GE(W)/HSR-54/2021-22 SPECIAL REPAIR TO EXISTING RAW WATER TANKS AT EBS AT HISAR MIL STN UNDER GE (WEST) HISAR

Amount

Complete dewatering of raw water tanks of capacity 17.50 lakh gallon by up to FFL vaccum process closed tankers, tractor driven and disposling off raw water to a distance exceeding 1.5km but not exc 5km at places incl continuos pumping/dewatering till the work has not been complete all as specified and directed

Excavating over areas, n exc 1.5 m deep and getting out in hard/dense complete all as specified and directed

All as per above item Ser No 2.00 but n exc 3 mtr complete all as specified and directed

All as per above item Ser No 2.00 but n exc 4.5 mtr complete all as specified and directed

All as per above item Ser No 2.00 but n exc 6 mtr complete all as specified and directed

M&L PCC 1:4:8 type D2 using 40 mm graded stone aggregate in foundations, filling and mass concrete, floor sub base etc. surface fair finished even & smooth without using extra cement complete all as specified and directed

M&L for concrete M-30 design Mix (20mm graded aggregate) as in foundation any thickness complete all as specified and directed

M&L for concrete M-30 design Mix (20mm graded aggregate) retaining wall any thickness above top footing including pilasters and buttress complete all as specified and directed

S&F mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking bending spirally for hooping for columns hooking ends and binding with and including mild steel wire complete all as specified and directed

All as per above item No 9.00 but in stirrups 6 to 8 mm dia complete all as specified and directed

S&F for formwork to face of wall/retaining wall and similar work for including attached pilaster, buttresses or better in flat surfaces complete all as specified and directed

S&F for formwork to face of wall/retaining wall and similar work for including attached pilaster, buttresses or better in curved surfaces complete all as specified and directed

Removing excavated material not exc 50 mtr and depositing where directed at a level not exc 1.5 mtr above the starting point complete all as specified and directed

Returning & filling including spreading levellling watering and well ramming in layers n exc 25 cm complete all as specified and directed

Demolition of cement concrete in ground floor/ paving not exceeding 15cm thick below or above GL unreinforced complete all as specified and directed

Demolition of brick work built in cement mortar including all quoins arches pillars etc all complete all as specified and directed

M&L cement concrete type D-2 1:2:4 (using 20mm graded aggregate) as in foundations, filling and mass concrete, floor sub base etc. surface fair finished even & smooth without using extra cement complete

M&L for brick work with sub class 'B' brick in brick on edge wall in CM 1:3 complete all as specified and directed

M&L for brick work with burnt bricks straight or curved in plan exceeding 6 mtr mean radius with old size bricks in cement mortar 1:3 complete all as specified and directed

M&L providing PCC type B 1:2:4 (using 20mm graded stone) in window or door cill lintels stepsstring courses coppings etc complete all as specified and directed

M&L for flush pointing in CM 1:3 to brick wall complete all as specified and directed

M&L raking out joints/pointing to brick work in walls to bricks on edge in floor surface channels, roofs etc in CM complete all as specified and directed

Demolition of cement concrete in ground floor/paving not exceeding 15 cm thick or above GL unreinforced complete all as specified and directed

M&L cement concrete type D-2 1:4:8 (using 20mm graded aggregate) as in foundations, filling and mass concrete, floor sub base etc. surface fair finished even & smooth without using extra cement complete all as specified and directed

M&L for 100 mm thick PCC 1:2:4 type B2 using 40mm graded stone aggregate) flooring ,surface finished even and smooth with using extra cement, complete all as specified and as directed.

Forming construction Joint 30mm deep X 10mm wide filled with sealing compund grade 'A' complete all as specified and directed

Dismantling posts or struts (wood, steel or RCC embedded in concrete, brick work, masonry etc. any section including taking out embedded portion and making good disturbed ground. complete all as specified and directed

Excavating in post holes (or similar holes) each not exc 0.50 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers n.exc 25cm, in hard dense soil complete all as specified and directed

M&L for posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire etc., flat iron fillets drilled and countersunk for blusters running bars, nosing to steps incl embeding in concrete and screwing etc wind ties for roof including securing bolts and similar work conforming to Gde E-165 (Fe 290) complete all as specified and directed.

M&L mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, length of bolt not exc 5 cm and dia of neck 11 to 15 mm complete all as specified.

Preparing new steel surface of any description and applying one coats of red oxide primer for post embedded in ground complete all as specified and directed

Preparing new steel surface of any description over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed

Dismantling of chain link fencing barbed wire fencing & wire mesh etc any type

Supply only Chain link MS galvanised fencing any size or type complete all as specified and directed

Fixing only mild steel galvanized chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts etc. including provision of binding wire. complete all as specified and directed

Taking up cast iron water mains (including all fittings) 200 mm bore with spigot and sockets ends and lead joints including burning out joints and recoverina lead complete all as specified and directed

Supply and lay pipe ductile iron S/s including special Class -K 9,300 mm dia complete all as specified and directed

Supply laying and jointing cast iron sluice valve of class PN 1.6 IS-14846 makred 300 mm bore with steel spindle & cast iron wheel having both flanged and drilled ends including rubber gasket nut bolt and washers heavy duty 16mm diat etc and including taking down complete all as specified and directed

M&L cast iron DI fittings or specials for flanged spigot soketed and pipe up to 30mm bore conforming to IS-1538 and ISI marked such as bends, tapers tee pieces (single and double branch) any type and angle/radios and straight connecting pieces but all ends flanged complete (joints excavation and eath work shall be measured and paid separately)complete all as specified and directed

moti construction company

Shiva Constructin Co.