Repair/Reconditioing of 16 MVA, 33/11KV Power Transformer (Kanohar Make) Sr.No.16000/10 located at Malabar Hill Receiving Sub-station.

LABOUR & MATERIAL CHARGES (EXCLUDING COPPER MATERIAL):

To & fro transportation of Transformer with accessories including Insurance, loading/unloading between Undertaking site and contractor’s site.

Removing top plate, disconnecting OLTC gear, Conservator and Buchholz Relay etc and taking out, putting back core coil assembly in original position for inspection.

Dismantling of HV windings

Dismantling of LV windings

Dismantling of the core assembly

Cleaning and painting of transformer tank from inside and outside as per specification

Cleaning and painting of conservator tank from inside and outside as per specification

Replacement of the damaged / defective core laminations

Reconditioning of the damaged / defective core laminations

Replacement of core bolts with insulation

Replacement of only insulation of the core bolts

Reassembly of the core

Replacement of HV winding by using new conductor and insulation (labour charges only)

Replacement of LV winding by using new conductor and insulation (labour charges only)

Overhauling and repairs of ON LOAD TAP CHANGER, OLTC mechanism overhauling. The OLTC shall be made mechanically and electrically through.

Dehydration of the assembled core and windings in an oven under vacuum

Assembly of accessories such as conservator tank, HV and LV bushings, radiators, associated pipings etc for carrying out final testing at the works.

Cost of new transformer oil to be replaced

Routine/acceptance tests as per IS 2026-1977 and as per Annexure-VII

Heat Run test

Replacement of all gaskets

Copper Material Charges (HV & LV winding with Leads):

HV winding

LV winding

HV leads

LV leads

Tap winding leads

Credit Part:

Credit for Copper parts

Credit for existing Transformer Oil, if it is replaced by new

Credit for replaced M. S. Hardware

Credit for replaced Brass components/accessories

Other items which may required to be replaced:

Complete OLTC

Oil level gauge

Radiator valves

Filter valve 50mm

Filter valve 80mm

Filter valve 100mm

Drain valve 50mm

Drain valve 80mm

Drain valve 100mm

Sampling valves

Conservator valves

Bi-directional flanged rollers

Buchholz relay for main tank

Winding temperature indicator

Oil temperature indicator

OSR for OLTC

Magnetic oil level gauge

Breather for Main tank

Breather for OLTC tank

Radiators- Repairing/testing

Pressure Relief Valve

Marshalling box - Fabrication, wiring & electrical components

Any other item such as OLTC parts etc. which are not mentioned above:

Cover gasket

All type of oil seals and air release plugs

Fixed contact with fixing materials

Moving contact with fixing materials

Terminal Board Assembly

Transition Resistance unit assembly for 3 Phase

TPI Assembly

Motor for Drive mechanism

Door Gasket

Limit switch raise

Limit switch lower

Terminal Block 6 sqmm

Mechanical counter

M.S. Handle (For Manual Operation)

Motor Protective Relay

Nitrogen Injection Fire Protection System:

Supply of NIFP System

Retrofitting, Installation, Commissioning & On-site Testing of NIFP System

HIGH VOLT ELECTRICALS PVT. LTD. (BID ID -6345073)

HIGH VOLT ELECTRICALS PVT. LTD.