Pdg. Special Repair to E.I. in Boys Hostel No. 2 of Government Polytechnic Jhajjar. (Recall)

Amount

HSR Items

23.5 Coppper Wiring in existing PVC / MS Conduit Pipe Surface / Recessed

23.5.1 Wiring only in 1.5 sqmm PVC insulated copper conductor cable for LIGHT/FAN/Call bell point in existing conduit pipe and MS boxes including cost of Bakelite cover for MS box, switch, wall socket, ceiling rose/connector etc.

23.5.1.2 Group B

23.5.2 Wiring only inexisting conduit and MS box for Twin control light point with 2 nos., 2-ways, 5 amp. switch in 1.5 sqmm FRLS PVC insulated copper conductor cable.

23.5.2.2 Group B

23.5.4 Wiring in existing conduit and MS Box for 3-pim 5 amp. Plug point by using 2 no. 1.5 sqmm FRLS copper wire and 1 No. 1.5 Sqmm FRLS copper wire including providing 1 no. 5/6 Amp 3/5 pin socket and 1 no. 5/6 Amp switch etc. complete as required.

23.5.4.2 Group B

23.5.5 Wiring inExisting Conduit system for 3-pin 15 amp. Plug point by using 2 Nos. 4 Sqmm FRLS copper wire and 1 no 4 Sqmm FRLSCopper wire for earthing, Including providing 1 no 15/16 amp 3/6 pin socket and 1 no 15/16 amp. switch etc. complete as required

23.5.5.2 Group B

23.5.6 Wiring main sub mains in Two single core for phase and neutral wire and one single core for each wire PVC insulated copper conductor cable 1100 volts grade in existing MS/PVC Conduit etc complete as required

23.5.6.1 1 run of size 1.50 Sqmm (1/1.40 mm)

23.5.6.2 1 run of size 4 Sqmm (1/2.24 mm)

23.8 Fittings and Accessories.

23.8.1 Providing and fixing Paino type accessories of approved make in existing box and Bakelite sheet including fixing and making necessary connection, complete in all respect

23.8.1.12 Bakelite angle / straight button holder large size.

23.9 Erection of Exhaust fan in existing opening, complete with necessary earthing of Fan including carriage from PWD store to the site of work.

23.11 Making suitable hole in the wall suitable for exhaust fan upto 450 mm sweep including finishing the same and fixing of stainless steel wire mesh 2 mm thick having about 50 meshes per inch at exhaust side complete as required.

23.22 MCCB, Distribution Boards, MCB's, RCCB's, Change Over etc.

23.22.1 Supply and erection of modular case circuit breaker single pole / 4 pole on existing wall / pedestal / panel including bounding to earth and making necessary connections required to complete the job in all respect upto the entire satisfaction of the Engineer-in-Charge of the work.

23.22.1.5 TRIPLE POLE MCCB 200 to 250 Amp., 25 KA

23.22.4 Supply and erection of double door sheet steel enclosure distribution boards suitable for MCB's & ELCB's recessed in wall including bonding to earth complete with all labour and material required to complete the job in all respect up to the entire satisfaction of the Engineer-in-charge of the work.

23.22.4.5 TPN DB Horizontal type Double Door 4 way (8 incoming and 3 phase * 4 outgoing)

23.22.4.7 TPN DB Horizontal type Double Door 8 way (8 incoming and 3 phase * 8 outgoing)

23.22.5 Supply and erection of miniature circuit breaker 240/ 415 V in the existing distribution board including making necessary connections

23.22.5.1 6 Amp. to 32 Amp. Single Pole

23.22.5.6 40 Amp. to 63 Amp. MCB's TRIPLE POLE

23.22.5.8 41 Amp. to 63 Amp. MCB's FOUR POLE

24.1 Earthing and Lightening Arrestor

24.1.1 Earthing with GI earth pipe 4.5 m long and 40 mm dia with masonry enclosure on the top etc. (but without charcoal or coke and salt) as required

24.1.2 Extra for using salt and charcoal/coke for earth electrode as required.

24.1.11 Providing and laying earth connections from earth electrode with 4.00 mm dia GI wire in 15 mm dia GI pipe from earth electrode as required.

24.5.2 S/E of mark double walled corrugated (DWC) HDPE pipe10 Kg./Cm2 laid 0.75 mtr. below ground level including digging and refilling of earth including cost of suitable size socket / cuppler for HDPE pipe including the cost of labour and material required to complete the job in all respect upto the entire satisfaction of Engineer-incharge of the work

24.5.2.3 DWC/HDPE pipe 63/50 mm outer dia / inner dia

24.4.16 Supply and erection of weather proof M.S. box of size 20 cm x 15 cm x 10 cm. covered with 3.00 mm thick M.S. sheet hinged cover, locking arrangement, housed in wall, including the cost of 1 no. 16 amp. 415 volts SP MCB and 2 nos. 63 amp. 415 volts neutral links fixed on hard wood board/10 mm Bakellite sheet in the M.S. box including painting and necessary connections

M.R. Items

NS-1 S/E of underground cable loose in existing pipe or trenches complete in all respect upto the entire satisfation of Engineer-in-Charge of the work.

i) 10 Sqmm 4 Core (Armd.)

ii) 25 Sqmm 4 Core Cable (Armd.)

iii) 95 Sqmm 3.5 Core Cable (Armd.)

N.S - 2 Supply & Erection of LED flood light fitting of Havels make JETA IRI SFL 100W LED or its equivalent make of Crompton/WIPRO/Phillips/Bajaj make with pressure die cast alluminium housing, reflector and enclosed with toughened glass with all accessories as supplied by the manufacturer complete in all respect upto the entire satisfaction of Engineer-in-Charge of the work.

N.S - 3 Supply and erection of MS Saddle and clamps duly galvanised , on wall / RCC parapit for fixing underground cable at a distance of 0.60 metre center to center fixed by means of rawl plug including the cost of all labour and material required to complete the job in all respect and upto entire satisfaction of the Engineer-in-charge of work. (Based on Old HSR 31.48)

N.S - 4 Supply and erection of MS stand made of 50mmx50mmx6mm angle iron frame and 150cm long, 30cm wide with MS sheet covering size 30cmx30cm 3.15mm thick fixed on the top of board & legs duly embedded in 1:2:4 cement concrete block 30cm below ground level including the cost of cement sand, welding, painting & fabrication charges etc. up to the entire satisfaction of Engineer - in - charge of the work. (Based on Old HSR 31.51)

S.S. Enterprises