Nit No. 43 Item No. 01

Amount

Supplying and fixing 5 A to 32 A rating, 240/415 V, 10 kA, "C" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required.

(a) single pole

(b) Triple pole & Neutral

Supplying and fixing following rating, double pole, 240 volts, isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required. 40 amps

Fabrication, Supplying, installation and commissioning of Canopy type floor mounted panel of size 650mm X 850mm X 300mm deep board made out of 2mm thick MS Sheet with 600mm long legs of angle iron (50mm x 50mmx 5mm) having double doors, with 2 No. MV Danger Notice plates fixed on front doors i/c painting, connection, installation in cement concrete complete with locking arrangement and suitable to accomodate control panel/starter, single phase preventor, MCB DB, Energy meter etc. complete as reqd.

Providing and fixing of canopy door 1 nos. of size 410mm x 560mm made out of 2mm thick MS Sheet along with locking joint duly welded at front along with 1 nos. of brass butt hinges(light/ordinary type) of size 100x 70x 4 mm and welding the same on existing canopy body

P&F of following sizes of PVC insulated & PVC sheathed copper conductor 3 core submersible cable confirming to IS.694/1990 etc. as reqd. (a) 3 x2.5 sq.mm.

(b) 3 x4 sq.mm.

(c) 3 x6 sq.mm.

SITC of cubical type control panel board for single phase & Three Phase submersible pumping set of following rating complete with contactor, relay MCB , condenser, voltmeter, ammeter and indication lamp etc including connection etc. as reqd.

(a)1.5.HP (Single Phase)

(b)3.0.HP (Single Phase)

(c)5.0.HP (Three Phase)

(d)7.5.HP (Three Phase)

Supplying, lowering and fixing following size of G.I. Pipe (M- Class) i/c cutting threading on both sides etc ISI marked etc as reqd. (a) 32 mm (Nominal Bore)

(b) 40 mm (Nominal Bore)

(c) 50 mm (Nominal Bore)

S& F following sizes of GI Elbow as reqd. (a) 32 mm

S&F following sizes of GI socket as reqd. (a) 32 mm

S&F following sizes of GI union as reqd. (a) 32 mm

Lifting the existing submersible pump set 1 to 5 HP with all accessories from well and lowering the same from following depths complete as reqd. (a) from depths up to 40 meters deeps

(b) from depths more 40 meters upto 60 meters

Rewinding of single / three phase A.C.motors of vertical type multi stage submersible pump set (Dismantled material will be retained by contractor) of following ratings:- (a) Single phase 1.5 HP,

(b) Single phase 3 HP,

(c) Three phase 5 HP,

(d) Three phase 7.5 HP

Development Of tubewell with suitable capacity of air compressor i/c lowering of the necessary induction pipe or line i/c cost of fuel, hire charges of compressor etc as reqd. The development shall be considered complete when gravel stop sinking, Discharge ceased to improve and the sand contents are not more than 10 PPM after 20 minutes of starting the Pump complete as reqd.

Repairing of the Pumping unit of the Single phase (100 mm), vertical type, multistage, submersible pump set by replacement of following accessories/ parts etc compete as reqd. (a) Gun Metal Bush / Bearing.

(b) Pump Shaft.

(c) Impeller

Repairing of the Pumping unit of the Three phase (150 mm), vertical type, multistage, submersible pump set by replacement of following accessories/ parts etc complete as reqd. (a) Gun Metal Bush / Bearing.

(b) Pump Shaft.

(c) Impeller.

SWASTIK ELECTROTECH PRIVATE LIMITED