 2 crushed sand, 4 graded stone aggregate of nominal size 20 mm) including consolidation, finishing, curing etc. complete as per specification and drawings but excluding the cost of Formwork shuttering, centering and steel reinforcement at all Levels.

Supply, Installation, testing and Commissioning of LT Cable and FOC as per the specification and as directed by EIC :

Supply of LT Cable : 4 core, 16 sq. mm., 1.1 KV Power Cable Stranded Aluminum conductor, XLPE insulated, PVC "ST-2" inner sheathed (extruded), Galvanised Steel Round wire Armoured and overall PVC "ST-2" extruded sheathed as per IS 7098 and as per specification given in the tender. The total length of the cable should be marked with / have embossing of size, voltage grade, make and length on every one meter length of the cable. The cable should be supplied in a non returnable steel drum in one length the full quantity.

Laying of LT cable : 4 core, 16sq.mm., Laying of LT cable 1.1 KV grade XLPE insulated, Aluminum conductor at a depth of 900 mm below the ground level, covering the same with sand and baked bricks at both sides of the cable and top, as directed by Engineer-in-Charge. (Excavation for under ground cable will measured separately under Excavation item 4.1)

Laying of OFC Cable & power cable through 50mm HDPE Pipe below 600mm Ground level with Electrical Cable/Opticle Fiber Cable. Supply of HDPE Pipe is in Scope of contractor (Excavation for under ground pipe will measured separately under Excavation item 4.1 & 4.2)

Supply, Installation,Testing, Commissioning and Guarantee of CCTV System and accessories as follows:

Supply ,Installation,Testing, Commissioning and Guarantee of Network IR, High Defination 16/32X , 2MP PTZ Dome Camera

Supply and Installation of 12 Port LIU fully loaded 19" Rack Mountable with adaptor SC, SM, pigtails

Supply and installation of optical Fiber Pigtail; 1.5 m; 9/125 micron SM:LC

Supply and installation of SC-SC Single mode fibre patch cords of 3mtr Length Make Dlink or equivalent

SITC of Media Converter suitable for OFC to RJ45 with SM, LC, SFC.

Supply, installation, testing and commissioning of of CAT-6 SFTP cable including termination at both ends i.e. one end in Rack panel and other end in STP CAT-6 module type connector. Make Dlink/Finolex or equivalent

Supply, Testing and commissioning O.F.Cable 12-Core Outdoor-Armoured Unitube SM -HDPE sheath.

F.O.C splicing ,OTDR Testing, cable gland testing ,end to end connectivity, certification and test for all fibers

SITC of GI Powdercoated IP 65 Junction Box Near Pole, Suitable to incorporate Power supply, 2 Nos. Media Converter, OFC Spicing and other accessories.

Supply, installation, testing and commissioning of mounting accessories like box, providing connection for PTZ camera etc.as directed by EIC.