Supplying and fixing L Angle with weldmesh Protection Cover to open well and Steel Grill Doors to Sanitary Complex A B C of Arulmigu Bannari Mariamman temple Bannari sathyamangalam Erode district

Manufacturing, supplying and fixing of Entrance steel doors with the following specification M.S angles of a size 40x40x6mm are used for the outer frames and M.S. angles of size 35x35x5mm for the shutter frames stiffeners with 32x6mm M.S. flat is provided at required intervals in the shutter frames 18 gauge C.R. sheet is laid as panel in the shutter and welded intact for 1/3 bottom portion of the shutter. M.S. flat 18x5mm is welded over the 32x6mm M.S. flat sand witching the CR sheet in between. Additional stiffener with 18x5mm M.S. flat is provided diagonally at the rear side of the shutter. The balance 2/3 portion at top is provided with grill at an average weight of 20 kg/sq.m with 300mm hieght of fixed glazing at top with 3mm thick Pin Headed glass including6 Nos Steel Parliament Hinges of Size 125mm x 150mm for double leaves shutter to be provided 6nos of holdfasts 200mm in length made of angle section spliced at the ends are welded to the outer frame of the door. Tower bolts 4nos. One the top of each shutter, one at lock rail and the other at the bottom are provided. one aldrop is provided at on appropriate place in the door.3 Nos of handle are to be provided. A Tie bar is provided at the bottom of the outer frame to prevent twisting of frame during transportation or fixing. All members are given one coat of red oxide primer as directed by the departmental officers. The rate includes cost of all meterials, labour charges,taxes, transportation to site of work, loading, unloading and all other incidental charges etc., complete complying with standard specification and as directed by the departmental officers. - Double leaf of size 1.50m x 2.40m.

Fabricating supplying erecting and fixing STEEL TRUSS using tubuler channel of 100mm x 50mm x 3mm size at top & bottom and 50mm x 50mm x 3mm square pipe of vertical and sloped portion and 80mm x40 x 3mm using purelines fixed in base plate and clit angles including cost of materials and labour charges etc.complete.

Supplying fabricating and fixing MS weldmesh panels using 35x35x6mm 'L' angle for outter frames and 25x6mm flats for stiffener and weld mesh of size 7.5 x 2.5cm. 10g. The cost is including of all materials and labour charges but excluding of priming coat

Painting Two coats with ready mixed enamel paint over New iron work inculding cost of material and labour chargers

GST Amount for providing Service to Government Contract Works for the above works at 18%(9%+9%). {GST Amount is the Total GST Amount for overall quoted amount}