Loading
Loading…
Loading…
Tender Value
₹99.7 L
EMD Value
₹2.0 L
Closing Date
24 Aug 2026, 3:00 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
Above/Below/Par
GSUBKN
14 conditions · 3 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N or 'V' whichever is less; where V= Advertised value of the tender in crores of Rupees, N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIII, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
Any RRI/PI/EI/MACLS Supply, Installation Testing, Commissioning Signalling work OR Any RRI/PI/EI/MACLS Alterations Signalling work OR Any CTC/TMS Work
5 conditions · 1 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
If the bidder fails to submit copy of audited balance sheet alongwith the offer then contractual turnover of that year will be treated as NIL
S&T associated work for the provision of Tower wagon siding at Raman (RMN) station in HSR-BTI section of Bikaner Division.
SnT-GS-BKN-2026-27-01
SnT-GS-BKN-2026-27-01
Open
Works - General
12 Months
Bikaner, Rajasthan
₹0
₹2.0 L
24 Aug 2026
31 Jul 2026
10 Aug 2026
109 items across 11 schedules · ₹99,73,485.02 total
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| manufacture and supply of Hot Architecture Electronic (EI) system complete as per specification No. RDSO/SPN/192/2019 Ver. 2 or latest, as per requirement & tentative Signalling Plans & Diagrams. Interlocking (EI) system mainly i n g of Central Processing Interface Equipment/Relays etc requirements, Dual operator Grade VDU panel (42" LED) with nc y (Hot stand-by dual VDU one system online and other standby mode), All Interfacing suitable for EI, interconnecting Jumper wires, Industrial grade Terminals (32'' LED with UPS 1 hr back up), required power converters for EI equipments, for EI equipments and Relay screw less disconnecting type fixture mounting arrangements accessories necessary to make the EI functional as per approved plan. The tenderer should furnish details of cards/ modules/ sub- connectors etc. for each station. 10% Essential spares of the EI subject to minimum one of mainly consisting of processor, module, interface relay etc. Item detailed break up with unit and to be provided in separate (THIS ITEM SHALL BE USED ALTERTION WORK IN EXISTING RDSO Inspection charges: Railways Payment terms:100% | — | — | — | — | |
| 1 | with routes less than 100 | Per Functional Vital Bit | 20.00 | 1,05,893.14 | 21,17,862.8 |
| 2 | wiring, programming, testing commissioning of EI equipment as per supply item in item no. above of Chapter 1 of this SOR transportation from Consignee's site. The works and materials for wiring, testing and grouting, cutting of floors, refilling of the same, re-plastering, CC/ masonry works, fixing/ laying of insulated ladders/ casing- cable trays/ RCC/GI pipes / Cables, of cables with lugs/ connectors, lettering are to be provided/ done contractor for the equipments vide item no. 01010400 of of SOR. This also covers the of built in EI Data loggers of all to monitor the system to any where desired by Engineer-in- (THIS ITEM SHALL BE USED ONLY ALTERTION WORK IN EXISTING EI) Installation shall be complied to Technical Advisory Note No dtd. 28.08.2014. wiring, programming, testing commissioning of Operator VDU in Hot with Redundancy. Any Equipments/cards/Modules required for Hot with Redundancy shall be and Installed by the Contractor. also includes supply of Two nos. computer and printer table work station table) and one no make operator chair model Termination of indoor/ PIJF relay room on relays, tag blocks, as per approved wiring diagram alterations/ modifications as site. Soldering to be done at all termination. Dressing/ lacing of be done neatly with help of thread / plastic self lock strip of size. The tools/ equipments/ simulation boards required for shall be supplied / fabricated by This includes replacement of cards/ LEDs/ equipments going during testing. Necessary power boards with required capacity plugs, surge and lightning protection be supplied and installed by contractor. 230V supply shall be by Railways. In case supplies are to be extended, from Power room then same shall be extended contractor with his own materials 1X16 sq mm wires, cables, lugs, pipes, insulated ladders etc. After testing, Factory Acceptance Tests Square Sheet testing system fault free while submitting to otherwise suitable necessary be taken by Engineer-in-charge. Consignee, Inspection charges: Payment terms: 100% after | Job | 1.00 | 6,53,241.66 | 6,53,241.66 |
| 3 | preparation & supply of drawings in print copies and original tracing CAD FORMAT for Electronic at each station. After of the work, the completion incorporating completion details be supplied as per Technical given in tender document Line). The technical specifications ANNEXURE-01010100 of SOR. Consignee Inspection charges: Payment terms: 100% after | Station | 1.00 | 2,11,776.71 | 2,11,776.71 |
| 4 | embedded fanless PC based VDU terminal as per RDSO spec. No. RDSO/SPN/192/2019 Ver. 2 or latest & No. - STS/E/TAN/3007 version 1 The size of VDU shall be 42 inch. Note: (i) Technical shall be mentioned in the document. (ii) One revolving chair supplied with control terminal. Consignee Inspection charges: Payment terms:100% after supply | Numbers | 2.00 | 4,93,241.48 | 9,86,482.96 |
| 5 | wiring, testing and of embedded fanless PC control terminal as per RDSO RDSO/SPN/192/2019 Ver. 2 or RDSO TAN No. - STS/E/TAN/3007 1 dated:02.11.12. Note: (i) requirements shall be mentioned tender document by tendering Inspection: Consignee Inspection None Payment terms:100% after | Numbers | 2.00 | 1,23,310.37 | 2,46,620.74 |
| 6 | embedded fanless PC based terminal as per RDSO spec. RDSO/SPN/192/2019 Ver. 2 or latest & No. - STS/E/TAN/3007 version 1 The size of VDU shall be 42 inch. Note: (i) Technical shall be mentioned in the document by tendering authority. table of suitable size along with chair should be supplied with terminal. Inspection: Inspection charges: None terms:100% after supply | Numbers | 1.00 | 4,64,279.54 | 4,64,279.54 |
| 7 | wiring, testing and of embedded fanless PC Maintenance terminal as per RDSO RDSO/SPN/192/2019 Ver. 2 or RDSO TAN No. - STS/E/TAN/3007 1 dated:02.11.12. Note: (i) requirements shall be mentioned tender document. Inspection: Inspection charges: None terms:100% after commissioning. | Numbers | 1.00 | 1,16,069.88 | 1,16,069.88 |
| 8 | of SWR literature in English with associated mid-section gate with all corrections as per SWRD & approved SIP. For these corrections, editing, correction etc. are to be and one rough print to be given for approval before printing, as for final processing of CRS This also includes preparation of cards in format provided by Inspection: Consignee Inspection None Payment terms:100% after | Station | 1.00 | 4,330.94 | 4,330.94 |
| 9 | of Station Working Rules from Hindi and framing out in DIGLOT similar software) as per extant Rly The required SWR in English will by the contractor and has covered separately in item no. of Chapter 1 of SOR. Inspection: Inspection charges: None terms:100% after execution. | Station | 1.00 | 5,389.49 | 5,389.49 |
| 10 | photocopies & binding of the SWR in English/Hindi/Diglot form as practice. Inspection: Consignee charges: None Payment after execution. | Set | 6.00 | 214.85 | 1,289.1 |
| 11 | and Plotting of Signalling Plan (SIP) in AUTOCAD. Two prints with soft copy will be to Railway for checking. If are suggested/proposed by then again two copies of prints submitted for advance approval carrying out all the alterations as by the Railways. will be submitted for all the mentioned above for the purpose by Railway prior to of station. Inspection: Inspection charges: None terms:100% after execution. | Per SIP | 1.00 | 33,772.62 | 33,772.62 |
| 12 | circuits in connection with of wiring diagrams as per Signalling Plan and submission of well as outdoor completion It includes Route Section Plan Selection Table (ST), Locking Table Control Panel Diagram (CPD)/VDU Two copies of prints with soft be submitted to Railway for If alterations are by Railways then copies of prints will be submitted approval after carrying out all as suggested/proposed by Tracings will be submitted for diagrams mentioned above for the of approval by Railway prior to of station. All drawings will in CAD. The wiring diagrams relay rack analysis, relay analysis, fuse details. Tag block etc. A separate CD/Pen drive will to Railway for each station original tracings. It also includes and supply of laminated one completion plans including circuit and indoor as well as outdoor documents on standard 75- polyester film for station in Auto (Six) sets xerox copies will be for each of the documents below: Cable Route Plan, Cable Location details plan for all the Cable termination details, Plan, SWR Diagram, Wiring Selection Table, Locking Table, Analysis, Fuse and Tag Block of Relay Rack and CT Rack, Indication Panel/VDU diagram, Diagram, Track Circuit Plan, Plan and Junction Box details Total cost of design and documents for a station/yard calculated on basis of total possible as per Selection Table Inspection: Consignee Inspection None Payment terms:100% after | Per Route | 40.00 | 4,999.24 | 1,99,969.6 |
| 13 | in existing relay room includes supply of PVC insulated Railway signalling cable @40<45@Core/40-Core) of (1/0.6) sqmm RDSO Spee. No. IRS/S-76/89 or latest) for wiring between relay SM's/Panel room & Relay room to office for block working. This also supply of PVC insulated jumper multi strand 16/.2 mm, tinned in all as per RDSO Specn.No.IRS-S- or latest). This item will bringing all the power supplies room to respective bus bars on by using 10/6 sqmm copper as per instructions of engineer This will include wiring between panel and relay room if required. All be done as per standard of North Western Railway with dressing & threading. The item supply & wiring of tag block, fuse (G-Type and ND Type) and all related material required for indoor wiring in relay ConsigneeInspection NonePayment terms:100% after | Per Relay | 50.00 | 630.75 | 31,537.5 |
| Installation of Modular power arrangement for VDU and industrial PC) with input and output arrangement and Hot Modules as per RDSO Make Gallant or similar. One of 1. Input O- ring diode with potential free -1 No contacts two 110 V DC sources from IPS 110 VDC bus Qty 1 No. 2. Inverters (Master / slave) - Input- Output: 120 V AC/220V A500VA - 3. Isolated DC-DC convertors- v DC Output: 24 V DC/ 10A, Qty 3 U SS rack with back panel board /front panel power inverter auto change over all required over switch and all protection circuits (3U height for 132.5mm +/-10% & 1U height 44.5mm +/- 10%) Qty - 1 No. or similar. (This item is for VDUs of EI system) Inspecting (i)for inverters and converters : for other items : Consignee Charges: (i) Borne by Railways | — | — | — | — | |
| 14 | of Modular power supply Payment Terms: 100% after | Set | 2.00 | 2,18,289.6 | 4,36,579.2 |
| 15 | of Modular power supply Payment Terms: 100% after | Set | 2.00 | 54,572.4 | 1,09,144.8 |
| Schedule total | ₹56,18,347.54 | ||||
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
RMNtenderdocument.pdf
ATTACHMENT
JPOforprot.ofSntcables.pdf
ATTACHMENT
ESPofRMN.pdf
ATTACHMENT
GCCApril-2022AdvanceCorrectionSlipNo_4ACS-4_1.pdf
ATTACHMENT
Correctedcompendiumofinstructiononsafetyatworkssite31.3.14_1.pdf
ATTACHMENT
GCCACS3.pdf
ATTACHMENT
GCC2022AdvanceCorrectionSlipNo_6ACS-6.pdf
ATTACHMENT
acs5dt20-10-2023GCC.pdf
ATTACHMENT
GCCACS114.07.2022.pdf
ATTACHMENT
GCCACS213.12.2022.pdf
ATTACHMENT
GCCACS11.pdf
ATTACHMENT
GeneralconditionGSU17.04.20261.pdf.pdf
ATTACHMENT
GCCApril-2022AdvanceCorrectionSlipNo_7ACS-7.pdf
ATTACHMENT
GCC-2022-UPTOACS09.pdf
ATTACHMENT
GCCACS10.pdf
ATTACHMENT
GCCACS81.pdf
ATTACHMENT
GCCACS9.pdf
ATTACHMENT
GCCCorrectionSlipsuptoACS11_1.pdf
ATTACHMENT
topsheetRMN.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .