SITC of Biosafety Cabinet Class II Type 2

PUNJAB BIOTECHNOLOGY INCUBATOR

COMMERCIAL BID FORMAT

Name of the Equipment Bio Safety Cabinet Class – II Type A2

Name of the Manufacturer

Make of the Equipment

Part A - Main Equipment Qty Rate in Rs. GST Amount Total Amount

Application: For handling of samples under controlled/ sterile environment and to protect personnel, laboratory. environment and samples against biohazardous / infectious agents, pathogens etc 1

Cabinet should have

1 Air Balancing: 30% Exhaust & 70% Re-Circulation .

2 Direction of flow : Vertical.

3 Working Area 4 x 2 x 2 Ft (w x d x h).

4 Should have energy efficient DC ECM blower.

5 Low sound emission < 65 dBA.

6 Exterior with galvanized powder coated steel or galvanized metal coated with antimicrobial coating.

7 Work area and side/ Rear wall should be made up of one-piece SS-304 without any joints.

8 Drip tray underneath the removable SS-304 Single piece worktop with lift out knobs to collect spilled liquids.

9 Safety sash/Front door made of clear Toughened glass, vertical sliding.

10 HEPA/ULPA filter with efficiency 99.995% to 99.999%.

11 Should have Digital Display showing - Particle retention: 0.3 micron, Comply with the requirement of ISO class – 5 cleanliness or better.

12 Pre Filters should have Synthetic, non-woven polyester media, with Retention 10 -15 micron and Efficiency 90% (min).

13 Cabinet should have Bright, Fluorescent/LED lighting >1000 Lux.

14 UV germicidal lamp - Controlled by automatic UV lamp timer and should automatically switch “off” when the front door/sash is opened to avoid accidental exposure of UV rays to the users.

15 Alarms  Audible and visual window alarm  Should have Audible SASH HEIGHT alarm to warn the operator if the window is raised above the recommended height  Fail-safe system to ensures that in case of exhaust failure, the cabinet’s main fan automatically shuts down to ensure safety to the user

16 Should have Main and outlet power circuit breakers.

17 Provision of gas/vacuum service port with external shut-off valve.

18 Should have Power switches for exterior mounted fluorescent lights and / or ultraviolet lights, interior outlets, at least two 16/6 Amp power sockets and blower motor etc.

19 Equipment should have supporting base/stand along with lockable castor wheel for mobility.

20 Power supplies 220-240 V, 50 Hz.

21 Should be NSF 49 certified.

22 Calibration Certificate from NABL Accredited Agency after successful installation

Total Amount of Part A

PART B - AMC Charges (After expiry of Standard Warranty of One (01) Year

1st Year AMC Charges

2nd Year AMC Charges

3rd Year AMC Charges

4th Year AMC Charges

5th Year AMC Charges

6th Year AMC Charges

Total Amount of Part B

Total FOR Amount upto PBTI Site- Part A + Part B

Total Amount in Words:

1. It is mandatory to quote item wise rates for Part B lump sum rates are not acceptable for these.

2. Bidder must quote amount in the given cells, if amount against any cell is included in main component, bidder should put "Zero" value.

3. Taxes must be mentioned, if it is not mentioned, the same shall be treated as included in given rates.

4. This is to certify that the rates quoted above are not more than the rates charged from any Institution/Department/Organization

Signatory Name: