FEB WORK 01

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and for all lift, as directed by Engineer-in-charge.DSR-2023, 2.6.

Provinding and laying cement concrete 1:4:8 (1 Cement: 4 coarse sand derived from natural sources: 8 graded stone aggregate 40 mm nominal size derived from natural sources).DSR-2023, 4.1.8.

M150 brick work Designation 7.5 in foundation and plinth in: Brick work with common burnt clay F.P.S. (non modular) bricks of class.DSR-2023,6.1.1.

1:2:4 (1 Cement: 2 coarse sand (zone-III) derived from natural sources: 4 graded stone aggregate 20 mm nominal size derived from natural sources).DSR-2023, 4.2.3.

Reinforced cement concrete work in walls (any thickness), including attached pilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers, abutments, posts and struts etc. above plinth level up to floor five level, excluding cost of centering, shuttering, finishing and reinforcement:1:1.5:3 (1 cement: 1.5 coarse sand (zone-III) derived from natural sources: 3 graded stone aggregate 20 mm nominal size derived from natural sources).DSR-2023, 5.2.2

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete above plinth level.Thermo-Mechanically Treated bars of grade Fe-500D or more.DSR-2023, 5.22A.6

Construction of granular sub-base by providing close graded material spreading in uniform layer with mortor grader on prepared surface including compaction complete as per technical specification clause 401

Construction of un-reinforced, dowel jointed, plain cement concrete pavement over aprepared sub base with approve grade cement @ 400 kg per cum, coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, laid with a fixed form or slip form paver, spread, compacted and finished in a continuous operation including provision of contraction, expansion, construction and longitudinal joints, joint filler, separation membrane, sealant primer, joint sealant, debonding strip, dowel bar, tie rod, admixtures as approved, curing compound.

Supply and fixing of Leg Press as per attached detail and specifications.

Supply and fixing of Cross Walker as per attached detail and specifications.

Supply and fixing of Chest Press Pull Chair as per attached detail and specifications.

Supply and fixing of Cycle/Arm Paddle Bike as per attached detail and specifications.

Supply and fixing of Abdominal Board Double as per attached detail and specifications.

Supply and fixing of Waist Twister as per attached detail and specifications.

Supply and fixing of Swing Two Seater as per attached detail and specifications.

Supply and fixing of Arm Wheel as per attached detail and specifications.

Supply and fixing of Air Walker as per attached detail and specifications.

Supply and fixing of Chin Up and Dipping Bar as per attached detail and specifications.

Supply and fixing of ROTO wave slides 5 feet height plateform as per attached detail and specifications.

Supply and fixing of Standard seesaw as per attached detail and specifications.

Construction of Padustrial Board (1.20x0.75)m size all complete.

Please Enable Macros to View BoQ information