Collectorate Ke Nikat Transits Hostel Ke Awasho ki Marramat and Rangai Putali ka Karya

Removing white or colour wash by scrapping and sand papering and preparing the surface smooth including necessary repairs to scratches etc complete (As per chap.13 -S.l.code no .13.88 of D.S.R)

Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead code no. 15.56 of dsr

12mm thick cement Plaster with cement mortar in proportion of 1:4 cement and corse sand in single coat on fair side of single or half brick wall for interior plastering including arises, interior rounded angles chamfers and of rounded angles not exceeding 80 mm in grit and finished even and smooth.(As per chap.13 -S.l.code no .13.4.1of D.S.R)

Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.(As per chap. -S.l.code no .13.80 of D.S.R)

Finishing walls with Premium Acrylic Smooth exterior paint with Silicone additives of required shade: New work (Two or more coats applied @ 1.43 Itr/10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 sqm) code no.13.46.1 of dsr

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade One or more coats on old work code no.13.99.1 of sor

Extra for providing and fixing expanded metal mesh of size 20x60 mm and strands 3.25 mm wide 1.6 mm thick weighing 3.64 kg per sqm for encasing of rolled steel sections in beams, columns and grillages, excluding cost of hangers.

Providing and laying damp-proof course 40 mm thick with cement concrete 1:2:4 (1 cement: 2 coarse sand (zone-III) derived from natural sources: 4 graded stone aggregate 12.5 mm nominal size derived from natural sources)(As per chap.4 -S.l.code no .4.10 of D.S.R)

providing and fixing 110 mm dia isi marked PVC pipe for seawoge water pipes etc conforming to IS make working pressure 4 kg/Sqcm including supply of all materials labour, testing, complete fitting bend, cowl T&P,etc. recquired for proper completion of work

roviding and fixing angle iron frames for doors, windows and ventilators of mild steel Angle sections of size 35x35x5 mm, joints mitred and welded by angle iron 35x35x5 mm or 35x 5 mm flat pieces to the existing T-iron frame or to the wall with dash fastener, including fixing of necessary butt hinges and screws and applying a priming coat of approved steel primer, all complete as per the direction of Engineer-In-charge. (As per chap.10 -S.l.code no .10.31 of D.S.R)