SPL REAPAIR TO ADDRESS SEEPAGE ISSUES IN TOWER SM-392 AT GOSWAMI ENCLAVE UNDER GE (AWC) MHOW

M & L for repair to sunken floor by provide water proofing treatment to sunken floor surfaces of RCC slab by the following specifications as specified and directed :- (a) Provide PCC 1 : 1.5 : 3 type A with using 12.5mm graded stone aggregate in slope of average thickness 50mm on sunken floor slab mixed with and including integral water proofing compound manufactured by Dr FIXIT or equivalent as approved, finish the surface even & smooth without using extra cement. (b) Rendering 15mm thick in CM 1:3 mixed with & including integral water proofing compound on sunken floor and sides of (Vertical surface) sunken portion. (c) Applying surfaces of bituminous primer (conforming to IS-3384-1965) @ 0.40 Kg/Sqm complete. on complete sunken surfaces of floor & wall and provide necessary connections to soil/waste pipe from WC/ nahani trap etc including demolation of old sunken complete all as specified and as directed. (d) Applying a tack coat of Industrial bitumen grade of 85/25 at the rate of 1.2 Kg per Sqm including cleaning surfaces (1st coat for bonding material below membrane and 2nd coat on top of membrane. Each coat would be paid seperately.) (e) APP based polymeric membrane minimum weighing 3kg/sqm and minimum 3mm thick reinforced with polyster non wove fabric (wt. not less than 150 gms/sqm) land on primed surface by forced application complete all as specified and directed. Note : Floor Area shall be measured for payment.

M & L PCC 1:5:10 type E-2 using 40 mm graded stone aggregate as in mass concrete complete all as specified and directed.

M & L rendering 10 mm thick on brick wall/cement block wall or concrete surfaces in cement mortar 1:6, surfaces finished even and smooth without using extra cement complete including taking down cement plaster on brick or stone walls/ concrete surface, etc. all as specified and as directed.

M & L rendering 5 mm thick in cement mortar 1:3 on concrete surfaces as in ceiling surface finish even and smooth without using extra cement including taking down cement plaster on brick or stone walls/ concrete surface, etc. complete all as specified and directed..

Supply only Integral water proofing compound complete all as specified and directed.

M&L for preparation of new plastered surfaces of walls and applying two coats of oil bound distemper over a coat of alkali resistance primer over a coat of putty complete all as specified and directed.

M&L for preparation of new plastered surfaces of ceiling and applying three coats of white wash complete all as specified and directed.

M& L in repair for preparation of surface for application of water based epoxy resin coating of waterproofing for internal wall dampness and filling of cracks and making the surface smooth and finish complete all as specified. Note : (a) Complete removal of treatment/plaster(where needed) on internal walls and preparation of surface for application and making the surface wet .(b) apply first coat of Dr. fixit Dampguard in ratio(1U base:1U hardner:1U water) in one direction and leaving the coat to dry for 6 to 8 hrs.(c) apply second coat of Dr. fixit dampguard in ratio(1U base:1U hardner:1U water) in perpendicular direction to the first coat applied and leaving the surface to dry for 24 hrs. Material: Dr. fixit Dampguard or equivalent.

Description all as per ser item No. 7.00 above but one coat of white wash on ceiling complete all as specified and as directed.

M & L for complete removal of existing treatment on walls and evenly applying two coat of oil bound distemper with roller over a coat of putty all as specified and directed.( Note: putty will be measured and paid seperately in relevant item.)