REPAIR TO SEWAGE LINES, COMPOUND WALL, FENCING AT KHETOLAI, NMACHANA, LATHIN, POKARAN AND GOMAT AREA UNDER AGE (I) POKARAN

Amount

Demolition of plain cement concrete (Un reinforced) in benching and surface channels,bedding etc above ground level.

Demolition of cement concrete bed in haunching and breaking up RCC drain pipes set in cement mortar of 150 mm Dia

Demolition of cement concrete bed in haunching and breaking up RCC drain pipes set in cement mortar of 200 mm Dia

Excavation in trenches n.exc 1.5m deep and n.exc 1.5m wide in manholes,etc. n getting out any type of Soil

M&L for plain cement concrete 1:4:8 Type D2 using 40mm graded aggregateas in foundation, filling in mass concrete for manholes & drains.

M&L for plain cement concrete 1:3:6 Type C2 using 40mm graded aggregateas in foundation, filling in mass concrete for manholes & drains.

M&L for plain Cement concrete 1:2:4 Type B1 using 20 mm graded aggregate as in benching and surface channel of Manholes.

M&L for plain cement concrete 1:3:6 Type C1 using 20mm graded aggregate as in coping including form work etc complete.

Demolition of stone masonry built in cement or cement lime mortar all as specified and directed.

M&L for squared rubble walling, Jodhpur type brought up to courses, well bonded, bedded and solidly hearted, built in cement mortar (1:6) all as specified & directed.

M&L for squared rubble walling, Jodhpur type brought up to courses, well bonded, bedded and solidly hearted, built in cement mortar (1:6) all as specified & directed, but except stone.

M&L extra for forming fair finished drain or channel 30 cm inner girth in cement concrete using extra cement incl, forms mould, mi-tred/stopped ends etc.

M&L for rendering 15mm thick in CM 1:4 on stone masonary sufaces including finished even and smooth using extra cement.

M&L for reinforced concrete NP2 drain pipes 150 mm Dia pipes confirming to IS laid in trenches and jointed in CM 1:2 all as specified & directed by EIC

M&L for reinforced concrete NP2 drain pipes 200 mm Dia pipes confirming to IS laid in trenches and jointed in CM 1:2 all as specified & directed by EIC

M & L for cutting in to existing manhole for connectiing new drain 150 mm bore , making good to pipe & renderring cutting out existing benching for & forming branch channel in cement concrete ( 1:2:4) type B1 smooth finished & reforming benching as requierd.

Returning filling in soil including spreading, levelling and well ramming in layers n.exc 25cm thick in layer etc all complete.

Removing excavated material n exc. 50 m and depositing where directed at a level n exc. 1.5 m above the starting point

Cleaning of manholes upto 1.00m depth by means of removing the silt, sludge, etc & baling out water complete manually or mechanically and removing the sludge to excceding 2 km from the camp area complete all as specified and directed by Engineer-in-Charge.

Cleaning of manholes exceeding 1.00m but not exceeding 2.00m depth by means of removing the silt, sludge, etc & baling out water complete manually or mechanically and removing the sludge to excceding 2 km from the camp area complete all as specified and directed by Engineer-in-Charge.

Cleaning of choked sewage lines of any bore of pipe including drains by roding and well flushing with water taking out waste materials any quantity and depositing where directed including covering the same with at least 30cm thick layer of soil all as directed by Engineer-in-Charge.

M&L for cleaning of septic tank of 50 users capacity by balling out taking out sludge and removing the sludge to a distance exceeding 2.00 km from the camp area including removing stone patti/ RCC cover slab and refixing complete all as specified & directed by Engineer-in-Charge.

M&L for cleaning of septic tank of 25 users capacity by balling out taking out sludge and removing the sludge to a distance exceeding 2.00 km from the camp area including removing stone patti/ RCC cover slab and refixing complete all as specified & directed by Engineer-in-Charge.

Dewatering and desludding of foul water and Slude from soakage wells/Septic tanks manually or mechanically as directed by Engineer-in-Charge. Note :- The actual volume of foul water shall be measured and paid in this item

M&L for removal of blockage in between WC and nahani trap/WC to 1st manhole/floor trap to nahani trap etc, by flexible roding and removal the all dirt upto a distance of 100m all as directed by Engineer-in-charge.

Dismantling of fencing wire mesh any type

Dismantling wrought iron or mild steel work of any description not otherwise provided for

Dismantling posts or struts (Wood, Steel or RCC), any section embedded in concrete, brick work etc. including taking out embedded portion and making good disturbed ground.

S&F Posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe 410-0 or Fe 310-0

Supply only Chain link MS galvanised fencing, any size or type

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire

S &F framed work as in doors or gates of angle or other section with gusset plates, rails, braces etc complete drilled for fixing of steel sheeting or other covering. Door etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings and decorative cast iron artical etc.

S&F in repairs galvanised, 2 strand, steel barbed wire 2.24 mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails, straining bolts, including securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins etc. as directed (each line of wire to be measured)

M&L for preparation of new or previously untreated steel surfaces of any description, not otherwise described, over 10 cm in width or girth and applying two coat of synthetic enamel paint over one coat of red oxide or zink chrome primer on new steel urfaces al as specified.

Demolition for precast concrete articles

Providing precast cement concrete louvres and jallies,Type B-0 1:2:4 (12.5 mm graded aggregate set in CM 1:4, 35mm thick (measured solid), including all mouldings but excluding frame (pre cast frame shall be measured separately and paid separatly)

Providing, Type B1 1:2:4 (20 mm graded aggregate, precast cement concrete , columns, posts, boundary pillars,with plain fair faces, including chamfers weatherings, throating etc. and setting in mortar complete with joints to match

M&L for preparing newly plastered surfaces of walls and applying two coats of cement base paint over a coat of white wash complete all as specified.

Dismantling of floors health or walls tiling and Stone floor including cement mortar bedded (but not backing) & removing serviceable tiles to store and rubbies of the premises

M/L PCC (1:4:8) type D-2 using 40 mm graded stone aggregate as in sub bases, 75 mm thick complete.

M&L for Chequered cement concre tiles 20 cm x20 cm x25 mm thick with mixture of grey & white cement in equal proportion, set, jointed and pointed in neat cement slurry in floors in coloured cement to match including screed bed 15 mm thick in CM (1:6) complete all as specified and directed

Dismantaling Stone slabs and tiles of any description or thickness in floors, aprons etc.

M&L 20 mm thick Granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite.

M&L for jodhpur stone roof slabs, self faced 7.5cm to 10cm thick, 25cm to 35cm wide, hoisted, set, jointed and grouted in lime mortar 1:3 or cement mortar 1:6 complete complete all as specified and as directed by the Engineer-in-Charge

M&L for 05 cm thick Jaisalmer stone slabas in chajjas/ shelves, cills, landings, manhole cover stones, etc and like n exc 2.00m in length, punched dressed on face and along exposed edges, self faced on other side and set & pointed in cement mortor 1:4, complete all as specified.

M &L for Machine pressed precast concrete, With grey cement and pigments, interlocking paver block any shape and size confirming to IS 15658-2006 of 60mm thickness, M-35 Grade.

M&L for Sand filling under floors or in foundation including watering and consolidation

M&L For Type B1 1:2:4 (20 mm graded aggregate) Providing, cement concrete in kerbs of mud stops, rounded or chamfered on edges

Dismantling of cast iron RCC, AC or PVC pipe jointed in CM any 100mm dia bore

PVC (SWR) floor trap, plain with grating including jointing with solvent cement 75 mm dia out let

S&F PVC (SWR) pipes of 110 mm dia, single socketed fixed to walls

S&F PVC (SWR) pipes of 75 mm dia, single socket fixed to walls

S&F 100 bore of pipe stack clamps out of 50 mm by 5 mm flat iron and 16mm dia round iron stays, including bolts and nuts and securing ends of stays to wall or roof.

S&F PVC (SWR) bends with access door of 110 mm dia, any radius

S&F PVC(SWR) bends with access door of 75 mm dia, any radius

S&F PVC (SWR) bends of 110 mm dia, any radius

S&F PVC (SWR) bends of 75mm dia, any radius

(PVC (SWR) vent cowl, 100 mm dia

Providing precast cement concrete 1:2:4 Type B1 using 20 mm graded aggregate, in cover slabs (for man holesetc.) Set in CM 1:6 completed.

M&L for TMT steel bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire(annealed) not less than 0.9mm dia orsecuring with clips

M/s Shri Inder Construction Company

rathore construction co.