PROVISION OF PAVER BLOCKS AND VIEW CUTTER AT BUILDING NO P-290 AND CERTAIN SANCTIONED WORKS UNDER GE HADDO, SRI VIJAYA PURAM

Amount

Surface excavation n. exc (not exceeding) 30 cm deep and averaging 15 cm deep and getting out in hard dense soil complete all asspecified and as directed.

M & L for hardcore of gauge n exc 63 mm deposited spread and levelled in layers n exc 15 cm thick watered and rammed to a true surface of broken stone or boulders complete all asspecified and as directed.

M & L for providing 100 mm thick, PCC 1:4:8 type D2 using 40 mm graded stone aggregate as in sub base of floors complete all asspecified and as directed.

Demolition of cement concrete (Un-reinforced) in ground floors and pavings n.exc 15cm thick (above or below GL) complete all as specified and directed

M&L for providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour,design & pattern as in footparth, parks,lawns, drive ways or light traffic parking etc.,of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand Complete all as specified and directed

Removal of surplus soil to a distance n. exc. 50m and deposited where directed at a level n. exc. 1.5 m above the starting point complete all asspecified and as directed.

Excavation in post hole in hard/dense soil (or similar holes) each n. exc 0.5 cum, getting out, returning filling in and ramming earth or broken rubble mixed with earth around in layers not exceeding 25cm, watering, and removing surplus soil to a distance n. exc 50m and making good surface complete all as specified and directed

M&L for cement concrete 1:3:6 type C2 (Using 40mm graded stone agrregate) as in foundation of posts, railing and similar work complete all as specified and directed

M&L Cement concrete 1:4:8 type D2 (using 40mm graded stone aggregate) as in foundations or mass concrete complete all as specified and as directed

M&L precast cement concrete block masonry exc 10 cm width with solid block PCC 1:3:6 type C1 (using 20 mm graded stone aggregate) and setting in cement mortar 1:4 complete all asspecified and as directed.

M&L for 10mm thick plaster in CM (1:6) on fair faces of concrete/PCC block surfaces of walls finished even and smooth (without using extra cement) complete all asspecified and as directed.

M&L for Roof trusses (framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including distance pieces, cleats etc. conforming to Fe-410W Gde E-250 complete all as specified and as directed

M&L for applying two coat of synthetic enamel paint over a coat of red oxide primer including preparation of new steel surfaces of any description over 10cm width or girth not otherwise described complete all as specified and directed

M&L for preparing newly plastered wall surface and applying two or more coats of 100% premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/10 Sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 Sqm complete all as specified and directed

S & F 8mm thick fibre cement plank of 0.15m width of any colour fixed in position with suitable screws/ fasteners as per manufactures instructions on aluminium/ mild steel work in wall cladding @ c/c distance of 0.25m including applying two coats of exterior emulsion paint on fibre planks complete all as specified and as directed. Note: Aluminium/ Mild steel work shall be measured and paid seperately. Make : As approved by GE.

Demolition of stone slabs and tiles of any description or thickness in floors, aprons, riser of steps, skirting, dado etc laid in any mortar complete all as specified.

Excavation in post hole in soft/loose soil (or similar holes) each n. exc 0.5 cum, getting out, returning filling in and ramming earth or broken rubble mixed with earth around in layers not exceeding 25cm, watering, and removing surplus soil to a distance n. exc 50m and making good surface complete all as specified and directed

M & L for providing 75 mm thick, PCC 1:4:8 type D2 using 40 mm graded stone aggregate as in sub base of floors complete all asspecified and as directed.

M & L for providing 25 mm thick PCC 1:2:4 type B0 using 12.5 mm graded stone aggregate as in floors finishing the surface of concrete topping even and fair without using extra cement, complete all as specified and as directed

M&L chequered Cement concrete tiles 30 cmx30cmx 25 mm thick set, jointed and pointed neat cement slurry in floor with grey cement and pigments , incl CM (1: 4) 20 mm thick screed bed complete all asspecified and as directed.

M&L for cement concrete type C1 1:3:6 (20mm aggregate) in foundations, filling and mass concrete complete all asspecified and as directed.

S&F Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all asspecified and as directed.

S&F Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws complete all asspecified and as directed.

S&F aluminium wind tie of any size fixed with self tapping screws of size 50/75mm with integral EPDM washer in roof covering complete all asspecified and as directed.

S & F Rolled sections as in main and cross beams, hip and jack rafters; purlins, pole where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates using structural steel of Fe-410W (Gde E-250 quality A) complete all asspecified and as directed.

S&F mild steel Plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, without any attachment complete all asspecified and as directed.

S&F angle iron posts for fencing posts, structs including flat iron etc and including cutting tops to shape as directed, drilling holes, notching for wires etc flat iron fillets for securing fencing including all necessary welding, drilling, bolting or riveting conforming to Fe-290 (gde E-165) complete all as specified and directed

Returning, filling in soil incl levelling watering and well ramming in layers n.exc .25cm in fdn trenches complete all asspecified and as directed.

M&L 10mm dia MS round bars cut to length bent to shape required etc..(to be used for stiffness to chain link) fixed independently to the angle iron post, (Conforming to Fe 410-W (Gde E-250) quality 'A' or Fe 290 (Gde E-165) complete all asspecified and as directed.

Supply and Fixing of PVC coated MS galvanised chain link fencing of size 50mm x 50mm x 4.0mm fixed to any type of fencing posts with straining bolts, stiffener rods etc. including provision of binding wire if required etc complete all asspecified and as directed.

M&L for two coats of synthetic enamel paint over a coat of Red oxide primer including preparation of new steel/iron surface of any description n exc 10 cm in width or girth complete all asspecified and as directed.

M & L for reinforced cement concrete 1:1.5:3 ( Using 20 mm graded stone aggregate) as in foundation plinth beam cantilevers, bressummers etc,complete all asspecified and as directed.

M & L for reinforced cement concrete 1:1.5:3 ( Using 20 mm graded stone aggregate) as in column, pillars, piers, post and like, any thickness, above top of footing including attached pilasters and buttresses complete all asspecified and as directed.

M & L for form work to sides for rough finished surface of concrete columns and similar work for rectangular, square, round etc. complete all asspecified and as directed.

S&F TMT steel bars 10mm dia and over, cut to length, bent to shape required, including cracking bending spirally for hooping for footing, columns, beams, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia complete all asspecified and as directed.

S&F TMT steel bars 5mm dia and over upto including 10mm , cut to length, bent to shape required, including cracking bending spirally for hooping for footing, columns, beams, hooking ends in stirrups spacers and binder and binding with and including mild steel wire (annealed) not less than 0.9mm dia complete all asspecified and as directed.

M&L precast cement concrete block masonry exc. 10 cm width with solid block C1 (1:3:6) (using 20 mm graded stone aggregate) and setting in cement mortar (1:6) all as specified and as directed.

M&L for rendering 15mm thick cement plaster in CM( 1:4) on fair face of block or concrete surface with water proofing compound finished even and smooth without using extra cement complete all asspecified and as directed.

M&L for preparation on newly plastered wall surface and applying two coats of cement base paint complete all asspecified and as directed.

M&L for mild steel ornamental work as in intricate design gate, fabricated out of M S rolled sections, tubes, square, plain and twisted bars, hand made aldrop bolts, tower bolts and hinges to suit the design including fixing the gate with MS frame work all as directed and conforming to Fe-290.Gde-E-165 complete all asspecified and as directed.

Excavation in trenches n. exc 1.5m wide and n. exc 1.5m in depth in hard/dense soil for foundation, etc or for shafts, wells, cesspits, manholes, pierholes, etc n. exc 10 Sqm on plan and getting out complete all as specified and directed

M&L for cement concrete 1:2:4 type B1 (Using 20mm graded stone agrregate) as in foundation of posts, railing and similar work complete all as specified and directed

M&L for rendering 15mm thick on fair faces of brick work or concrete surfaces finished with even and fair without using extra cement in CM 1:4 complete all asspecified and as directed.

Supply only liquid water proofing compound

Manas Patra Steel Fabrication (BID ID -3315634)

LOOK UP ENTERPRISES (BID ID -3315625)

M/s Saina Enterprises (BID ID -3316168)

ABR Construction (BID ID -3315278)

M/s Kamal Electrical (BID ID -3317236)

AMR TRADERS (BID ID -3315549)

HANUMAN CONSTRUCTION (BID ID -3317262)