PRVON OF CONCERTINA COIL BARBED WIRE AND GALVALUME SHEETS ON SECURITY WALL AT 230 SU

Amount

M&L for Demolition of cement concrete in any position and any description including cutting of reinforcement bars to facilitate demolition complete all as specified and directed.

M&L RCC M-25 (Design Mix) using 20 mm graded stone aggregates as in beams.

Mild steel TMT bars 10 mm dia., and over cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with mild steel wire (annealed) not less than 0.9 mm dia., or securing with clips

Mild steel TMT bars 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips

Fair finished flat Form work to sides and soffits of floor or roof beams, lintels, cantilevers, shelves including supports etc.

S & F in repair for Galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured)

Supply and fixing in repair punched tape concertina coil 610mm dia made with high tensile strength galvanized mild steel wire 2.60 mm dia as per IS 4454 strip material (galvanized MS strip as per IS-1730) upto 3 metre height of wall with angle iron 'Y' shaped placed 2.5metre to 3 metre apart and with 9 horizontal R.B.T stud tied with G.I staples and GI clips to retain horizontal including necessary bolts or GI barbed wire tied to angle iron with reinforced barbed tape (RBT)/ spring core (2.6mm dia) wire minimum barb 9mm width, loop spacing 250± 20mm, coil length 9mm and fixed in position , complete all as specified and directed.Note :-(i) The make shall be got approved by AGE(I) confirming to the specification before procurement. (ii) Mild steel angle (Y-Shape) shall be measured and paid for separately.

Dismantling wrought iron or mild steel work of any description not otherwise provided for

S&F mild steel posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; including all necessary drilling, bolting or riveting, etc., conforming to Fe-290 Gde E-165

Supply only Mild steel flat iron conforming to Fe 410-0 as in rail/fillets for securing chain link fencing including drilling holes etc.

M&L preparation of new untreated steel surfaces of any description, over 10 cm in girth, not otherwise described and painting two coats of synthetic enamel paint over a coat of red oxide all as per directed by Engr-in-charge.

S&F prepainted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of an colour having tensile strength 550 MPA as in roof covering in roof covering incudingl ridge fixed with self tapping screws / L type or J type hook as specified

Demolition of brick work built in cement mortar incl all quoins, arches, pillars etc complete all as specified and directed .

Taking down cement plaster on brick or concrete walls, ceiling etc, including racking out joints , hacking for key, scrubbing down with water etc complete all as specified & directed by EIC .

M&L rendering 15 mm thick in CM 1:4 on fair faces of new brick work or concrete surfaces , finished even and smooth without using extra cement all as specified and as directed.

Material and labour for applying two coats of Acrylic weather coat emulsion paint on newly plastered walls/ceiling/facias/ramp Surface etc in disruptive pattern having percentage of Six- colour as 29.04% of RGB Value (143, 152, 113), 22.48% of RGB Value (112,139,86), 14.98% of RGB value (123,137,126), 13.80% of RGB Value (84,97,75), 14.15% of RGB Value (123, 137, 94) and 5.55% of RGB Value (206,193,141) as per sample approved by AGE(I) for building of height upto 7.5 meter, over and including a coat of alkali resistance primer complete all as specified and directed. Note:- The rate quoted by contractor is demmed to include preparation of surfaces and necessary scaffolding for painting upto required height.

Note: The Total amount shall subject to adjustment of credit for old Materials as per Schedule of Credit.

rajan builders (BID ID -3352656)