Kurinjipadi TP GF Fund 25-26 Kulam Works

Amount

Earth work excavation for foundation in Hard stiff clay, stiff black cotton, hard red earth, shales murram, gravel,stoney earth and earth mixed with small size boulders SS.20B and Sand, silt or other loose soil, wet sand,or silt not under water, light black cotton soil, sandy loam ordinary soil and to full depth as may be directed except in hardrock requiring blasting inclusive of shoring shuttering and baling out water and cleaning and levelling the site etc.,complete 10 cum

Supplying and filling in foundation, basement, etc with filling Crushed Stone Dust in layers of not more than 15 cm thick well watered, rammed and consolidated etc. complete complying with standard specification and as directed by the departmental officers

Plain Cement concrete 1:4:8 (one cement, four sand, eight aggregate) using 40mm gauge hand broken granite stone jelly for foundation including dewatering if found necessary and laid in layers of not more than 15cm thick and compacted,etc., complete complying with standard specfication..

Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X and B.G 10 stiffened with M.S angles of size 25mm X 25mm X 3mm laid over silver Oak (C.W) joists of size 10cm X 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification and directed

Plain Cement Concrete 1:2:4 (one cement, two fine aggregates and four coarse aggregates) using 20mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges etc., complete as per standard specification

Casting of precast cement concrete blocks of size 20 x 20 x 10cm in Plain cement concrete of mix 1:1 1/2:3 ( One cement one and half sand and three aggregate) using 20mm size hard broken stone jelly and mixing the concrete and laying the concrete in steel moulds after oiling them properly at casing yard and vibrating finishing the top surface smoothy placing the slab along with mould and plate in the casting yard removing the mould carefully after initial setting, Placing the slab in the curing bond after 24 hours from the time of casting, removing them from the curing pond after 7days of curing, stacking them in the stacking yard with in a lead of 100m and curing them from the full period by sprinking water as directed by the departmental Officers.

Supply and run of 4 X 6 sq.mm (84/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100V grade on 7/20 Gl bearer wire for service connection mains etc, complete as per standard specifications.SD 68

GI STEEL TUBULAR POLE FOR STREET LIGHT 4 Metre Length single Bracket Pole with Base Plate (250 x 250 x 6mm) 76.10mm OD x 3.65mm Thick x 4000mm Length PWD SOR 2024-25- Page No - 148

Supply and fixing of 30W LED Street Light Fitting with LED Outdoor Fittings (Light Emitting Diode)Higher End Philips / Havells / Equivalent etc complete. PWD SOR 2024-25- Page No - 115

Supply and fixing of 3 phase 32A aerial fuse unit for 3 Nos. 32A fuse units (500V) on suitable MS sheet covered with 6mm thick hylem sheet on suitable angle iron work the tapping pole with necessary clamp PWD ELECTRICAL SD 2024-25- SD-132

Supply and fixing of 125 A 4 Pole 200 Amps three phase 500 V 4 pole change over switch etc complete as per standard specification. PWD SOR 2024-25- P.No.121

Supply and laying of 2 x 10 sq.mm PVC LTUG aluminium armoured cable in a trench to be excavated at a depth of 0.75 metre putting 0.15 metre layer of sand and covering the cable completely with bricks and sand and refilling the earth to make good SD -198

P.Kumaravel (BID ID -1484844)