ward 21 bailahi bazar sthit shri siddhdhaam hanuman ji mandir ka jeernodhwar

Dismantling lime or cement mortar brick work including stacking of desmantled materials with in 50 m distance s directed by Engineer Incharge. DSR-15.7.4

Excavation in foundation in ordinary soil (Loam clay, or sand ) including lift upto 1.5 m & lead up to 30.0 Mtr & including filling,watering and ramming ofexcavated earth in to the trenches or in to the space between the building and the sides of foundataion trenches or in to the plinth and removal & disposal of surplus earth as directed by the Engineer- In-Charge up to a distance of 30.0 Mtr from the foundation trenches .as per DSR-2.8.1

E/W in cutting or in embankment including cartage of 5 km lead. DSR-2.25a

Cement concrete work in 1:4:8 with cement coarse sand and stone ballast including all. DSR-4.1.8

M-150 Brick work in 1:6 cement sand mortor etc all complete work in foundation upto plinth level DSR-6.4.2

M-150 Brick work in 1:4 cement coarse sand mortor etc all complete work in super structure DSR-6.4.1

Providing and laying in position ready mixed or site batched design mix cement concrete for reinforced cement concrete work; using coarse aggregate and fine aggregate derived from natural sources, Portland Pozzolana / Ordinary Portland / Portland Slag cement, admixtures in recommended proportions as per IS: 9103 to accelerate / retard setting of concrete, to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curing, carriage for all leads; but excluding the cost of centering, shuttering, finishing and reinforcement as per direction of the engineer-in-charge; for the following grades of concrete. (DSR-5.33 ) M 25 All works above plinth level upto floor V level DSR-5.33.1.1

Providing and laying in position ready mixed or site batched design mix cement concrete for reinforced cement concrete work; using coarse aggregate and fine aggregate derived from natural sources, Portland Pozzolana / Ordinary Portland / Portland Slag cement, admixtures in recommended proportions as per IS: 9103 to accelerate / retard setting of concrete, to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curing, carriage for all leads; but excluding the cost of centering, shuttering, finishing and reinforcement as per direction of the engineer-in-charge; for the following grades of concrete. (DSR-5.33 ) All works above plinth level upto floor V level DSR-5.33.2.1

2.5 cm thik Damp Proof course with cement and approved coarse sand 1:2 with and Including water Proofing material as ordered by the Engineer incharge in the proportion as specified by the manufactures including supply of all materials; labour and tools & plants etc required for proper curing and shuttering as necessary S.I.361.

centering and shuttering including strutting, propping etc. and removal of form for foundations, footings, bases of columns, etc. for mass concrete DSR-5.9.1

centering and shuttering including strutting, propping etc. and removal of form for Suspended floors, roofs, landings, balconies and access platform DSR-5.9.3

centering and shuttering including strutting, propping etc. and removal of form for lintels, beams, plinth beams, girders, bressumers and cantilevers DSR-5.9.5

Centering and shuttering including strutting, propping etc. and removal of form for columns, pillars, piers, Abutments, posts and Struts DSR-5.9.6

M.S. (TMT Fe500D or more) in Plain Work Such as RCC or RB Work including Supply of Steel and its wastage Bend,Hooks and authorised over lapping shall be masured and Including cost of binding wire. DSR-5.22.6

S/f of mild steel gate/ grill of including all labour material T&P

12 mm thick plastering work in 1:4 cement sand mortor all complete work. DSR13.4.1

Providing and applying White cement based putty of average thickness 1 mm of approved brand and kajufacturer over the plastered wall surface to prepare the suurface even and smooth complete. DSR 13.80 (factor-0.728)

Distempring with oil bound distemper of approved brand and manfucture and of requried shade including cost of all materials labours T&P etc. DSR-13.62.1

Painting or varnishing on iron work in small areas or new wood work with one coat of ready mix primer. DSR13.67.2

Black Zebra Marble Stone Flooring with 18mm thick marble stone, as per sample of marble approfed by Engineer-in-charge over 20mm thick base of cement mortar1:4 laid and jointed with grey cement slurry including rubing and polishing complete with. DSR 11.23.4

Providing an fixing SS (grade 304) railing made of hollow tubes ,channel,plates including all oprations and accessories DSR 10.28

Construction of granular sub-base coarse graded Grade 1 by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as per Technical Specification Clause 401.

S/L 80 mm thick interlock c.c. paver block with compressive strength 300-350 kg/cm2 &including sand cushion etc comp (Zig-Zag shape)

Cement concrete with in 1:2:4 cement coarse sand of 2.5 f.m. and 2cm gauge stone grit S.I. no 279(a)

Construction of un-reinforced, construction joint only,plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregates conforming to IS: 383, maximum size of coarse aggregate not exceeding 20 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of construction joints, applying curing of concrete slabs for 14-days and water finishing to lines and grade as per drawing and Technical Specification Clause 1501.

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved vy engineer incharge) .50 mm (+0.05%) total coated thickness with zinc coating 120 mpa Steel grade 5-7 microns Epoxy primer on both side of the sheet and polyester top coat 15-18 mocrons sheet should have protective guard film of 25 microns minimum to avoide scratches during transportation and should be supplied in single lenfth up to 12 m or as desired by engineer incharge . The sheet shall be fixed using self drilling as per market

Providing and fixing wash basin with C.1. brackets, 15 mm C.P. brass pillar taps, 32 mm C.P. brass waste of standard pattern, including painting of fitings and 6 brackets, cutting and making good the walls wherever require,White Vitreous China Wash basin size 550x400 mm with a pair of 15 mm C.P. brass pilar taps DSR 2023- 17.7.3

Providing and fixing C.P. brass bib cock of approved quality conforming to IS:8931 15mm nominal bore DSR 2023- 18.49.1

Wiring for light/ power plug with 2X4 sq. mm FRLS PVC insulated copper 2 3 5 6 7 conductor single core cable in surface/ recessed medium class PVC conduit alongwith 1 No. 4 sq. mm FRLS PVC insulated copper conductor single core cable for loop earthing as required. DSR 2022- 1.12

Wiring for circuit/ submain wiring alongwith earth wire with the following sizes of FRLS PVC insulated copper conductor, singlecore cable in surface/ recessed medium class PVC conduit as required. 2 X 10 sq. mm + 1 X6 sq. mm earth wire DSR 2022-1.14.5

Supplying and fixing suitable size GI box with modular plate and Cover in front on surface or in recess, including providing and fixing 3 pin 5/6 A modular socket outlet and 5/6 A modular |switch. connections etc. as required. DSR 2022-1.31

Installatlon, testing and commlssloning of celllng fan, including Add as per Dist. Cost index wiring the down rods of standard length (upto 30 cm) with 1.5 sq. mm FRLS PVC insulated, copper conductor, single core cable etc. as required. DSR 2022-1.44

Supplying and fixing 5 A to 32 A rating, 240/415 V, 10 kA, "C" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required Single pole and neutral DSR 2022- 2.10.2

Supplying, installing, testing and commissioning of following capacity TPN distribution tap off box made of 1.6mm thick sheet steel enclosure duly painted with powder coating on existing rising mains complete with HRC fuses, interconnections, earthing etc. as required. 16 A TPN, 2 way DSR 2022. 3.3.1

Earthing with G.I. earth pipe 4.5 metre long, 40 mm dia including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe etc. with charcoal/ coke and salt as required. DSR 2022- 5.2

Providing and fixing 25 mm X5 mm G.I. strip in 40 mm dia G.I. pipe from earth electrode including connection with Gl. nut, bolt, spring, washer excavation and re-filling etc. as required. DSR 2022- 5.11

Supply and fixinf of LED Street light fitting having die cast aliminiumbody and diffuse with drivr set suitablefor 180 watt. Confirming to IP 65 and above Protection complete in all respects CAT-AAA DSR E/M-2018

Supply & fixing of fire extinguishers, ABC type 9.00 Kg capacity (ISI marked IS : 15683 & TAC approved) complete with initial charge and wall bracket, along with supply of all materials and labour for proper completion of work. ELEC.-2018 - 1131(B)

Supply & fixing of fire extinguishers, CO2 type 6.50 Kg capacity (ISI marked IS : 15683 & TAC approved) complete with initial charge and wall bracket, along with supply of all materials and labour for proper completion of work. ELEC.-2018 1132(A)

S/F of Fire Bucket, round bottom made of G. I. sheet 9-11 Ltr. capacity duly painted as per fire brigade design, supported on hanging bracket chained and locked, initially filled with fine river sand, water as per directions of Engineer-in-Charge. ELEC.-2018 1133

Cemented sitting bench

water cooler (as per market rate.)

1% cotingency charge

sale of materials

Please Enable Macros to View BoQ information