SPL REP REPLACEMENT OF OVERHEAD LINES INTO UNDERGROUND CABLE AT HAMID ENCLAVE AND KHULNA MARG 03 INSTLN SPL REP FOR IMPROVEMENT OF ILLUMINATION AND CONVERSION TO LED 02INSTLN AND PROVN OF CHAIN LINK FENCE FOR BLDG NO P282 DGNCC 49 MW AT SI LINES

Amount

Excavation in trenches/ foundation in soft/ disintegrated rock not exc. 1.5 metre wide and n'exc. 1.50m deep for LT under ground cable/pole foundation and getting out including forming bottom surface to required level or slope, complete all as specified and directed.

Returning filling including spreading leveling watering and well ramming in layers not exc 25 Cm in soft/ disintegrated rock, complete all as specified and directed.

Removing excavated material in soft/ disintegrated rock n'exc 50M and depositing where directed at a level n'exc 1.5M above the starting point, complete all as specified and directed.

M&L for sand filling with clean dry fine sand unwashed including gently punning around cables in trenches for cable protection (8 cm below cable & 15 cm above cable) complete all as specified and directed. Note:- Compacted/punned thickness shall be measured & paid.

Supplying and laying reinforced precast concrete cable cover, class LV, flat of size 250mmx150mmx40mm complete all as specified and directed. Make: Mehtab tiles or equivalent make as per list of make as approved by GE.

Supply and Laying cable XLPE Insulated screened PVC bedded, galvanized steel strip or wire armored, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor laid in trenches or fixed on wall with the help of shadel of following sizes complete all as specified and directed. Make : Polycab / Havells India Ltd/ RPG cables Ltd or equivalent make as per list of make as approved by GE.

120 sqmm 3.5 core

95 Sqmm 3.5 core

70 Sqmm 3.5 core

50 Sqmm 3.5 core

25 Sqmm 4 core

10 sq mm 4 core

Supplying & erecting of steel tubular swaged type electric pole conferrming to IS, specification complete with base plate, welded top cap over all vertical length 9.00 mtr type 410-SP-31 including painted two coats of bituminous paint through out in portion embedded in PCC and externally painting with one coat with alluminium paint over a coat of red oxide primer including provision of black and yellow of 05 Nos of 30 CM each strip or as ordered by engineer-in-charge on poles up to 1.5 mtr high above coping level and numbering of poles with feeder location complete all as specified and directed. Note - PCC shall be measured and paid separately.

M&L for cement concrete 1:4:8 type D-2 using 40mm graded stone aggregate in foundations, filling and mass concrete complete all as specified and directed.

M&L for Cement concrete 1:3:6 type C-2 using 40mm graded stone aggregate in foundations, filling and mass concrete including filling at road cuttings or making pillars for supporting pipe including necessary form work complete all as specified and directed.

M&L for cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate in copings to poles & the like, etc including weathering, slightly rounded or chamfered angles and throating as directed. including necessary form work complete all as specified and directed.

Supply and jointing heat shrinkable outdoor type LT Straight through joint kits for XLPE/PVC insulated LT armoured cable 3.5 core complete with lugs complete all as specified and directyed. Make: 3M/ Raychem/ Denson or equivalent as per list of make as approved by GE

25 sq mm to 50 sqmm

70 sq mm to 95 sqmm

Supply and fix PVC insulated and sheathed copper multistranded cable 3 core 1.5 sq mm, heavy duty through or on pole connecting to cable looping box of street light fitting complete all as specified and directed.

Supply and fix FRP cable looping boxes with PVC sheet finish including one 6 amp MCB , 10 KA breaking capacity , C curve series, heavy duty connector for connection of 4 core cable and fixed to pole with suitable size flat iron clamp , nuts, bolts complete all as specified and directed by Engineer in charge .Make: Sintex/ Hensel or equivalent as per list of make as approved by GE

Supplying & laying in road cutting and along pole 40 mm nominal bore, light grade, galvanised steel tube conforming to IS 1239 (Part-1): 2004 including all fittings conforming to IS 1239 (Part-2): 2011 complete all as specified and as directed.

Supplying & laying in road cutting and along pole 50 mm nominal bore, light grade, galvanised coated steel tube conforming to IS 1239 (Part-1): 2004 including all fittings conforming to IS 1239 (Part-2): 2011 complete all as specified and as directed.

Supplying & laying in road cutting and along pole 100 mm nominal bore, light grade, galvanised coated steel tube conforming to IS 1239 (Part-1): 2004 including all fittings conforming to IS 1239 (Part-2): 2011 complete all as specified and as directed.

M&L for drilling suitable holes for inserting /laying of 100/50/40 mm bore GI pipe of any description below/under existing road surfaces/aprons/floors etc etc with using mechanical/ manual devices as required at site including making good the disturbed surfaces to match with the existing after laying pipes complete all as specified and directed.

M&L for earthing complete with galvanised steel plate earth electrode 600 mm X 600 mm X 6 mm thick, buried directly in ground (earth pit not less than 2.25 metres deep below ground level) with top edge of the plate not less than 1.5 metres below normal ground level, connected to galvanised earthing strip of dimension 32X6 mm by means of bolts, nuts, check nuts and washers of galvanised iron from earth plate to test point upto 7.5 metre including all as shown in electrical plate No. 3 of SSR Part I (2009) including necessary concrete chamber in cement concrete M15 (Nominal Mix) using 20 mm nominal size coarse aggregate, precast RCC cover slab in cement concrete M15 (Nominal mix) using 20 mm nominal size coarse aggregate of size 40 cm X 40 cm X 5 cm reinforced with 8 mm dia TMT bars @ 150 mm c/c both ways with one handle for lifting made out of 8 mm dia bar, GI funnel, GI wire mesh filter, 20 mm dia GI pipe medium grade for watering, 20 mm dia GI pipe medium grade for protection of earthing lead, charcoal or coke and salt in alternate layers including necessary excavation and earth work in any type of soil/ strata and testing complete all as specified and as directed by the Engineer-in-charge. NOTE :- (i) The unit rate includes the cost of GI pipe medium grade for protection of earth strip and 32x6mm earh strip upto 7.5 M. (ii) PCC pit shall be provided at least 500 mm away from the pit and not on the earth pit itself.

Dismantling cross arms of MS channel or angle sections etc from LT OH Line, complete all as specified and directed.

Dismantling insulators of LT OH Line any type, any size, complete all as specified and directed

Dismantling ACSR conductor, any type complete all as specified and directed

Dismantling concrete poles/struts, any size complete all as specified and directed

Dismantling steel poles/struts, any size complete all as specified and directed

Taking down old defective /unservicable HPSV/MH street light fitting/ Led light fitting of any wattage for replacement with new fitting, including provision for new LED drivers for servicable LED fittings through ladder/motorised /manual system, mounted on pole/bldg, on bracket complete all as specified and directed. Note : (i) No T&P will be issued by the Department. (ii) While execution of work, contractor must ensure proper safety precaution. (iii) The cost for new LED drivers / new LED fittings will be measured and paid seperately under respective items.

Taking down defective 150/250/400 Watt high mast / Flood light fitting consisting of SV/MH lamp (Aprox 6 to 8Nos) through ladder /motorised /manual system, mounted on any height of high mast pole on bracket/ round ring, disconnecting, replacing with LED fitting complete all as specified and directed. Note : (i) No T &P will be issued by the Department. (ii) While execution of work, contractor must be ensure proper safety precaution. (iii) The cost for new LED fittings will be measured and paid seperately under respective items.

S&F Integral LED Street light luminaire of 90W, comprising of epoxy powder coated housing, enclosed with glass cover in frame, IP 66 protection and with all fixing arangement like brackets (to be fixed on pole), clamps, nuts, bolts and washer connecting to electric system with 2.5 sqmm PVC Aluminium stranded conductor 2 core upto require length, on pole, testing on completion, complete all as specified and directed. Make: Bajaj CAT NO -BRTFG90WLEDCR or equivalent as per list of make as approved by GE.

S&F Integral LED High mast / flood light luminaire of 200W, comprising of epoxy powder coated housing, enclosed with glass cover in frame ,IP 66 protection and with all fixing arangement , nuts, bolts and washer connecting to electric system with 2.5 sqmm PVC Aluminium stranded conductor 2 core upto require length,on pole , testing and completion, complete all as specified and directed at site. Make: Bajaj Cat No : BJFL200WLED or equivalent as per list of make as approved by GE.

Supply, Laying, commissioning and testing of UG LT cable XLPE insulated screened PVC bedded, galvanized steel strip armored, electric power cable (heavy duty) 1100 volts grade with stranded aluminium conductor of size 16 sqmm 4 core including taking out old cables and removing from site complete all as specified and directed.

Excavation in trenches in any type of soil not exceeding 1.5 mtr wide and n.exe 1.5 mtr depth including getting out complete all as specified and directed.

Returning filling in including spreading, leveling, and well ramming, in layers not exceeding 25 cm each layer of any type of soil complete all as specified and directed.

Removing surplus excavated material (soil) from site not exceeding 50 mtrs from starting point and depositing where directed at level not exceeding 1.5 mtr above the starting point complete all as specified and directed.

Supply and laying brick of suitable dimension modular size for LT cable protection including removing old existing burnt bricks complete all as specified and directed.

S&F in replacement Integral LED Street light luminaire of 120W, comprising of epoxy powder coated housing, enclosed with glass cover in frame, IP 66 protection and with all fixing arangement like brackets( to be fixed on pole), clamps , nuts, bolts and washer connecting to electric system with 2.5 sqmm PVC Aluminium stranded conductor 2 core upto require length, on pole, testing and completion, complete all as specified and directed at site. Make: Bajaj CAT NO -BRTFG120WLEDCR or equivalent as per list of make as approved by GE.

Excavating in post holes (or similar holes) in soft/disintegrated rock each not exceeding 0.5cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering and removing surplus material to a distance not exceeding 50m and making good surface complete all as specified and directed.

M&L for mild Steel section in posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire etc, flat iron fillets (for securing wire mesh etc) including, bolting or riveting, etc, and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

Fixing only chain link MS galvanised fencing any mesh, size and any type of standards, rails, straining bolts, etc. including provision of binding wire as specified and directed by Engr-in-charge

Supply of chain link MS galvanised fencing PVC coated, any mesh, size and any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified and directed.

S&F 10mm dia mild steel screw bolts (machine made) with square or hexagonal heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and hexagonal or square nut, length of bolt exc 5cm but n.exc 10cm long fixed complete all as specified and directed.

S&F mild steel round bars conforming to Gde 1 (IS: 432 part-I) 5 to 10mm dia as in stiffeners in chain link fencings etc complete all as specified and directed.

M&L for preparation of new surfaces of steel any description n exc 10cm in width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

M&L for preparation of new surfaces of steel any description over 10 cm in width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

M&L for Brick work with sub class ‘B’ bricks (Modular), straight or curved on plan exceeding 6m mean radius, built in cement mortar 1:6 complete all as specified and directed.

Supply only Integral water profing compound complete all as specified and directed.

M&L for 15 mm thick rendering in cement mortar 1:6 on fair aces of bricks walls surface finished even and smooth without using extra cement including water proofing compound all as specified and directed. (water proofing compound shall be measured and paid seperately)

Schedule of credit (calculation will be done off line) Rs. 65140.00

Jyoti enterprises

Auto Traders