Sifting of 11 KV Line and other electrical work against Pradhan Mantri Gram Sadak Yojna (Deposit scheme) Under Jurisdiction of EDD, CESS-III and IV, Ciss Gomti, Lesa, Lucknow (Package No. UP46114, UP4697, UP46112, UP46113)

Amount

Sifting of 11KV Line against Pradhan Mantri Gram Sadak Yojna. Package No. UP46112, UP46113, UP4697, UP46114 Safe Loading, Carriage & unloading of following Materials from Centre Store to Pit Site/J.E. Dump Store.

Line Material

PCC Pole 8.5 Mtr. Long

ST Pole 11 Mtr. Long

ACSR weasel/Rabbit conductor

11 KV Pin Insulator

11 KV GI pin with nut

11 KV Disck Insulator

Three Phase Distribution Box

Stay Wire 7/10 SWG

Stay Rod Complete

GI Wire 4mm/6/8SWG

11 KV XLPE cable (3x70) sq.mm.

ABC 3x50 sq.mm.

ABC 1x16 sq.mm.

Earth Rod Complete

11 KV V type Cross Arm

11 KV Disck Fitting

11 KV OD/ID 3x120 sq.mm.

Fabrication, erection of double pole for end terminations/sectional double pole, 11 KV line on ST Pole with fixing of necessary clamps & other accessories like 1 nos top channel 100x50 mm 2.24 m. 1 No. Guarding Angle. Its grouting in ratio 1:4:8 plinthing 300 mm above ground level, earthing of support & one side cable expose.

Dragging of ST/PCC Pole, digging of pit erection of section/exposer type double pole structure on ST/PCC Pole with fixing of necessary item such as Top Channel, along with grouting (As per RESPO Norms) Dropper Channel, 11 pin insulator with Pin & 11 KV Disc Insulator with fitting, DO Fuse set its ramming as per RESPO Specification. Only Pole and insulator will be Provided by the Department.

Dragging of ST/PCC Pole to pit site, diging of pit erection and grouting (As per RESPO Norms) of 11 KV 11/8.5 Mtr Long ST/PCC Pole with, fixing of necessary item, such as V-type X-arm, F-bracket, 11 KV Pin insulator, Gaurding angle (1.8 mm 65x65x6) with Nut & bolts its ramming as per RESSPO Specification. Only Pole and insulator will be Provided by the Department.

Dragging of PCC Pole from Dump Store to pit site, diging of pit erection and grouting (As per RESPO Norms) of LT support suitable for laying of ABC Line on 8.5 Mtr Long PCC Pole by providing of necessary eye hook/Lt Shackle insulator with Clamps and its accessories etc. as per RESSPO Specification. Only Pole will be Provided by the Department.

Grouting & Nuzzling of stay set complete including fixing of necessary clamps. Accessories required including its grouting by civil material (Sand, Brick blast & cement). All material exept stay wire shall be supplied by the contractor.

Ordinary earthing by MS earth Rod 2500mm long as per RESPO Schedule. All material exept earthing wire shall be supplied by the contractor.

Laying Stringing & sagging of 3 Phase 3 wire 11 KV New Line on ACSR Wesal/Rabbit conductor as per RESPO Specification and direction on E/I. All material exept ACSR wesal/Racoon/rabbit conductor shall be supplied by the contractor.

Guarding of HT line by GI wire. GI wire shall be supplied by the department.

Proper laying & commissioning of (3x50/3x95/3x120 sq.mm) XLPE Aerial Bunched Conductor. Only ABC Provided by deptt.

Proper laying & commissioning of (1x16+1x16 sq.mm) XLPE Aerial Bunched Conductor. Only ABC Provided by deptt.

Fixing of Single/Three Phase distribution boxes/Kiosk on the LT poles including all clamps and material required for mounting connections & sealing. Only distribution box Shall be supplied by deptt.

Digging of pit suitable for 3x120 sq.mm 11 KV XLPE cable laying. After 11 KV XLPE cable laying refilling by Bricks & sand as Per RESPO Norms. Only 11 KV XLPE cable supplied by Department.

Laying of 11 KV 3x70 sq. mm XLPE cable double circuit digging of trench 1050 mm deep, 750 mm side including supply of required material, 1st class bricks, stone pad & fine sand. The inter spacing between two cable should be in between 0.25 m to 0.40m. The cables shall be laid in trench by first filling layer of sand and laying on sides with bricks, fixing bricks as partitions between two cables, after laying cable, covering cable by stone pads resting on bricks, covering it by earth, all work as per RESPO norms. (Allmaterial required for laying will be supplied by the contractor except 11 KV XLPE cable). One length cable-190 Mtr total length 380 Mtr.).

Cable Hosting of 11 KV 3x70/3x120 sq. mm XLPE Cable at the following including jumpering etc complete with help of GI Pipe as Per RESPO Norms. GI pipe and other required material shall be supplied by contractor.

High pressure testing of 11 KV 3x70/3x120 XLPE cable along with arrangement of High Pressure equipment.

Dismantling of Old LT/HT KV line, Pole and other material including rolling back its conductor, wire, including stacking & transporation of these materials form site to JE dump store/Central Store Daliganj, Lucknow.

Lopping & Chopping of tree branches for clearance of HT/LT line. After clearance of line through out pieces of tree branches of site.

Fabrication, errection & commissioning of 25 KVA T/F on Double Pole with all accessories. All material except 25 KVA T/F shall be supplied by the Contractor.

Supply and Laying of HDPE Pipe 125mm dia as per RESPO Norms. All Material will be provided by contractor.

Fabrication, erection of for conversion of existing single pole supprt into sectional double pole for 11 KV line on 11 M long ST Pole with groting plinthing and paintig of one st pole in the alignment of existing pole fixing of necessary clamps & other accessories like 3 no. top channel 100X50 mm - 2.24 M 2 no. Guarding Angle and 3 X bracing etc.(all material arranged by contractor except steel & pole & insulators) necessary stay set shall be provided by contractor at his own cost.as per RESPO norms.

Fabrication, erection of single section pole for 11 KV line on 8.5 M long 8.5 MTRe with fixing of necessary clamps & other accessories like 1 no. top channel 100X50 mm - 2.24 M. 1 no. Guarding Angle disc fitting and disc insulators etc.(all material arranged by contractor except steel & pole and insulators ).as per RESPO norms.

Erection of single stud pole support on PCC pole 8.5 M long with fixing of necessary clamps and other accessories required for erection.

Fabrication, erection of for conversion of existing single pole supprt into sectional double pole for 11 KV line on 8.5 MTR PCC Pole with groting plinthing and paintig of one st pole in the alignment of existing pole fixing of necessary clamps & other accessories like 3 no. top channel 100X50 mm - 2.24 M 2 no. Guarding Angle and 3 X bracing etc.(all material arranged by contractor except steel & pole & insulators) necessary stay set shall be provided by contractor at his own cost.as per RESPO norms.

M/S MANSA ENTERPRISES

M/s CHAUHAN ELECTRICALS