Providing and Applying Floor Marking Paint and Numbering on Vendor Sites Under Roads Division No. 1, M.C. Chandigarh

Providing and applying cement base putty of 1 mm thickness over paver block surface to prepare the surface even and smooth complete in all respect and as per complete satisfaction of Engineer in Charge.

Marking parking bay lines, arrows, lines etc. suitable for use on concrete surfaces of one coat of primer with hardner ratio 75:25 and two coats epoxy paint with hardner ratio 75:25 make Asian paints, Nerolac, or equalent at all locations prepared and applied and preparation of surface (surface to be over coated must be dry and free from debris before commencement of coating. Dry brushing should be done to remove dirt and dust. A fresh water wash is to be done if required) as per manufacturer technical specification and including 2 year warranty satisfaction of Engineer-in-charge.

Letter writing with 10cm hieght on paver block surface with paint of approved brand by Engineering in charge and complete in all respect.

Providing and fixing M.S Angle 75x75x6 mm frame board of height 12 feet and width 9 feet. The CRC sheet of 16 gauge of size 8.33 feet x 2 feet is to be welded on top side of the frame. The frame is to be fixed on ground with 2' long anchorage in cement concrete 1:2:4 block size 1'x1'x2' (Depth). The rates also inclused one coat of steel primer with two coat of special quality paint of approved shade and further writing the approved write-up on one side of the board as per the direction of EIC, complete in all respects as per drawing & job to the entire satisfication of Engineer- in-Charge.

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade : One or more coats on old work. (DSR 14.54.1)