NOTICE NO 861 LOT NO 04

Cleaning / Dewatring of pond

Excavation in foundation in ordinary soil (loam clay or sand) including lift up to 1.50 m and lead up to 30 m including filling watering and ramming of excavated earth into the trenches or into the space between the building and the side of foundation.

Construction of Embankment with approved material obtained from borrow pits with all lifts upto 1.50 m tramsporting to site, spreading, grading to required stope and compacted to meet requirement with lead upto 2 Km S.I. No. 253

Concrent with four cm(1.5”) gauge brick ballast, C/sand and cement in proportion of 8:4:1 in foundation and under floor including S/O all material labour T&P etc required for proper completion of the work. (S.I. 275)

Class 150 B/W in 1:3 cement & C/S mortar in F/P including S/O all material labour T&P etc required for proper completion of work

Supply and Laying of Rubber Moulded Reflective, Zig-Zag 80 mm thick precast compressed CC Inter locking block, compressive strength shall not be less than 30 MPA and Weight not less than 5.50 kg each block including cost of 50 mm thick bedding sand and joint filling with sand all material, labour T&P etc required for proper completion of the work over the prepared base concrete as directed by Engineer-in-charge

12 mm thick plaster with 1:4 cement and coarse sand morter in plinth both side of brick work inner side 15 cm below plinth and out side 15 cm below ground level including supply of all materials, labour and T&P etc. required for proper completion of the work

Distempering with OIL BOUND washable distemper of approved brand and manufacture give an even shade New work (Two or more coats) over and including a water tinnable priming coat with cement primer & applying white cement based putty D.S.R 13.80+13.60.1

Special Condition :- The Bitumen shall be issued by the department as VG-10 @ Rs 35200.00 Per MT & Emulsion SS-2 @ Rs 42500.00 & Road Roller @ Rs 2500.00 per day (For 6 Hr. Rolling) or The Divisional stock issue rate of Bitumen / Emulsion at the time of Issuance Whichever is higher.

Please Enable Macros to View BoQ information