Providing and Laying Paver Block back side of Saraay Building in GMSSH Sector 16 UT Chandigarh

Excavation for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location within all lifts and lead upto 1000m complete in all respects and to the entire satisfaction of Engineer in charge. N.S.

Haulage of matrial/Earth by mechanical transport excluding loading, unloading and stacking with lead upto 5 Km. N.S.

PREPARATION OF SUBGRADE AT CUTTING PORTION. Preparation and consolidation of sub grade after loosening of the ground upto a level of 100 mm below the sub-grade level, watered, graded and compacted in layers to meet requirement of table 300-2 for sub-grade construction complete in all respect in all respects and to the entire satisfaction of the Engineer in charge. N.S.

Providing, laying, spreading and compacting granular sub base material 200 mm thick compacted of natural sand, morrum, gravel crushed stone or combination thereof as per MORT&H specification confirming to clause 401 coarse graded grading – 3 as per table 400.1 of MORT&H specification (5th revision), including spreading on the prepared sub grade with the help of tractor with planner of adequate capacity maintaining the requited slope and grade during operation, rolling with road roller 8-10 tone with the grade and cross fall (camber) to be checked and any high spot or depressing which becomes apparent, corrected by removing or adding fresh material, including cost of tools and plants, carriage of material from stacks, templates, barrier, lighting arrangement at night, chowkidar and maintenance of diversion etc. complete in all respect as per MORT&H specifications, density of GSB as laid 2 gms/cc complete in all respect and to the entire satisfaction of Engineer in charge. N.S.

WET MIX MACADAM : Construction of 250 mm thick compacted Wet Mix Macadam to confirming to clause 406 of MORT&H (Ministry of road transport and highway)specification (5th edition) having as laid, density of 2.2gm/c.c (Two point Two gram per cubic centimeter) by providing laying, spreading and compacting clean, crushed aggregate and granular material, area conforming to Table 400.12 (Physical Requirement) and Table 400.13 (grading) of MORT&H (Ministry of road transport and highway)specifications (5th revision). The material shall be premixed with water at OMC in Mixing Plant/Pan type mixer/Pug Mill and mixed material carried to site by tippers and spread uniformly and evenly on the prepared sub base/base by tractor with planner of adequate capacity and all high and low spots remedied by removing or adding aggregate, as required and rolled with 8-10 (Eight to ten tones) tones roller to achieved/desired density. It shall included the cost of tools and plants, carriage of material from stacks, templates, barriers, safety temporary warning lamps at night, chowkidar, maintenance of diversion etc. Complete in all respects as per MORT&H (Ministry of road transport and highway) specification and to the entire satisfaction of the Engineer-in-charge. N.S.

Providing and fixing 80 mm thick ISI approved high density rubber moulded precast cement concrete paver blocks grey / coloured designer, polished, manufactured by vibro hydraulic pressure process consisting of design mix of cement, sand and fine aggregate having designation M-35 including best quality of colour and hardening agent. The pavers should be complied with tensile strength and breaking load as per BIS 6717-1993 and shall be tested against resistance to wear as per IS:1237-1980. The paver should be laid over a layer of 35 mm thick screened coarse sand to the required slope and filling the joints with fine sand etc. complete in all respect and to the entire satisfaction of Engineer-in-charge. N.S.