SPECIAL REPAIR OF SEWAGE AND DRAINAGE SYSTEM ALONGWITH CERTAIN MW AND RW AT LGJ MIL STN

Amount

Excavating in trenches, n exc 1.5 m wide and n exc 1.5 m in depth for foundation, etc. and getting out soft/loose soil and n exc 10 sq m on plan complete all as specified and directed.

Excavating in trenches, n exc 1.5 m wide and exc 1.5 m in depth for foundation, etc. and getting out soft/loose soil and n exc 10 sq m on plan complete all as specified and directed.

Excavating over areas, n exc 1.5 m deep and getting out soft/loose soil complete all as specified and directed.

M&L for PCC 1:3:6 type C2 using 40mm graded stone aggregate in foundation, filling & mass concrete all as specified and directed.

M&L for brickwork with fly ash old size bricks, straigth of curved on plan exc 6m mean radius, built in CM 1:4 complete all as specified and directed.

M&L for plain cement concrete, type B1 1:2:4 using 20 mm graded stone aggregates in lintels upto 1.5m span, cills steps, seismic and other similar bands, plinth courses, copings, bed plates, and the like including weathering, slightly rounded or chamfered angles and throating, incl formworks all as specified and directed.

M&L for PCC 1:2:4 type B2 using 40mm graded aggregates as in benching / haunchig of manholes including forming channels including necessary formwork etc complete all as specified and directed.

M&L precast cement concrete 1:2:4 type B1 using 20mm graded stone aggregate and set cement mortar 1:4 as in cover slabs (for manholes etc,) chajjas, shelves and similar articles with plain faces and including forming channels, including necessary formwork etc.all as specified and directed by Engr-in-Charge.

M&L for TMT bars(Fe-500D) 10mm dia and over, cut to any length bent to shapes reqd. including hooking, bending and binding with mild steel wire (annealed ) not less than 0.9 mm dia all as directed.

M&L for formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work not exc 200 mm thick (horizontal or sloping) rough finish surface of concrete flat all as specified and directed.

M&L for reinforced cement concrete 1:1:2 using 12.5mm graded stone aggregrate in slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like; all as specified and directed. Note : Reinforcement shall be measured and paid seperately.

M&L Rendering 15mm thick on fair face of brick work in cement mortar 1:4 mix with WPC and finished surfaces even and smooth without using extra cement as specified and directed. Note : - (WPC shall be measured and paid seperately)

Supply only liquid water proofing compound complete all as specified and directed.

M&L for 100 mm thick PCC (1:4:8) type D2 using 40 mm graded stone aggregate as in below of DWCPE pipe line as a bed and provide required slope all as specified and directed.

Supply and laying DWCPE (SN8) 150 (ID) mm diameter drain pipes as per IS-16098 (Part-II), laid in trenches on PCC bed to required slope, including all accessories/fittings, jointing and tested complete all as specified and as directed by Engineer-in-Charge. Note: DWCPE pipe should be ISI marked as approved by Engr-in - Charge.

Supply and laying DWCPE (SN8) 200 (ID) mm diameter drain pipes as per IS-16098 (Part-II), laid in trenches on moorum bed to required slope, including all accessories/fittings, jointing and tested complete all as specified and as directed by Engineer-in-Charge. Note: DWCPE pipe should be ISI marked as approved by Engr-in - Charge.

Returning, filling in, including spreading levelling including watering & well ramming in layers n. exc 25 cm any type of soil all complete as specified.

Removing excavated material n.exc 50m and depositing where direcrted at a level n.exc 1.50 m above the starting point all as directed.

Cutting into existing manholes for connection of new drain making pipes and rendering cutting out existing benching & forming branch channel in PCC 1:2:4 type B1 smooth finished & forming benches as reqd etc for 150 mm bore all as directed.

M &L for framed work such as grills, gratings, etc.. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars barred iron doors, ladders, framed balusters, walk ways, railings, framework of water tanks and similar work conforming to Fe.290.Gde-E-165 complete all as specified and directed.

M&L for hardcore of gauge n exc. 63mm, deposited, spread and levelled in layers n exc.15cm thick,watered and rammed to a true surface in Broken stone or boulders of compacted thickness.

M & L for 75 mm thick cement concrete type C-2 (1:3:6) (40mm graded aggregate) use as in sub base of floor necessary form work complete all as specified and directed.

M & L for 100 mm thick cement concrete type D-2 (1:4:8) (40mm graded aggregate) use as in sub base of floor and including necessary form work complete all as specified and directed.

M&L Machined pressed precast concrete interlocking paver block glossy with grey cement and pigment, any shape and size confirming to IS 15658-2006 of 60mm thickness M-35 grade with over Fazilka sand cushion all as specified and directed. Note : (Sand will be measured and paid seperatly).

Suply only Fine aggregate (sand) for Cushioning (Fazilka sand) all as specified and directed.

M&L for precast cement concrete 1:2:4 type B1 using 20mm graded stone aggregate as in kerb stones of any size with plain fair faces, including chamfers, weathering, throating etc setting in CM 1:4 complete all as specified and directed.

M&L for preparation of new plastered/ old surface of walls and applying two coats of cement base paint over a coat of primer complete all as specified & directed by Engr-in-charge.

Surface excavation n.exc (not exceeding) 30 cm deep and averaging 15cm deep and getting out soft/loose soil complete all as specified and directed

M&L for PCC (1:4:8) using 40mm graded stone aggregate as in foundation, filling of sunken floors/bottom and side of wall complete all as specified & directed by Engr-in-charge.

Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm in soft/loose soil.

M & L cement concrete in type B-2 (1:2:4) 40mm graded aggregate in foundation, floors filling and mass concrete complete all as specified and directed.

Taking down cement plaster on brick / stone walls including raking out joints, hacking for key, scrubbing down with water all as directed.

Dismantling floor, hearth or wall tiling/kota stone including cement mortar bedding (but not backing), removing rubbish off the premises all as directed.

M & L Machine cut kota stone slab flooring 20-25mm thick over cement screed base laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and polishing complete over and including 15 mm thick screed bedding in cement mortar 1:6, all as specified and directed.

M & L Machine cut kota stone slab 20-25mm thick in riser of steps, skirting, dado and pillar laid over cement screed and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and polishing complete over and including 10 mm thick rendering in cement mortar 1:4, complete all as specified and directed

S&F Pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet including Ridge 0.50 mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified & directed by Engr-in-Charge.

Supply and Fix structural steel works as roof trusses (framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or any flat section) including distance pieces, cleats etc conforming to Fe-410-W (Gde-E-250) quality A, Complete all as specified and directed by EIC.

S&F MS screw bolts of any dia with hexagonal or square heads at one end screwed at other end, dia of shank 5 to 10 mm and length of bolt exc. 5cm but n.exc. 10 cm complete all as specified and directed

M&L preparation new steel surfaces of any description over 10 cm width or girth and applying two coats of synthetic enamel paint over and including one coat of red oxide zinc chrome primer complete all as specified and as directed.

Demolition of brick work or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars, coping of manhoe/septic tank etc, but excluding ashlar facings, dressed stone work and precast concrete articles all as directed.

Demolition of reinforced cement concrete of any description and in any position not otherwise specificlly provided for (reinforcement cut as required to facilitate demolition) all as specified and directed..

Note:- The contract sum shall be calculated by deducting the amount shown in Credit Schedule attached to this tender, from total amount of Schedule 'A'/BOQ

Aggarwal brothers and company

ram rattan dass aggarwal

PAREEK AND COMPANY

Dashmesh Construction Company

KHANNA CONSTRUCTIONS

GOYAL ENTERPRISES

NATIONAL ENTERPRISES