MTPS I Mill Plant AC Plant Unit III AOH 2025 26 Air Washer System Epoxy painting of blowers and its auxiliaries enamel painting of AWCW Pumps pipe lines Spray nozzles flushing works Overhauling the Blower 3A 3B Damper box AWCW Pumps and gate valves

Amount

Charges for dismantling the casing cover of blowers 3A & 3B for painting and reassembling after completion of painting works.

Charges for scratching and cleaning, painting with epoxy zinc Phosphate /Aromatic Polyurethane primer one coat and epoxy smoke grey paint two coat for structures, spray room tank pipes, eliminator frame, water strainer structure, AWS Blowers 3A & 3B, dampers and ducts.

Charges for dismantling the water spray nipples and nozzles from the pipe line and scratching & cleaning and then re-fixing in the pipe line.

Charges for flushing the spray system pipe line

Charges for Pump complete overhauling and changing the worn out spares parts if necessary.

Charges for Refitting the pump with both suction and discharge pipe flanges with new gasket, coupling the motor with pump, checking axial and radial misalignment between pump and motor and completing the alignment within the prescribed limits and commissioning satisfactory.

Charges for Dismantling the Valves from the pipe line and Overhauling and then refitting of 250 mm / 200 mm AWCW Pump suction and discharge side Gate valves and cleaning of seating surface and lapping of valve gate and seat for perfect matching.

Charges for fixing the canvas cloth bellow joint in the Air Washer fan discharge line inside the Air Washer room(Blower 3B ).

Charges Painting of one coat of red oxide enamel paint after scratching and cleaning, then paint one coat of green enamel paint for circulating water system pipes of AWS.

DAMPER BOX i) Fixing the MS angle inside the damper box to hold the leaves and drilling for holes for damper box.

ii) Welding the MS Plate drilling holes in the damper bolts.

iii) Dismantling the existing damper box from blower unit for damper box.

iv) Erecting the new damper leaves with the blower unit for damper box.

Machining of SS rod for 12 mm dia drilling holes to the required size

Machining of bronzed bush of the required size

Charges for cleaning inside and outside of the air washer duct in the BFP Floor, switch gear control room and disposing the dust particles by gunny bag to outside the plant

Charges for devolution of the scrap materials to Central store (lorry will be supplied by TNPGCL).

Cost of Zinc Phosphate /Aromatic Polyurethane Epoxy Primer

Cost of Epoxy paint smoke grey

Cost of Epoxy Thinner

Cost of Red oxide primer

Synthetic Enamel ( Green color )paint

Canvass cloth Cost of Canvas cloth

Cost of GI bolt (8 mm X 25 mm length) with nuts and GI washer

DAMPER BOX SS Rod Dia 12 mm for 28 sets 14 mtrs length

25 mm bronze rod for machining bushes 2 mtrs

GI bolts & nuts with washers to fix the damper leaves with SS rod.

(GI 18 SWG) damper leaves

GI bolts (10 mm X 40 mm) with washers

One set of cutting gas

Charges for consumables and T & Ps for Sl. No. 1 to 17

T S CONTRACTOR (BID ID -1389720)