construction of Community Hall at Vasaloorpatti H/O Thinnanurnadu

Construction of Community Hall at Vasaloorpatti H/O Thinnanurnadu

Earth work excavation and depositing on bank with in initial lead of 10 m and initial lift of 2m in hard stiff clay, stiff black cotton soil, hard red earth, earth mixed with small sized boulders and hard gravelly soil as per SS 20B

Cement concrete 1:4:8 mix using 40mm ISS metal including cost and conveyance of all materials to site and all labour charges for mixing, laying and curing etc complete

Refilling the basement with excavated earth other than sand complying the Standard specification

Brick work in following Cement Mortar using best quality Fly ash bricks of size 23x11x7cm for foundation and basement including curing etc.,complete complying with standard specification.

For Foundation and Basement

For Superstructure in ground floor

Supplying and Fabricating and placing in position MS steel or ribbed for steel for all reinforced cement concrete works as per the design given including cost of steel and binding wire in all floors etc, Complete complying with stanard specification.

Supplying and erecting centering shuttering including necessary supports for plane surface in foundation and basement and in all floors for R C C column footing column plinth beam, beams, roof slabs, staircase steps, bed blocks, critical pier etc using mild steel sheets of size 90 x 60 cm and 10 guage stiffened, welded with mild steel angles of size 25mmx25mmx3mm for boarding laid over silver oak (country steel angles of size 25mmx25mmx3mm for boarding laid over silver oak (country wood) scantlings of size 10cm x 6.5cm spaced of about 90cm centre to centre and supported by casurina props of 10cm to 13cm dia spaced at 75cm centre to centre complete complying with standard specifications and as directed by departmental officers including conveyance of all materials to site and proper centering etc complete.

Centering below Ground Level

Rate for Column Post

Rate for Roof Slab, Lintel, beam

Rate for Sunshade

Cement concrete 1: 1.5 : 3 mix using 20mm ISS HBG metal for all RCC item of works excluding cost of Rein forcement and fabricating charges, centering and shuttering but including curing and providing fixtures like fan clamps in the RCC floor or roof slabs wherever necessary and bearing surfaces of walls , sides and bottom of the slabs, beams etc., shall be finished smooth with cement mortar 1:3, 12mm thick. and with kraft paper without claiming extra as directed by the departmental officers complete complying with standard specifications

Supplying and applying of two coats of putty of 3mm thick over the exposed RCC surface of ceiling including finishing the joints smoothy with grinding machine and the surface shall be thoroughly cleaned out of dust and scrubbing. The Surface shall then be allowed to dry for atleast 48 hours. It shall then be sand papered (waterproof abrasive sheet) to give a smooth and even surface. Any unevenness shall be made good by applying 1st coat of putty mixed with water on the entire surface including filling up the undulations and applying 2nd coat of putty after 6 hours of 1st coat of putty and then sand papering (waterproof abrasive sheet) the same after it is dry and finishing the surface smoothly, etc., complete complying with standard specifications and as directed by the Departmental Officers. [ The rates are inclusive of hire charges for grinding machine with wheel, cost of sand paper (waterproof abrasive sheet), cost of putty blade, labour charges for grinding the joints and sand papering, two coat of putty, scrapping the putty area to level the surface smooth, etc., complete]. The Putty shoule be got approved by the Executive Engineer before use on work.

Plastering with CM 1:5,12mm thick including curing etc., complete complying with standard specifications and as directed by the departmental officers.

Paving the Floor with scratch proof ceromic tiles of size 305x305x6mm including cost and conveyance of all materials to site and all labour charges etc complete

Providing granolithic floor finish in cement concrete 1:2:4 mix using 10-12mm ISS metal to 25mm thick including cost and conveyance of all materials to site and all labour charges for mixing, laying, curing etc complete for 10 cum

Oil Distembering two coats over new plastered including cost and conveyance of all materials to site and all labour charges etc complete.

Interior/Exterior Emulsion Two Coats over priming coat including cost and conveyance of all materials and labor charges etc. complete.

Painting two coats over new iron works using ready mixed enamel paint including cost and conveyance of paint and all labour charges etc complete

Supply and Fabrication of Steel door size 0.90 x 2.10 m includining Cost and Conveyance of all Cherges etc complete.

Supply and Fabrication of Steel Window size 0.90 x 1.20 m includining Cost and Conveyance of all Cherges etc complete.

Supply and Fabrication of Steel Window size 1.20 x 1.30 m - 6No includining Cost and Conveyance of all Cherges etc complete.

Supply and Fabrication of Steel Door Size 1.50 x 2.10 m includining Cost and Conveyance of all Cherges etc complete.

Labour charges for fixing Doors alongwith frames in position etc., complete (finished work) as per serial no 154 and item no 19

Labour charges for fixing Windows and Ventilators alongwith frames in position etc., complete (finished work) as per serial no 155 and item no 20

SupplyandfixingofTNEBmeterboardsuitablefor32Asinglephaseserviceconnectionwith32Afuseunit(500V)32Aneutrallinkandearthlink(1"x1/8"copperflat)onTWplankofsize375mmx300mmx19mmwithsupportingTWreepersof1"thickaneithersidewithpaintingwithsuitableboltandnutsforfixingtheTWplankonwallwithearthconnectionandinterconnectionwith7/20PVCinsulatedcopperwirefromEBmetertofuseunitwith1No40Amp30MA Double Pole RCD / RCCB (Lower End) with suitable necessary connection (SD 126)

Supplyandrunof4x6sq.mm.PVCinsulatedSCunsheathedFRLScopperconductorof1100Von7/20GIbearerwirefor service connection mains (SD 68)

Supplyandrunof4x6sq.mm.PVCinsulatedSCunsheathedFRLScopperconductorof1100Vgradein32mmdiaGIpipe (Class 'B') suitably bent at both ends with necessary angle iron up right and end supports for mains (SD 73)

Supply and providing 1000 litres capacity Priming Tank made up of PVC.M-0821

Please Enable Macros to View BoQ information