Development work of the pond located behind barn number 14 in Kanha Upvan.

Dewatering of water by deisel pump and etc all complete work .

Trenching in ordinary soil up to a depth of 60 cm including removal and stacking of serviceable materials and then disposing of surplus soil, by spreading and neatly leveling within a lead of 50 m and making up the trenched area to proper levels by filling with earth or earth mixed with sludge or/and manure before and after flooding trench with water (excluding cost of imported earth, sludge or manure).

Supplying and stacking of good earth at site including royalty and carriage up to 1 km (earth measured in stacks will be reduced by 20% for payment).

Supplying and stacking at site dump manure from approved source, including carriage up to 1 km (manure measured in stacks will be reduced by 8% for payment) : Screened through sieve of I.S. designation 16 mm

Fine dressing of the ground

Mixing earth and sludge or manure in the required proportion specified or directed by the Officer-in-charge..

Preparation of beds for hedging and shrubbery by excavating 60 cmdeep and trenching the excavated base to a further depth of 30 cm, refilling the excavated earth after breaking clods and mixing with sludge or manure in the ratio of 8:1 (8 parts of stacked volume of earth after reduction by 20% : one part of stacked volume of sludge or manure after reduction by 8%), flooding with water, filling with earth if necessary, watering and finally fine dressing, leveling etc. including stacking and disposal of materials declared unserviceable and surplus earth by spreading and leveling as directed, within a lead of 50 m, lift up to 1.5 m complete (cost of sludge, manure or extra earth to be paid for separately).

Digging holes in ordinary soil and refilling the same with the excavated earth mixed with manure or sludge in the ratio of 2:1 by volume (2 parts of stacked volume of earth after reduction by 20% : 1 part of stacked volume of manure after reduction by 8%) flooding with water, dressing including removal of rubbish and surplus earth, if any, with all leads and lifts (cost of manure, sludge or extra good earth if needed to be paid for separately) :Holes 90 cm dia, and 90 cm deep

Providing and Displaying Foxtail palm plant well developed with fresh & healthy foliage of ht. 210 to 240 cm in big 40 cm Cement Pot as per direction of the officer-in-charge.

Supply and stacking of plant Thuja compacta of height 75-90 cm., conical shaped, well formed with healthy foliage in earthen pots of size 30 cm as per direction of the officer-in-charge.

Providing and Displaying Washingtonia filifera palm plant well developed 90 to 105 cm ht. having 5 to 6 straight fresh and healthy leaves in 35 cm Cement Pot as per direction of the officer-in-charge.

Providing and Displaying Bismarkia Palm plant 115 to 180 cm ht., well developed 12 and above good color fresh and healthy leaves in 40 cm Cement Pot as per direction of the officer-in-charge.

Providing and Displaying Cycus cirsnallis plant well developed with fresh & healthy 35 to 40 lush green leaves in 40 cm Cement Pot as per direction of the officer-in-charge.

Providing and Displaying Topiary plant of Ficus Nuda well developed with fresh & healthy foliage from Top to Bottom with single piller 75 to 90 cm spread, 195 to 210 cm ht. in 35 cm Cement Tray /Cement Pot as per direction of the officer-in-charge.

Supply and stacking of Grevillea robusta (Silver Oak) plant of height 150- 165 cm. in big poly bags of size 25 cm as per direction of the officer-incharge.

Supply and stacking of Plumeria acutifolia plant of height 150-165 cm. with 3-4 branches in big size HDPE bag as per direction of the officer-in-charge

Supply and stacking of Chorisia speciosa plant of height 150-165 cm. in big poly bags of size 25 cm as per direction of the officer-in-charge.

Supply and stacking of Polyalthia pendula (Ashok Pendula) plant of height 180-195 cm. in gunny bag of size 30 cm as per direction of the officer-incharge.

Supply and stacking of Azadirachta indica ( Neem ) plant of height 120- 130cm in big polybag of size 25 cm as per direction of the officer-in-charge.

Supply and stacking of Bauhinia blakeana (Kachnar) plant of height 120- 150 cm. in big poly bags of size 25 cm as per direction of the officer-in-charge.

Supply and stacking of Bottle palm plant of ht. 210-240 cm bottom girth 30-35 cm well developed in big HDPE bags.

Providing and displaying of Areca Palm plant, having ht. 2.40 m to 2.70 m with 12 to 14 suckers, well developed, fresh and healthy with lush green foliage in 35 cm size of Bucket type cement pots & as per direction of the officer-in-charge.

Providing and displaying of Raphis palm specimen plant, having ht. 1.50 m to 1.65 m with 40 to 50 lush green suckers, well developed, fresh & healthy foliage leaves in 40 cm size of Earthen Pot / Chali / Tray & as per direction of the officer-in-charge.

DRY stone pitching etc all complete work

Supply of stone 22.5 mm thick

cost of solar street light etc all complete work .

Providing and laying in position cement concrete of specified gradeexcluding the cost of centering and shuttering - All wori< up to plinth level:1:2:4 (1 cement : 2 coarse sand (zone-Ill) derived from naturalS-Ources: 4 graded stoneaggregate 20mm nominal size derived fromnatural sources)

Providing ,supplying and fixing of RCC or sand stone banches of 3 seated size 6x1.5x2.5 of primuim quality with with ornament work on elevation etc all complete .

Earth work in excavation)manual means over areas (exceeding 30 cm in depth 1.5 m in width as well as 10 sqm on plan ) including getting out and disposal of excavated earth lead upto 50 m , as directed by Engineer- in - charge .( DSR CODE NO 2023 2.6.1)

Supply and fixing of decorative 40 to 45 Watt LED Post top indirect light luminaire having Pressure die cast aluminium body and Clear glass with driver set confirming to IP 65 and above protection complete in all respect. CAT-AAA

Supplying and laying of aluminium conductor PVC insulated armoured served sheathed cable 1100 volts grade at the depth of 750 mm bellow ground level over a cushion of 75 mm thick sand all around and protected with burnt bricks on side and on top .On surface the cable run shall be fixed on MS clamps etc.of suitable size or as directed by the Engineer-Incharge ,complete in all respect.The armouring of the cable shall be properly connected with the earth conductor by clamps etc.Following size size 10 sq mm x 2 core

size 35 sq mm x 3½ Core

Providing and laying in position cement concrete of specified gradeexcluding the cost of centering and shuttering - All wori< up to plinth level:1:4:8 (1 cement : 4 coarse sand (zone-Ill) derived from naturalS-Ources: 8 graded stoneaggregate 40mm nominal size derived fromnatural sources)

Centering and shuttering Including strutting. prppptng etc. and removal of fom,Suspended floors, roofs, landings, balconies and access plateforme etc.

Providing and laying in position ready mixed or sitebatched design mix cement concrete for reinforoed cement concrete work . admixtures in recommended proportions 1:1.5:3 excluding the cost of oentering, shuttering, finishing and reinforcement as per direction ofthe engineer-in-charge thecost of extra cement.Concrete of M25 grade with minimum cement content of 330kg /cum (DSR NO 5.33.1.1 )

Steel reinforcement for R.C.C work including straightening , cutting bending placing in position and binding all complete upto plinth level thermo- mechanically treated bars of grade fe - 500D OR more .(DSR NO 5.22.6)

Brick work with common burnt day ( non modular ) brick of class-150 in foundation and plinth in Cement morter 1:4 (1cement : 4coarse sand)

12 mm cement plaster of mix 1:4 ( 1 cement 4 coarse sand) (DSR NO 13.1.1)

P/L 80 mm thick interlocking

Structural steel work in single section, fixed with of without connecting plate, including cuting,hoisting, fixing in position andapplying a priming coat ofapproved steel primer all complete.(DSR NO 2023 10.2 ) Angle (50x50x6mm) Flat iron 32x6mm

P/L pvc condute pipe including all comp.

P/L Wall birla putty on decorated wall etc.all complete work . (DSR NO 2023 13.8 )

Painting of Railing and gate with enamel paint ect all complete work . (DSR NO 2023 13.6.1 )

S/F of 20 mtr Hight mast shaft of approved make with risking systeum hot dia glavanized inside & out side dip, heving pole sheet thickness 3 mm Top dia minimum 150mm, bottom dia minimum 310mm, base plat 25mm thick, suitable for wind velocity as per IS 875 part 3& having no circumferential weld,with accessories for high mast such as head frame suitable for 6 luminaries & its control gear boxes 0.75 HP power etc all comp.(PWD-2018.SI No. 21.3)

S/F of 25 sq mm 3-1/2 core Alu Conductor PVC insulated armoured served sheathed cable 1100 volts grade at a depth of 750 mm below ground level over a cushion of 75 mm thick sand all around and protected with burnt bricks on side and top. On surface the cable(PWD 2018 SI No.501(i))

S/F of 25 sq mm plain or pin type copper tin plated cable socket to the cable leads, insulating with tape and making connection etc. complete in all respect as per direction of the Engineer-Incharge (PWD 2018 SI No.504(e))

Boaring (Buggi) for Cabling work below 3.5 mt ground level including HDPE pipe (LNN Rate)

Road Cutting and Tailes reparing same (LNN Rate)

Supply and burring of Safe Earthing Electrode T-19 (Hot Dip Galvanized), length up to 2000mm, outer pipe 50mm, inner pipe 25, terminal Dia 12mm, outer GI pipe of 16 SWG and inner GI pipe of 12swg Hot Dip Galvanization up to 100 micron filed with crystaline conductive mixture (CCM) having anti corrosive & conductive property with 50kg activated soil (BFC) capable of reducing thr soil resistivity with good (PWD 2018 SI No.-725(A))

S/F of 40A TPN automatic street light cubical panel painted with anti corrosive alkali and acid proof paint consisting of time switch TSO-100 series contractors HRC fuses isolating switch metering instrument & instrument box with CTS etc all comp. (PWD 2018 si No.807(f))

S/F of factory wired integral LED floood light luminaires with die cast aluminium housing with toughend glass/UV stabilized PC Cover and lenses built with mandatory driver set suitable for 170 to 200 Watt.coirming to IP 66, IK 07 and above protection complete in all respect including Labour. 20400-24000 system lumens, High LED with lenses >120 Lm/W, P.F.>0.95, THD<10% at full load, CRI>70, Protection at 440V & >300V auto cut and re-start feature, 4KV internal Surge Protection,with 5 years warrantee

Please Enable Macros to View BoQ information