Construction of Auditorium building at HIPA Fairlawn Shimla SH Providing central heating system therein

Amount

Supply installation testing and commissioning of electric element type hot water boiler /generator complete with s tank, cylindrical shell 10mm with dished ends,sheet metal enclosure, integral electrical and control panel i/c all operational and safety controls. The Boiler shall be Horizontal type capacity of 86000Kcal/hrcapacity, bank will consist five steps with micro processor intelligent step controller , scr controller and reverse flow sensor, interlockig arrangement acessories i/c making cc foudation and complete in all respects: (Make: Rapid Cool, Model Dx, Dyna Flow )

Supplying, installation, testing & commissioning of hot water couple pump set having mechanical seal, GM impeller suitable to deliver minmium 10 LPS at 18 mtr head coupled with Squirrel cage /TEFC induction motor & making suitable CC (Cement : Concrete) foundation , connection etc. as required. (Make:- Kirloskar/ Crompton/ KSB.)

Supplying, installation, testing & commissioning of make up water selfpriming coupled pump set having mechanical seal, gun metal impeller suitable to deliver min 120LPM at 25 mtr head 2900 RPM with Squirrel cage /TEFC induction motor & making suitable CC (Cement : Concrete) foundation , connection etc. as required. (Make:- Kirloskar/Crompton/KSB)

Supply, installation, testing and commissioning of hot water piping and fittings complete with supports, hangers and specified insulation thickness. All piping shall be black mild steel Class C, ISI marked with fitting. The unit rate of piping shall include this support arrangement and hangers i/c wooden isolator where required under insulation at support points.The piping shall be insulated with 80Kg/ M.Cub. section density fiberglass insulation finally covered with 26 gauge Al. Cladding for inside and 6mm plaster for outside complete as required

80 mm pipe with 75 mm insulation.

62 mm pipe with 75 mm insulation.

50 mm pipe with 75 mm insulation.

38 mm pipe with 50 mm insulation.

32 mm pipe with 50 mm insulation.

25 mm pipe with 50 mm insulation.

19 mm pipe with 50 mm insulation.

Supply, installation, testing and commissioning of Gate valves/ Sluice/Glove/ Butterfly valves ISI marked, with flanges or screwed ends as required. Valves 65 mm and above shall of C.I. IBR86 Body Grade A , with flanged ends and gunmetal trim, yoke type -rising stem ,P N. 1.6 and i/c flanges and valves upto 50mm shall be gunmetal flenged ends non rising stem, integral seat, body test pressure 50kgf/cm Hyd. (MAKE: KRILOSKAR/SANT/LEADER)

Supply, installation, testing and commissioning of Swing Check valve straight type ( BS 5153) class 125 body material cast iron IBR86 to 93Grade A bolted cover renewable seat , renewable disc SS trim working pressure 10.54 kg/cm with flanged ends i/c flanges complete as required. (MAKE: KRLOSKAR/SANT/LEADER)

Supply, installation, testing and commissioning of Y type Stainer, body material cast iron IBR 86 to 93 Grade A bolted cover SS304 trim working pressure 150 psi with flanged ends and tested to 150PSI i/c flanges. (MAKE: KRLOSKAR/SANT/LEADER)

UNITECH ENGINEERS