Loading
Loading…
Loading…
Tender Value
₹7.9 Cr
EMD Value
₹15.8 L
Closing Date
9 Oct 2026, 3:00 pm
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
EAST
14 conditions · 2 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N OR 'V' Whichever is less; where. V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per ANNEXURE-XXXIII, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
a)The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii)Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii)One similar work costing not less than the amount equal to 60% of advertised value of the tender.
Defination of Similar Work :- "Work of Supply, Installation & Commissioning Of DAC." OR "Any Signalling work involving Supply, Installation & Commissioning of DAC."
10 conditions · 3 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Tender document, Scope of work & GCC 2022 are attached with the tender.
Provision of dual detection of Track Circuit in the balance section of East Section of Mumbai division.
CR-BB-SNT-EAST-2026-56~CR
CR-BB-SNT-EAST-2026-56
Open
Works - General
18 Months
Mumbai, Maharashtra
₹0
₹15.8 L
11 Sept 2026
11 Sept 2026
25 Sept 2026
14 items across 2 schedules · ₹5,81,69,339.46 total
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| 1 | Supply of Frequency Selective Voltmetre, A P L A B make Model No. FSV-02 or similar. (Inspection Agency Consignee) | Numbers | 2.00 | 1,44,154.4 | 2,88,308.8 |
| 2 | Digital current clamp meter to measure current leaks parasitic draws down to 1 mA and electric load from 1 mA to 100 Amp AC/DC, and voltages from 0 to 600 V AC/DC, small jaw size to measure current in signaling circuits, 4 digit display. make FLUKE/ GTC/KIOCO or superior with better specification mentioned with all accessories like test lead, batteries and carrying case, sample may got approved from consignee before supply.(Inspection Agency Consignee) | Numbers | 20.00 | 24,381.82 | 4,87,636.4 |
| 3 | Tool kits for for Multi Section Digital Axle counter as per RDSO specification RDSO/SPN/176/2005 (Ver.2) with latest amendment or specifiaction with Supply of tools for mounting and adjustment of track side equipment and standard jig for drilling holes in rail/fixing DPs on rail. All equipment and tools shall be minimum as per OEM's recommended list adequate for installation, day to day maintenance and adjustment of indoor and outdoor gears including kit for making and drilling of holes on rail and as per annexure XXI. (Inspection Agency Consignee) | Numbers | 15.00 | 82,795.18 | 12,41,927.7 |
| 4 | Supply of heavy duty drill machine specification Bosch Impact drill GSB 16 RE Drill capacity wood: 30 mm , steel: 12mm , concrete 16mm, 701 W, Light weight. (Inspection Agency Consignee) | Numbers | 10.00 | 2,203.36 | 22,033.6 |
| 5 | Battery operated High performance LED area with 3000 lumens output light weight & unbreakable as per specification attached (1) Product specification M18 HAL -+ M18 NRG 502B (2) Article No. 493345123 (3) Battery compatibility all Milwaukee M18 Batteries (4) Battery capacity (Ah) 5.0 (5) Battery type Li ion (6) No of Battery charger supplied 01 No. (7) Full Battey charging time 59 min (8) Max light output 3000/1500/650 (9) Max run time battery 2/4/9 hr. (10) No. of batteries supplied 2 Nos. (11) Voltage (AC) (V) 220-240 (12) Voltage (DC) (V) 18 (13 Wight with battery pack (kg) 3 (14) One year onsite warranty, installation & training free of cost mak Eibenstock/Milwaukee or equivalent. (Inspection Agency Consignee) | Numbers | 5.00 | 59,365.66 | 2,96,828.3 |
| 6 | Arrangement of Battery operated RailCore Drill alongwith additional 18 mmTCT Rail Core Drill , Maximum corecutting capacity : 36 mm, Ratedspeed: 250/450 RPM, Battery type:Li-on, Battery voltage: 50 Volt,Battery pack capacity: 4 AH, Numberof Battery supplied: 2 Nos, Number ofCharger supplied: 1 No, Specialdesign pressurized Internal spindlecooling to give maximum life of corecutter and to avoid heating of the rail.Time taken to drill one hole of 32 mmin 60 KG 90 UTS rail section less thanone minute. Time taken to fix themachine on the rail, less than 2minutes and to de-clamp less than 1minute. 34 Number 32 mm diameterhole with full charge batteries (17hole per battery) in 60 Kg 90 UTS railsection. 3 Sets of standard center raildrilling adapters for gauge 90, 52, 49provided along with machine. Weightof machine with battery: 18.5 KG,Make: Eibenstock. Bosch,KPTL((Inspection Agency Consignee) | Numbers | 5.00 | 2,09,200.73 | 10,46,003.65 |
| 7 | Supply of polyolefin cable channel 2434 with following dimensions, height (internal/external) 155/230mm x width 240mm/340 mm x length 1000mm with suitable detachable cover having fire protection class K1 in accordance with DIN 53438 part 2 and electrical characteristic Dielectric strength 48KV/cm in accordance with DIN VDE 0303-21 for laying of all types of S&T cables. (Inspection Agency RITES) | Metre | 1440.00 | 2,337.55 | 33,66,072 |
| 8 | Supply of 120 mm HDPE pipe for laying in Horizontal Boring. (Inspection Agency RDSO) | Metre | 250.00 | 802.78 | 2,00,695 |
| 9 | "Supply of DC-DC converter modules 24- 40V/10A as per DSO/SPN/165/2012 (Ver.3) withlatest amendment. ACCEPTED MAKE--as required at site(Inspection Agency RDSO)" | Numbers | 50.00 | 19,942 | 9,97,100 |
| 10 | Wiring of MSDAC track circuit contacts in Data logger and necessary changes in simulation software panel at site and at control room for mismatch Data.(Inspection Agency Consignee) | Numbers | 15.00 | 16,545.78 | 2,48,186.7 |
| 11 | Supply of Cable fault locator as per specification. Make : Tempo, Stanlay or Greenlee. Module SIDEKICK PLUS 1155- 5001(Inspection Agency Consignee) | Numbers | 1.00 | 5,49,133.75 | 5,49,133.75 |
| 12 | Supply of Generator Module (Outdoor) suitable for Siemens make MSDAC suitable with existing Multi- Section Digital Axle Counters as per RDSO/SPN/176/2013(Inspection Agency RDSO) | Numbers | 15.00 | 76,941.9 | 11,54,128.5 |
| 13 | SIRIUS CARD for Multi Section Digital Axle CounterSiemens make RDSO specificationNo.RDSO/SPN/176/2013 Ver.3 or latest Make/Brand:SIEMENS(Inspection Agency RDSO) | Numbers | 5.00 | 1,65,006.33 | 8,25,031.66 |
| Schedule total | ₹1,07,23,086.06 | ||||
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
GCC_April-2022.pdf
ATTACHMENT
CORRECTIONSLIP1to11GCC2022_compressed.pdf GCC CORRECTION SLIP 1 TO 11
ATTACHMENT
FINALNEWTENDERDOC2026-56.pdf
ATTACHMENT
CORRECTIONSLIP1to11GCC2022_compressed.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .